D₁ + V Μ 5 ΚΩ 10 ΚΩ (2) >> +15 V 10 ΚΩ 5 ΚΩ K0197 +3Vo D₂ + V (b) 1 ΚΩ D₁ V + 1 ΚΩ V www 2.2 ΚΩ αν 1.5 ΚΩ -15 V (c) +15 V

Q: Q5: For the following counting sequence, design the counter using D flip-flops. Desired sequence 0,…

A: The counter with counting sequence 0,2,3,1,0 needs to be designed by using the D Flipflop. The…

Q: A causal signal is given as x[n]= (0.5)". Find the discrete time Fourier transform (DTFT) of signal…

A: The above question is based on the properties of DTFT. Here note that since it is mentioned that…

Q: Briefly explain about parameters and samples

A:

Q: An oscilloscope shows peak-to-peak amplitude of 8 cm for a measured sinusoidal voltage waveform with…

A: In the given questions we need to calculate the average value of the given signal.

Q: µ=0.5, G1=3.5 Write the nodal voltage analysis matrix for this circuit.

A: The nodal voltage analysis Matrix needs to be obtained for the given circuit

Q: Node 1 www R1 Es (ins R₂ B www Node 2 www R3 W RA C www Rs Node 3 www R6 www R7. E6 E Figure 3:…

A:

Q: Determine the current through the 4 kn capacitive reactance of the circuit below. E₁ R₁ = 100 V 0° 2…

A: Circuit diagram is given as,

Q: Find the closed loop transfer function for the following block diagram by using block diagram…

A: it is asked to find the closed loop transfer function by block diagram reduction techniques

Q: Q1. a) Derive (show proof) the relationship between 'a' & 'B' of the transistor. b) In a transistor…

A: given that  α - commom base current gain = 0.997β - common emitter current gain γ - common collector…

Q: The neutral point of 25 MVA, 11 kV alternator is grounded through a resistance of 5 2, the relay is…

A: It is given operating current of relay is 2 A. Grounded through a resistance of 5 ohm. CT ratio is,…

Q: iiFor the Circuit Below: V₁ 13 = 3Ω ΖΩ γγγγγ E₁ 4Ω I I V₂ 3Ω ΤΩ ΤΩ Μ ΖΩ > 3Ω 4Ω V3 son IF…

A: In this question We need to determine the loop currents as shown the circuit.  We are solving this…

Q: PLEASE SHOW FULL WORK WITH EXPLANATION,

A:

Q: 1. (a) A sinusoidal voltage with Veff = 10V is connected across Z₁ = 1 + j as shown in figure(a)…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: VI qurk Бокна o + NV ..B..!. M 4K2 V2 +) бирк зокне R2 to s kn V3 + 12VPK 25 KHz 21 Im H 44 Find UR₁…

A:

Q: 1. A single phase, 60Hz, 200-km medium nominal-T transmission line receives 10 MW at 0.95 lagging pf…

A:

Q: 3. A 120 KVA transformer has a maximum efficiency of 98% and this condition occurs at 10% under…

A: transformer rating 120 KVA maximum efficiency  ηmax = 98% under load of 10% that is 90% load (x =…

Q: Problem 3: Find the Thevenin and Norton equivalent circuits of Circuit 3 below with respect to…

A:

Q: Question 2. Equivalent circuit parameters of a three-phase, 2P=6-pole 50 Hz, 2400 V, 950 rpm stator…

A: Pole, P=6 frequency, f=50 Hz Rotor speed= Nr=950 rpm Supply line voltage, Vl=2400 V   Synchronous…

Q: 1- Given the following two-degrees of freedom translational mechanical system, use the "by…

A: For the given mechanical translational system, the transfer function G(s) = X1(s)F(s) needs to be…

Q: Q13. Convolute the following: x(t) = u(t)- u(t-5), h(t) = u(t)-u(t-2).

A: X(t)=u(t)-u(t-5) h(t)=u(t)-u(t-2) We need to calculate output signal using convolution.( Graphical…

Q: Given the system, write the output, c(t), in general terms. Specify the forced and natural parts of…

A: The given block diagram is shown below. The input is unit step signal and in s-domain it is given…

Q: C(s) 9 2 +9. s(s + j3)(s − j3) = (-) (₁²49)

A: Cs = 1s9s2+9

Q: The device shown in Figure 1 can be modeled as an independent voltage source in series with a…

A: Given Data: A voltage-current relationship waveform of a device as, vQ, iQ=-4,4m , 8,2.5m To Find:…

Q: Question 2. A three-phase, delta-connected, 2-pole 1000 V, 50Hz asynchronous motor rotates at 2920…

A: The given circuit diagram is shown below, Here,Pole, P=2.Voltage, V=1000 V.Frequency, f=50 Hz.Speed…

Q: Calculate the current flowing through each of the resistors A and B in the circuit shown in the…

A: Circuit diagram is given as,

Q: Suppose a circuit has a resistor, inductor and voltage source connected in series. The resistance is…

A: it is asked to find the current in given circuit

Q: EX loss less T. L having Zo=your working at A=3 m By using Crank digram, drow the standing wave at…

A: According to the question, a lossless TL having Z0 =400 Ω, working at λ=3 m. By using Crank diagram,…

Q: Question 2. The parameters of a three-phase transmission line are given as Z = (12.84+ j72.76) and y…

A:

Q: In the circuit of Fig. 11.26, Z₁ = 60/-30° and Z₂ = 40/45° 0. Z, Calculate the total: (a) apparent…

A: It is given that: Z1=60∠30° ΩZ2=40∠45° Ω

Q: Hz A function is given by f(t) = sin²t+ cos2t. Which of the following is true ? (A) f has frequency…

A: here we have to find the frequency components present in the signal

Q: An uncharged capacitor and bulb are connected in series with a battery. Describe and explain what…

A: An uncharged capacitor and bulb are connected in series with a battery as shown below,

Q: B-8-9. The pole-zero configurations of complex functions Fi(s) and F₂(s) are shown in Figures…

A: Given Data: The closed contours and pole-zero configuration in the s-plane for the two systems F1s…

Q: Do the operations by taking two digits in the part of the decimal number after the dot. Do not…

A: Solution: Given data: 3- phase Delta -connected Z=40 ohm<30(degree) Voltage=374 V Angle= 140…

Q: We caucing the average cower divered to a oad by an AC signs, it is not as straght forward as DO. It…

A: Maximum voltage V = 96 V. Load resistance R=6.8 Ω.

Q: E = 10V ( I AC + VR - R=292 + VL XL Xc= 1027 + Vc What should XL at resonance? What is the magnitude…

A:

Q: Using a d.c. voltmeter and a.c. voltmeter to measure the output filter of a power supply, the obtain…

A: here we have to find the ripple of the filter output voltage.

Q: 4.2-2. Let T = 0.08 s and E(s) M S+4 (s+2)(S-2) (a) Without calculating E(2), find its poles. (b)…

A: NOTE: As per our company guidelines we are supposed to answer first three sub-parts only. Kindly…

Q: How do electric cars handle power distribution between the motor and other electrical systems in the…

A: The electric car has a motor, which gets powered by the battery source pack. The main advantage of…

Q: 13. For the following circuit, F 3 ΚΩ www 1 km2 +10 mA the power absorbed by the 3k2 resistor is:…

A: The circuit is,

Q: What are the consequences transmitter and an antenna in wireless communication? of having a…

A: Having a mismatched impedance between a transmitter and an antenna in wireless communication can…

Q: A 10-bit ADC has a full-scale of 10.230 V, when the digital output is (11 1111 1111)2. The…

A: here we have to find the quantization error of the ADC in millivolt.

Q: 3. An iron-core solenoid with a length of 20 cm and a radius of 5 cm consists of 400 turns and…

A: Length of core lc = 20 cm = 0.2 m radius of core  rc = 5 cm = 0.05 m No. Of turns     N = 400…

Q: For a 4- bus network, Zbus is shown below. [0.71660 0.60992 0.53340 0.580491 0.73190 0.64008 0.69659…

A:

Q: A capacitor is charged by connecting it to a 12 V battery with internal resistance 22. If the time…

A: Internal resistance R=2Ω. Time constant τ=2×10-4 sec.

Q: Rooftop PV PV module DC bus HZ DC/DC converter We want to build a DC-DC converter for the system…

A:

Q: Q1: let the sequence x(n)= 2√√n² 3 n³ - 3 2≤n≤3 -3<n<0 other wise 1-y₁(n)= 2x(2n-2)…

A: At n=2 &amp; 3 , x(n) will be n223=n3 x(2) = 23, x(3) = 33=1 At n=-2 &amp; -1 x(n) will  be n3-3…

Q: 5. A single phase, 60Hz, 200-km medium nominal- transmission line supplies a load of 700 MW at 0.95…

A: We are authorized to answer only one question at a time since you have not mentioned which part you…

Q: A 08 4092 20 Q 7 60 52 100) V 120 (2

A: here we have to find voltage (V) from the given circuit when voltage sources are acting.

Q: 2. Consider the circuit shown in Fig. 2, where the input is the voltage v, (t) = 10 cos(20t-0.35m).…

A: In this question We need to determine the equivalent impedance, steady state value, complex power…

Q: Al A single-phase supply vs = √2 240 sin cot, 50 Hz, supplies power to an R-L through an ideal diode…

A: Given data Supply voltage at the secondary side, vs=2402 sinωt Current extinction angle, β=222° To…

Rectangular Coordinate System

In a rectangular coordinate system, each point based on the pair of coordinates is specified uniquely in the plane. From two fixed perpendicular lines, these coordinates are at a distance in the rectangular coordinate system. Each line is known as the reference axis and axes as plural. The point where they meet is called the origin (0,0).