Answered: frequency of the generator is 60.0 Hz.…

frequency of the generator is 60.0 Hz. Draw the vectors with their tails at the dot. If the rms voltage of the generator is 120 V, what is the average

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section: Chapter Questions

Problem 40A

See similar textbooks

Related questions

Q: Submit Answer Tries 0/6 (b) What is the rate of energy dissipation in the resistor? Submit Answer…

A: Applied force on rod F=1.30 N Speed of the rod v=2.30 m/sLength of rod=L Magnetic field=B

Q: A uniform 8.00 m, 1500 kg beat is hinged to a wall and supported by a thin cable attached 2.00 m…

Q: A small ball with mass 1.10 kg is mounted on one end of a rod 0.570 m long and of negligible mass.…

Q: (numbers 1-2) A 7 kg block and 3 kg block are connected by a negligible mass string as shown. The…

Q: 31. A small uniform cylinder of mass m is released from rest at a height of R/2 above the bottom of…

A: Radius of half pipe = RHeight of cylinder =R/2Cylinder rolls without slipping.

Q: The following gives the calorimetric values for water at various phases: Latent heat of…

Q: 4. Three copper frames are dragged through an external magnetic field in the direction s shown. The…

A: Lenz's law staes that the induced electromotive force with different polarities induces a current…

Q: X 9. An industrial laser is used to burn a hole through a piece of metal. The average intensity of…

Q: Current Attempt in Progress In the figure, two particles, each with mass m = 0.90 kg, are fastened…

Q: A 1.91 kg mass is initially at rest upon a frictionless, horizontal surface. An applied force of…

A: The mass of the object is 1.91 kg.The initial speed of the object is 0 m/s.The surface is…

Q: An object with a height of 2.36 cm is placed 35.4 mm to the left of a lens with a focal length of…

Q: a) Using mesh analysis, find lı and lz in the circuit of Figure1. 40 Ω j10Ω m 40/30° V I -j20 Ω…

Q: ray of light is incident at angle ?θ = 59° on the side of two stacked transparent blocks. The bottom…

Q: How did you get t2=h/343?

Q: (b) the second meter of the fall 0 initial kinetic energy How is the initial kinetic energy for the…

Q: An automobile crankshaft transfers energy from the engine to the axle at the rate of 96.7 kW when…

A: Here Power = 96.7 kW angular speed = 2940 rev/min We have to calculate the torque produced.

Q: One and of a uniform 3.30-m-long rod of weight is supported by a cable at an angle of 8-37 with the…

Q: A satellite makes 4 revolutions of the earth in one day. How many revolutions would it make in 6(…

A: Determine the number of revolutions the satellite makes in a day.The problem states that the…

Q: You have a light spring which obeys Hooke's law. This spring stretches 2.44 cm vertically when a…

A: mass m= 2.50 kgspring stretched dx=2.44cm= 2.44/100=0.0244mForce provided by gravity is balanced by…

Q: If an airplane propeller rotates at 2150 rev/min while the airplane flies at a speed of 305 km/h…

Q: Calculate the potential difference between points A and B in the circuit shown at right. A) 3.56 V…

Q: The coil in a loudspeaker has 40 turns and a radius of Part A

A: Number of turns, N = 40 Radius, r = 4.2 mMagnetic field, B = 0.36 TCurrent, I = 260 mA

Q: The index of refraction for violet light in silica flint glass is 1.66 and that for red light is…

A: Ray diagram through prism:

Q: What is the decibel level of a sound that has an intensity of 10.4 x 10-5 W/m2? Assume the…

A: The sound intensity is The reference sound intensity is Find:Sound level for given sound intensity.

Q: Problem D: The populations of termites and spiders in a certain house are growing exponentially. The…

A: The exponential growth formula for a population is given by:P(t)=P0 * ekt ,where:P(t) is the…

Q: (a) A coil of conducting wire carries a current of i(t) = 16.0 sin(1.20 x 10³t), where i is in…

Q: A transverse wave travels across a string having a linear mass density 0.065 kg/m. The wavelength of…

Q: A coin is at the bottom of a beaker filled with an unknown liquid which has an index of refraction…

Q: n struggles to read by holding a book at arm's length, a of 53 cm away. Part A What power of reading…

Q: 3. A car travels with constant acceleration along the x-axis. It initially moves at 12 m/s in the +x…

A: A car travels with constant acceleration along the x-axis.It initially moves at vi=12 m/s in the +x…

Q: A heavy metal tray with mass 25.0 kg tray lies on a table. On top of the tray is another stone with…

Q: The simplest nucleus, that of hydrogen, is a single proton. Next comes the nucleus of H, the isotope…

A: To calculate the binding energy of the deuteron, we can use the formula for the binding energy (BE)…

Q: How does a white dwarf differ from a neutron star? (Select all that apply.) A white dwarf is less…

Q: ectangular loop of 250 turns is 35 cm wide and 19 cm high. Part A What is the current in this loop…

A: Number of turns, N = 250 Width of rectangular loop, w = 35 cm Height of rectangular loop, h = 19…

Q: The body in the figure is pivoted at O, and two forces act on it as shown. If r₁ = 1.28 m, r₂ = 2.07…

Q: 6.15 Calculate the electron heat capacity at 1000 K in Na, Al and Cu metals using the following…

Q: The Sun has diameter 1.4 x 106 km, and it is 1.5 x 108 km away. ▼ Part A How large is the image of…

A: Sun diameter = 1.4×106 km Distance of sun = 1.5×108 km

Q: . Assume that a camera has a bi-convex lens. Should you move the lens toward or away from the…

Q: 34 Application of torque (a) Four forces are acting on an object that is free to rotate. The…

A: Here,

Q: Exercise No 17: A block of mass m = 1.5 kg is attached to the end of a vertical spring of force…

A: This question is based on simple harmonic motion.

Q: A laser emits a narrow beam of light. The radius of the beam is 9.3 mm, and the power is 4.1 mW.…

A: The radius of the beam isr=9.3 mm=0.0093 mThe power isP= 4.1 mW = 0.0041 W

Q: A 4900-pF capacitor is charged to 120 V and then quickly connected to an inductor with 83-mH…

Q: A box of mass 4.8 kg slides on a horizontal frictionless table and collides with another box of mass…

A: Given data:mass of box 1, m1 = 4.8 kgmass of box 2 = 3 kgInitial veloctiy of box 1 = 4 ms-1Initial…

Q: PROBLEM 4: A small bead of mass m is constrained to slide without friction inside a circular hoop of…

Q: numbers 32-33) An object is placed 24 cm from a converging lens with a focal length of 8 cm. 32.…

A: Object distance is 24 cm from lens u = - 24 cmFocal length (f) = + 8 cm

Q: |Problem 1: An inductor with L= 4.5 H is in a closed circuit with I = 0.35 A (see the diagram). When…

A: Given:The inductance: L = 4.5 H;The current flowing in the circuit initially: Ii = 0.35 A;The…

Q: heavy metal tray with mass 25.0 kg tray lies on a table. On top of the tray is another stone with…

Q: cannonball is fired from the ground with an upward initial velocity of 30 m/s. If the cannonball…

Q: 3) A truck is moving down a 10° incline. The driver strongly applies the brakes to avoid a collision…

Q: A record turntable is rotating at 33- rev/min. A watermelon seed is on the turntable 7.8 cm from the…

A: Here is the explanation

Question

Sketch the phasor diagram for an ac circuit with a 105Ω resistor in series with a 92.5-mH inductor and a 32.2 μF capacitor. The frequency of the generator is 60.0 Hz. Draw the vectors with their tails at the dot. If the rms voltage of the generator is 120 V, what is the average power consumed by the circuit?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the given variables:

VIEW

Step 2: Calculate the average power consumed by the circuit

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The emf of an ac source is given by v(t)=V0sint, where V0=100V and =200 . Find an expression that represents the output current of the source if it is connected across (a) a 20-pF capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
A resistor and inductor are connected in series across an ac generator. The emf of the generator is given by v(t)=V0cost , where V0=120V and =120rad/s ; also, R=400 and L = 1.5 H. (a) What Is the impedance of the circuit? (b) What is the amplitude of the current through the resistor? (C) Write an expression for the current through the resistor. (d) Write expressions representing the voltages across the resistor and across the inductor.
An AC generator with an rms emf of 15.0 V is connected in series with a 0.54-H inductor. The frequency of the source emf is 70.0 Hz. Draw a phasor diagram for this circuit, including the current, the potential difference across the inductor, and the source emf. Draw your diagram with the current phasor pointing toward the right along the horizontal axis.
An ac source of voltage amplitude 100 V and frequency 1.0 kHz drives an PLC series circuit with R=20, L = 4.0 mH, and C=50F . (a) Determine the rms current through the circuit, (b) What are the rms voltages across the three elements? (c) What is the phase angle between the emf and the current? (d) What is the power output of the source? (e) What is the power dissipated in the resistor?
An ac source of emf delivers 5.0 mW of power at an rms current of 2.0 mA when it is connected to the primary cod of a transformer. The rms voltage across the secondary coil is 20 V. (a) What are die voltage across the primary coil and the current through the secondary coil? (b) What is the ratio of secondary to primary turns for the transformer?
A resistor and capacitor are connected in series across an ac generator. The emf of the generator is given by V(t)=V0cost , where V0=120V , =120rad/s , R=400and C=400F.(a)What is the impedance of the circuit? (b) What is the amplitude of the current through the resistor? (C) Write an expression for the current through the resistor. (d) Write expressions representing the voltages across the resistor and across the capacitor.
The emf of an ac source is given by v(t)=v0sint. where V0=100V and at =200rad/s . Calculate the average power output of the source if it is connected across (a) a 20F capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
In a series RLC circuit with a maximum current of 0.250 A, an AC source with Vmax= 115 V operating at 60.0 Hz is connected to a 325-mH inductor, a 7.50-F capacitor, and a resistor with unknown resistance R. Draw a phasor diagram for this circuit, including the current, the potential difference across each of the circuit elements, and the source emf. Draw your diagram with the current phasor pointing upward along the vertical axis.
In the AC circuit shown in Figure P32.3, R = 70.0 and the output voltage of the AC source is Vmax sin t. (a) If VR = 0.250 Vmax for the first time at t = 0.0100 s, what is the angular frequency of the source? (b) What is the next value of t for which VR = 0.250 Vmax? Figure P32.6 Problem 3 and 5.
A step-down transformer has 65 turns in its primary coil and 10 turns in its secondary coil. The primary coil is connected to standard household voltage (Erms= 120.0 V, 60.0 Hz), a. What is the rms voltage in the secondary coil? b. If, instead, the transformer is connected to a 6-V DC battery, what is the rms voltage in the secondary coil after the first few milliseconds?
A 40-mH inductor is connected to a 60-Hz AC source whose voltage amplitude is 50 V. If an AC voltmeter is placed across the inductor, what does it read?
A 200- resistor, 150- F capacitor, and 23-H inductor are connected in series with an ac source of amplitude 10 V and variable angular frequency . (a) What is the value of the resonance frequency R? (b) What is the amplitude of the current if =R ? (c) What is the phase constant of the current when =R ? Is it leading or lagging the source voltage, or is It In phase? (d) Write an equation for the voltage drop across the resistor as a function of time when =R . (e) What is the power factor of the circuit when =R ? (f) How much energy is used up by the resistor in 2.5s when =R ?