Please explain part 1 (ii) of the question given. 1) i) A 6 inch diameter well that fully penetrates a 40ft thick open aquifer is pumped at a rate of 100 gpm. The drawdown in the well is 22ft when a steady water level is established. The drawdown in a well 152ft distant is 12ft. Estimate the coefficient of permeabiliity of the soil deposit. Answer of permeability is K= 9.88 x10-4 ft/sec. ii) Discuss the validity of the answer obtained in 1( i ) and suggest how would you improve the test data obtained to produce a better value of k. Why?

Please explain part 1 (ii) of the question given. 1) i) A 6 inch diameter well that fully penetrates a 40ft thick open aquifer is pumped at a rate of 100 gpm. The drawdown in the well is 22ft when a steady water level is established. The drawdown in a well 152ft distant is 12ft. Estimate the coefficient of permeabiliity of the soil deposit. Answer of permeability is K= 9.88 x10-4 ft/sec. ii) Discuss the validity of the answer obtained in 1( i ) and suggest how would you improve the test data obtained to produce a better value of k. Why?

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.23P

See similar textbooks

Similar questions

Question 3 a. An oil well in the Nameless Field is producing at a stabilized rate of 600 STB/day at a stabilized bottom-hole flowing pressure of 1800 psi. Analysis of the pressure buildup test data indicates that the pay zone is characterized by a permeability of 120 md and a uniform thickness of 25 ft. The well drains an area of approximately 40 acres. The following additional data is available: w = 0.25 ft, A = 40 acres Bo = 1. 25 bbl/STB, Ho = 2. 5 cp Calculate the pressure profile (distribution) and list the pressure drop across 1 ft intervals from rw to 1.25 ft, 4 to 5 ft, 19 to 20 ft, 99 to 100 ft, and 744 to 745 ft.
PROBLEM NO. 3 SOIL PERMEABILITY A pump test was conducted on a test well drilled into a confined aquifer, with the results showr ** elow. If water was pumped at a steady flow of 205 gal/min, deter... the coefficient of permeability (k in ft/sec) of the permeable soil in the aquifer. 150 ft 75 ft IMPERMEABLE LAYER 20 ft: 12 ft TEST WELL IMPERMEABLE LAYER AQUIFER 16 ft OBSERVATION WELLS Lectures 5
Question 2 * A well with a diameter of 0.6 m is constructed in a confined aquifer. The sand aquifer has a uniform thickness of 15 m, overlain by an impermeable layer with a depth of 35 m. A pumping test was conducted to determine the coefficient of permeability of the aquifer. The initial piezometric surface was 15 m. below the ground surface datum of the test well and observation wells. After water was pumped at a rated of 13 liters/sec for several days, water levels in the wells stabilized with the following drawdowns, 6.4 m in the test well, 3.7 m in the observation well 10 m from the test well, and 2.4 m in the second observation well at a distance of 30 m. From these data: o Find the depth of the water in the test well Calculate the permeability of the aquífer.
Question 2: * A soil sample 10 cm in diameter is placed In a tube 1 m long. A constant supply of water is allowed to flow into one end of the soil at A and the outflow at B is collected by a beaker. The average amount of water collected is 1 cubic centimeter every 10 seconds. The tube is inclined and has a head difference of 1.2 m. Determine the following o Hydraulic Gradient o Seepage velocity if porosity is 0.375 o Hydraulic conductivity Flow Rate Discharge Velocity
A 0.3 m well has a 25 m long screen that covers the entire depth of an aquifer. The aquifer medium has an effective grain size of 1.5 mm. The well is pumped at a rate of 0.2 m³/s. Assess the validity of Darcy's law near the well. Assume, porosity = 0.25 (Dynamic viscosity of water at 20°C is 1.005*10-3 Ns/m2)
Answer both 1 (i) and (ii) 1) i) A 6 inch diameter well that fully penetrates a 40ft thick open aquifer is pumped at a rate of 100 gpm. The drawdown in the well is 22ft when a steady water level is established. The drawdown in a well 152ft distant is 12ft. Estimate the coefficient of permeabiliity of the soil deposit. ii) Discuss the validity of the answer obtained in 1( i ) and suggest how would you improve the test data obtained to produce a better value of k. Why?
Refer to Figure 7.24. The following data were collected during the field permeability measurement of a confined aquifer using a pumping test. Determine the hydraulic conductivity of the permeable layer. Use Eq. (7.49). Thickness of the aquifer, H = 4.5 m Piezometric level and radial distance of the first observation well: h1 = 2.9 m; r1 = 17.8 m Piezometric level and radial distance of the second observation well: h2 = 1.8 m; r2 = 8.1 m Rate of discharge from pumping, q = 0.5 m3/min
2. A confined aquifer is recharged by a continuous supply of water from the certain source. The average thickness of the aquifer was determined to be 25 m and the average width is 4 km. The hydraulic conductivity of the aquifer was obtained at 40 m/day and its void ratio is 0.3333. The piezometer heads in two wells 1.325 km apart are 65 meters and 60 meters from a common reference datum. Determine the rate of flow in cubic meters per day. Determine: •compute the rate of flow through the aquifer in m3/day •compute the seepage velocity in m/day •compute the time of travel from the head of the aquifer to a point 8 km downstream in days
5.The diameter of a well is 300 mm and the depth of the aquifer is 20m. The radius of of circle of influence was found to be 135m. The coefficient of permeability of soil is 30 m/d. Calculate the drawdown of the well if the aquifer is a) confined, and b) unconfined. The yield required from the well in both the cases is 3000 cum/d.
Problems An aquifer of 20m average thickness is overlain by an impermeable layer of 30m thickness. A test well of 0.5m diameter and two observation wells at a distance of 10m and 60m from the test well are drilled through the aquifer. After pumping at a rate of 0.1 m³/s for a long time, the following draw downs are stabilized in these wells. First observation well, 4m, second observation well, 3m. Show the arrangement in a diagram. Determine the coefficient of Permeability and the drawdown in the test well.
3.1 Construct IPR of a vertical well in an oil reservoir. Consider (1) transient flow at 1 month, (2) steady-state flow, and (3) pseudo-steady-state flow. The following data are given: Porosity, o = 0.25 Effective horizontal permeability, k = 10 md Pay zone thickness, h = 50 ft Reservoir pressure, pe or p = 5,000 psia Bubble point pressure, p, = 100 psia Fluid formation volume factor, B, = 1.2 Fluid viscosity, M. = 1.5 cp Total compressibility, c, = 0.0000125 psi- Drainage area, A = 640 acres (re = 2,980 ft) Wellbore radius, rw Skin factor, S = 5 0.328 ft
For a falling-head permeability test, the following values are given: Length of specimen = 200 mm Area of soil specimen = 1000 mm^2 Area of standpipe = 40 mm^2 Head difference at time t = 0 = 500 mm Head difference at timt t = 3 minutes = 300 mm Determine the hydraulic conductivity of the soil in ×10−4cmsec Please answer this asap. For upvote. Thank you very much