Find the voltage across the capacitors in the given circuit under dc conditions,where R₁ = 66 and R₂ = 19 0.R₁wwwC₁+511092wwwww50 92wwwR₂60 V3-4C₂The voltage across the capacitors are v₁ =15 +HHV and v2=V.

The voltage across the capacitor under DC conditions needs to be calculated for the given values of…

Answered: Find the voltage across the capacitors…

Engineering

Electrical Engineering

Find the voltage across the capacitors in the given circuit under dc conditions, where R₁ = 66 Q and R₂ = 19 Q.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: #1. In the circuit shown in Fig. 1, the current source l(t)= 15 sin(377t + 40°) A. Determine the…

A: In this question, We need to determine the voltage across the resistance 20ohm. We are solving this…

Q: 3. 8.5.7 7.07 Find the equivalent impedance for the circuit given. 1002 www 200 80 -180 m j5 Ո -7202…

Q: In the circuit shown below, the current through the inductor is 1Ω 1/0° V -j1 Ω + 1/0° Α 1/0° Α 1 Ω…

Q: Use the principle of superposition to find the voltage Vb and current i in the circuit shown below…

Q: Two BJT transistors Q1 and Q2 are identical. MOSFET parameters are: V₁-1V, K-3 25mA/V², λ=1/100…

Q: A plane wave of frequency 1 GHz is travelling through a block of Teflon having & = 2.1, µr = 1 and o…

A: Note: Since you have posted a question with multiple sub-parts, we will provide the solution only to…

Q: 7- Select the correct answer; the transformer function in the circuit below is. A. Insulating…

Q: MAKE ONE ORIGINAL WORDED PROBLEM WITH DIAGRAM AND ITS FREE BODY DIAGRAM FOR CAPACITANCE IN SERIES…

A: It is given that: MAKE ONE ORIGINAL WORDED PROBLEM WITH DIAGRAM AND ITS FREE BODY DIAGRAM FOR…

Q: For the RLC circuit shown in the image below, assume the circuit has long reached a steady state,…

A: Given, Circuit is The circuit has long reached a steady state, and then the switch closes at t =…

Q: H.W: Develop a program that will cause output D to go true when switch A and switch B are closed or…

Q: A 32 km, 50 Hz, three phase line delivers 2.4 MW at 0.8 pf lagging at 64 kV to a balanced load. The…

Q: For the unity feedback system shown in figure 1, R(s) + K(s+10)(s+20) (s+30)(s²-20s+200) Figure 1 a.…

A: In this question we need to draw the root locus and find the range of gain K that makes the system…

Q: In the circuit in (Figure 1), take R = 45 kn. Figure 2.5 mA 8 kn { R + V- 80 ΚΩΣ m 15 ΚΩ k 40 V 5 kΩ…

Q: 5. Find Cm for a piece of wire has a diameter of .064 of an inch. 6. Find CM for a Wire has 24…

Q: Point charges Q₁ and Q₂ are, respectively, located at (4, 0, -3) and (2, 0, 1). If Q₂ = 4 nC, find…

Q: : Consider the following non-unity feedback control system. K is a gain parameter 0<K<∞). For the…

A: The question is based on time response analysis in control system and Routh Hurwitz stability. As…

Q: B: Mention four factors (physical state& conditions) that the phenomenon of corona is affected by…

A: We need to mention the four factors (physical state& condition) that the phenomenon of corona is…

Q: Consider a cross-section of a single-conductor cable as shown in Figure. The conductor occupies the…

Q: H.W: Write the ladder logic program needed to implement each of the following (assume inputs A, B,…

Q: Use source transformations to find i0 in the circuit shown below. 10 ΚΩ ww 3 ΚΩ m 5 ΚΩ )50v {15kΩ…

Q: 3) Use the loop current method to determine the power dissipated in the 2 ohm resistor in the…

A: Given: A network, To find: Power dissipated in 2Ω resistor using loop current method.

Q: 10. Show that, the magnetic field due to a straight current carrying filamentary conductor of…

A: The Biot Savart law is analogous to Coulomb's law. According to Biot Savart Law, the magnetic field…

Q: Q.1 Under steady state de conditions, find it. ve and the energy stored in the inductor and…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: The solution are attached. Can you please explain if the circuit is a natural or step responce. I;m…

A: In this question,we have to check the Circuit as natural response or step response.

Q: for D the answer 16 or 20?

A: The above question is related to transformer winding.

Q: 3.40 For the bridge network in Fig. 3.86, find i, using Homesh analysis. ML 56 V(+ Figure 3.86 For…

Q: Find the interval of convergence for the series (3x+1)+1 2n+2

Q: Problem 6 In Lec. 7, we calculate the Ohmic power dissipation of P=11² R. by using the Ay known…

A: Let's start with the expression for Poynting vector, which represents the power per unit area…

Q: The fault shown can be best characterized as which of the following: (A) Three Phase (B) Line to…

A: This analysis can be done to determine the short circuit current. Analysis of fault is important to…

Q: Voltage across 2

Q: Sketch a plot of power vs frequency for mechanical oscillator? What is the expression for maximum…

Q: 10. A unit is to have a current draw of 24 amps and located 100 feet from the circuit-breaker. Using…

Q: #2. A 3-phase power system is shown in Fig.2, the delta-connected load is supplied throug…

Q: II. Use a table of Laplace transforms to find each of the following. 1. f(t) = 4t 2. f(t) = t2 3.…

A: Since you have posted the questions with multiple subpart and so we are supposed to answer 3…

Q: a b Calculate the resonant frequency in both radi- ans/sec and hertz, Q, and the bandwidth for a…

Q: B: Relay is consist two circuits, what they are? And determine whether the next relay is normally…

A: The given relay diagram is shown below,

Q: Is t=0 if

Q: In a certain region, the electric field is given by D = 2p(z + 1)cosa, - p(z + 1)sin a + p² cos o a₂…

A: The equation for the electric field is given by,D=2ρz+1cos ϕ aρ-ρz+1sin ϕ aϕ+ρ2 cos ϕaz μC/m2.

Q: Consider the circuit shown in the figure. A Q-point value for IC between a minimum of 4 mA and a…

A: Given data IC=4 mA to 5 mA β=115 to 250 VBEQ=0.7 V Vsupply=5 V VCC=15 V To find out We have to…

Q: What is the RMS value of the voltage v(t) = 2 cos(3nt +)? 1.41 V 2.82 V None of the choices provided…

A: The voltage signal is, vt=2cos3πt+π2.

Q: 60W-100V tungsten lamp has a resistance of 20 ohm at air temperature (0◦C). What is the rise in…

Q: A 1.8⁰ step, 4-phase stepper motor has a total of 40 teeth on rotor. The number of stator teeth for…

A: A stepper motor- 4 Phase , m =4. Step angle, β=1.8° Total number of teeth on rotor N= 40 To find-…

Q: 8. Test Whether the signal y(t) = ax(t) + b is linear or non linear.

A: Given: A system defined as, y(t)=ax(t)+b, To find: whether the system is linear or non linear?

Q: Explain the term “four-quadrant operation” in the context of power electronic converters. Explain…

A: It is asked to explain the term “four-quadrant operation” in the context of power electronic…

Q: (b) A single-phase ideal transformer with 2 kVA rating has 480 V at the primary, and 120 V at the…

Q: SERIES AND PARALLEL AC CIRCUIT DETERMINE THE TOTAL IMPEDANCE, TOTAL CURRENT, AND POWER FACTOR OF THE…

Q: Calculate the mutual impedance, secondary current and the thermal power of the load in the…

A: In this question, We need to determine the mutual inductance M, secondary current I1 and thermal…

Q: PROBLEM-4 transient analysis of this system; R(s) a. b. G₁ ): Consider the following unity feedback…

Q: Calculate the magnitude of transfer function K(s),show how you get the value s+ 8.52 s²+(377)² K(s)…

A: Given transfer function is K(s)=hs+8.52s2+(377)2s+966s+5633; We need to determine the magnitude of…

Q: circuit. A coil of wire, with a low-frequency time-harmonic current i(t) = lo coswt, is wound…

A: current passing through the coil is i(t) = Iocosωt B(t) - magnetic flux density H(t) - magnetic…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Find the voltage across the capacitors in the given circuit under dc conditions,
where R₁ = 66 and R₂ = 19 0.
R₁
www
C₁
+51
1092
www
ww
50 92
www
R₂
60 V
3-4
C₂
The voltage across the capacitors are v₁ =
15 +
HH
V and v2=
V.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Requirement

VIEW

Step 2: Nodal Analysis

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
List the five capacitor replacement rules.
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
In the circuit below, Find the voltage across the inductor at time t = 0.000909 s. The values are V1 = 146V, R = 4.4 ohms, L =0.02 henries
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
(VD₂ = Determine the voltage across each capacitor in the circuit figure below. 0.68 V, VD₂ 0.56 V) = 240 V rms 50 Hz 1:1 ooooo elele C₁ H 1μF D₁ HE D₂ .C₂ 1 μF