A company spilled a contaminant that got intothe water distribution system of a small town,which has an average flow of 100,000 gpd. Thecontaminant infiltrated a pipe 1,500 ft from thestorage tank, and the concentration at theinfiltration point is 5 mg/L. The storage tank hasa volume of 125,000 gallons and the first user is500 ft from the storage tank. Assume velocity of2.5 ft/s in pipes, and a rate constant of 3/day.What is the concentration at the first user?

velocity in pipes =v =2.5 ft/sdistance of first point = 1500 ft-500 ft =1000 ftso that time taken…

Answered: erage flow of 100,000 Itrated a pipe…

Engineering

Civil Engineering

erage flow of 100,000 Itrated a pipe 1,500 ft d the concentration at is 5 mg/L. The storage

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A groundwater supply has been designated as vulnerable to fecal contamination, and the state has specified a disinfection level of 99.99% (4.0-log) virus inactivation. The peak hourly pumping rate is 2000 gpm from the well field through a 4200-ft pipe with a 16-in diameter to a reservoir in the town. The water temperature is 10°C. A. what is the contact time in the pipeline? B. What chlorine residual is required in the water at the outlet of the pipeline? F3 F4 F5 F6 F7 F8 F9 F10 F11 F12 %23 & 3 4 7 8 T Y D F G K CO LLI
Q.` The wastewater having an organic concentration of 54 mg//is flowing at a steady rate of 0.8m³ /day through a detention tank of dimensions 2mx4mx 2m. If the contents of the tank are well mixed and the decay constant is 0.1 per day, the outlet concentration (in mg//, up to one decimal place) is
The below figure shows a pump that transfers a steady stream of 35 API crude oil from an oil tanker to a refinery storage tank, both free surfaces being open to the atmosphere. The effective length-including fittings-of the commercial steel pipe is 6,000 ft. The discharge at point 4 is 200 ft above the pump exit, which is level with the free surface of oil in the tanker. However, because of an intervening hill, point 3 is at a higher altitude than point 4. Losses between points 1 and 2 may be ignored. The crude oil has the following properties: Density p= 53 lbm/ft; Viscosity u= 13.2 cP3; Vapour Pressure Pv = 4.0 psia 1,000 ft 5,000 ft Storage tank 200 ft Oil tanker W hp
The concentration of suspended solids in the flow is 2500 g/m3. Knowing that (SS) come into the clarifier each day is (31275 Lbs/day). Determine The flow to a clarifier in MGD ? Select one: O a. 1.5 O b. 1.2 O c. None O d. 1.3
A new water treatment plant is going to be constructed in Jacksonville to replacethe existing plant. The average annual water temperature is 19 oC. The following designassumptions for a flocculation tank have been made:Number of tanks = 1Detention time = 40 minVelocity gradient = 25 s−1Impeller type: radial, 3 flat blades, Np = 0.33Impeller diameter = 1.1 mRotational speed = 30 rpmWhat is the design flow rate in m3/d?
Example 5.21 Design the absorption field system for the disposal of septic tank effluent for a population of 100 persons with sewage flow rate of 135 /pcd. The percolation rate for the percolation test carried out at the site of the absorption field may be taken as 3 minutes. MADRIDRODRIA ninicontactinooo....
a. The wastewater from a manufacturing treatment plant is discharged to a municipal `treatment plant for processing with domestic wastewater. The characteristics of the wastewater from the manufacturing treatment plant are 3500 mg/l BOD, 4500 mg/l SS, 70 mg/l nitrogen and 2 mg/l phosphorous. The characteristics of the domestic wastewater are 350 mg/l BOD, 285 mg/l SS, 50 mg/l N and 11 mg/l P. If the required BOD/N/P weight ratio is 100/5/1, what is the minimum quantity of domestic wastewater required per 1000 gallons of manufacturing wastewater to provide adequate nutrients for biological treatment and the concentration of SS in the combined wastewater? b. What additional of NH4OH and H3PO4 would be required in pounds per million gallons of wastewater to provide the necessary nutrient levels for the treatment of the manufacturing wastewater described above (a) if the domestic wastewater had not been combined with it.
In a raw water treatment plant, 34560 m³/day of raw water having density of 1000 kg/m³ and kinematic viscosity of 10-6 m²/sec is required to be processed. The rapid mixing tank imparts a velocity gradient of 830 s-1 to blend 38 mg/lt of alum with the flow for a detention period of 2 minutes. The mechanical horse power input required for rapid mixing is HP. (Rounded off to two decimal places)
na wastewater treatment plant, 35 mg/L of ammonia was nitrified to oxidized nitrogen in the bioreactor. The inflow is 2 ML/d. What is the minimum rate the A recycle must run at to achieve an effluent oxidized nitrogen of 2.5 mg/L? The RAS is run at a ratio of 1:1 sewage to RAS return. I need to know how to work out the answer please
e sp .gr.= 0.90, is flowing a) what is the discharge in gallons per minuk (gpn)! b.) what is the dischage in mega gallons per day (mgd)! 1-A liquid, sp.gr.= 0.90, is flowing in a 200-mn diareler PIpe at 12m/s.
Please upload your full solution to the following problem. Raw water from Lake Limpid is treated via direct filtration and disinfection to supply 0.26 m³/s (5 MGD) to the town of Phresherville. Disinfection is performed in a 600-m³ contact basin with superior baffling. Water exiting the contact basin has a free chlorine residual of 2.0 mg/L. Is the Phresherville water treatment process in compliance with the Surface Water Treatment Rule?
Q6The large tank holds 300 gallons of brine solution. Salt was entering and leaving the tank; a brine solution was being pumpedinto the tank at the rate of 3 gal/min; it mixed with the solution there, and then the mixture was pumped out at the rate of 3gal/min. The concentration of the salt in the inflow, or solution entering, was 2 lb/gal, so salt was entering the tank at therate Rin 5 (2 lb/gal) . (3 gal/min) = 6 lb/min and leaving the tank at the rate Rout 5 (A/300 lb/gal) . (3 gal/min) 5 A/100 lb/min.According to this information, if 50 pounds of salt were dissolved initially in the 300 gallons, how much salt is in the tankafter a long time?