estion 3L(t)00002H100sin(10t)V102.I 5sin(10t – 35°)VFor the above circuit, use the technique of phasor anlaysis to determine the current in the inductor i (t) at steady state (after a long time).Part I: First, determine and draw the circuit in the frequency domain. Be sure to label all componentsPart Il: Then solve for the current i (t) use any analsyis technique.You must show all your work. Take a picture/scan and upload BEFORE PROCEEDING TO THE NEXT QUESTION.Attach FileBrowse Local FilesBrowse Content CollectionA Moving to the next question prevents changes to this answer.

Answered: Image /qna-images/answer/1e13f6f6-75a7-4193-9762-35952301e20c.jpg

iL(t) 2H 100sin(10t)V 102 I 5sin(10t – 35°)V For the above circuit, use the technique of phasor anlaysis to determine the current in the inductor i (t) at steady state (after a long time Part I: First, determine and draw the circuit in the frequency domain. Be sure to label all components Part II: Then solve for the current iL(t) use any analsyis technique.

iL(t) 2H 100sin(10t)V 102 I 5sin(10t – 35°)V For the above circuit, use the technique of phasor anlaysis to determine the current in the inductor i (t) at steady state (after a long time Part I: First, determine and draw the circuit in the frequency domain. Be sure to label all components Part II: Then solve for the current iL(t) use any analsyis technique.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

6. a sinusoidal current is in phase with the voltage. It has an active power of 50VARS and reactive power of 10VARS. what is its apparent power? A. 71 VARS B. 41 VARS C. 51 VARS D. 61 VARS 7. An RLC series circuit has a resistance of 250ohms, 25microFarad capacitance and 57mH inductance. determine its impedance considering the circuit is at resonance condition. A. 150 ohm B. 230ohm C. 250 ohm D. 300 ohm
Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of 5kohms in series with a capacitor of 10 nanofarad is connected across a 16v sinusoidal supply. Calculate the output voltage at a frequency of 60Hz and again at frequency of 120Hz. This is the example/guide that might help.
: Answer All points: A d.c. circuit usually has .......... as the load Oresistance Oinductance Ocapacitance Oboth inductance and capacitance
Capacitance by AC- Bridge: The impedance of the capacitor of capacitance C is: Select one: a. Directly proportional to 1/C b. Directly proportional to 1/C2 C. Directly proportional to C2 d. Inversely proportional to 1/C
For a series RLC circuit with a sinusoidal input voltage, the amplitude of the current passing through the circuit (I, in mA) is plotted as a function of frequency for two cases: Curve 1 with R1, L1. and Curve 2 with R2. L2 as shown in the next figure. The value of the capacitor used in the circuits is C=0.01 micro Farads. If the value of R2 =1600 Ohm then the input voltage (in volts) is: 7.5 25 110 Frequency H2 O a. 4 O b. 16 sin(9888 t) O c. 8 O d. 8 cos(6.28 f t) O e. 8 sin (6.28 R t)
An applied voltage signal consists of a superposition of a dc voltage and an ac voltage of high frequency. The circuit consists of an inductor and a capacitor in series. Show that the dc signal will appear across C and the ac signal across L.
A 20ohms resistor is connected in series with an inductor, a capacitor and an ammeter across a 25V variable frequency supply. When the frequency is 400Hz the current is at the maximum value of 0.5A and the p.d. across the capacitor is 150V. Calculate the capacitance of the capacitor and the resistance and inductance of the inductor.
A series L-R-C circuit consisting of a voltage source, a capacitor of capacitance C, an inductor of inductance L, and a resistor of resistance R is driven with an AC voltage of amplitude Vin and frequency omega. Define Vout to be the amplitude of the voltage across the resistor and the inductor. Find the ratio Vin/Vout.
A circuit is designed with an AC source of max voltage 12 and frequency 60 Hz. The circuit has a resistance of 1050 Ohms, an inductance of 0.06 Henrys, and a capacitance of 0.009 coulombs per volt. - omega for source in rad/s? - omegaR for circuit? -XL? -XC? -phi in radians? -Z? -imax?
Date Pags 2) A sinusoidal alteznating voltage has value of 200V and 50 Hz It cEOSses an EoMo S. a fzequency of the zeso axi in a pasitive disection when t=0. Detezmine ņ the Aime when voltage fizst teaches the instan Zenemus value of 200 V and 2) the whe time when Valtage madei mum. after passing throag its positive ualu e eeashes the value Of 141.4V.
b) Two circuits connected in series which voltage drop across at each circuit can be expressed in time TTM domain as V1 (t) =5 sin (3147) V and V2 (1) =15 sin (314t - 30°) V. Sketch the waveforms of these voltages to illustrate peak values and phase relationships. UTM 5 UTM UTM TM S UTM UTM TM 5 UTM 8 UTM
Let Zeq be the equivalent impedance of a series connection of an inductor with inductance L and a capacitor with capacitance C. At w=1/√√LC, the equivalent impedance is given by _ O a. Zeq = 00 O b. Zeq = 0 O c. Zeq = 0.5 O d. Zeq = 1