By means of a rope whose mass is negligible, two blocks are suspended over a pulley, as the drawing shows. The pulley can be treate as a uniform solid cylindrical disk. The downward acceleration of the 44.0-kg block is observed to be exactly 1/5 the acceleration du to gravity. Noting that the tension in the rope is not the same on each side of the pulley, find the mass of the pulley. Number Units 11.0 kg 44.0 kg

By means of a rope whose mass is negligible, two blocks are suspended over a pulley, as the drawing shows. The pulley can be treate as a uniform solid cylindrical disk. The downward acceleration of the 44.0-kg block is observed to be exactly 1/5 the acceleration du to gravity. Noting that the tension in the rope is not the same on each side of the pulley, find the mass of the pulley. Number Units 11.0 kg 44.0 kg

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The arm of a crane at a construction site is17.0 m long, and it makes an angle of 16.8◦with the horizontal. Assume that the maximum load the crane can handle is limitedby the amount of torque the load producesaround the base of the arm.What maximum torque can the crane withstand if the maximum load the crane canhandle is 785 N?Answer in units of N · m.
The wheel of a car has a radius of 0.300 m. The engine ofthe car applies a torque of 240 N*m to this wheel, which does not slip against the road surface. Since the wheel does not slip, the road must be applying a force of static friction to the wheel that produces a counter torque. Moreever, the car has a constatnt velocity, so this counter torque balances the applied tourque. What is the magnitude of the static frictional force?
A half-Atwood machine is made from a 2 kg box resting on a friction-less ramp (inclined 10 ̋above the horizontal) and a 1.5 kg box hangingfrom the other end of the string. The pulley is a disc with radius 20 cmand mass 1 kg. The system is released from rest.Determine the direction and magnitude of the hanging box’s acceleration.
A yo-yo-shaped device mounted on a horizontal frictionless axis is used to lift a 39 kg box as shown in the figure. The outer radius R of the device is O.37 m, and the radius r of the hub is 0.17 m. When a constant horizontal force F app of magnitude 270N is applied to a rope wrapped around the outside of the device, the box, which is suspended from a rope wrapped around the hub, has an upward acceleration of magnitude 0.88 m/s?. What is the rotational inertia of the device about its axis of rotation? Fapp Rigid mount Hub Yo-yo shaped device -Rope Number i Units
A solid cylinder haas a mass off 1.39 kg and a radius of 0.398 m. The cylinder is placed on an inclined surface and released from rest. The cylinder accelerates down the incline at a rate of 2.42 m/s^2, What is the manitude of the static frictional force that acts on it?
A small block with mass 0.130 kg is attached to astring passing through a hole in a frictionless, horizontal surface . The block is originally revolving in a circle with a radiusof 0.800 m about the hole with a tangential speed of 4.00 m/s. Thestring is then pulled slowly from below, shortening the radius of thecircle in which the block revolves. The breaking strength of the string is30.0 N. What is the radius of the circle when the string breaks?
A large wooden turntable in the shape of a flat uniform disk has a radius of 2.0 m and a total mass of 120 kg. The turntable is initially rotating at 3.0 rad/s about a vertical axis through its center. If one applies a constant force tangentially to the edge of the turntable, one can slow down and a. eventually stop the turntable. What magnitude of such a force (constant) should be applied to stop the turntable in 30.0 seconds? b. agai While the turntable is rotating at 3.0 rad/s, if a 70.0 kg parachutist makes a soft landing on the turntable at a point near the outer edge. Find the angular speed of the turntable after the parachutist lands. (you can treat the parachutist as point particle.) Moment of inertia for a disk: I cm = MR2
The figure below shows an arm that is balancing a carton of milk in the hand. The mass of the carton of milk is 1.77 kg, and in the figure is the gravitational force on the carton. The biceps muscle applies a force Fg to the forearm directed up and to the right at an angle of 75.0° from vertical. The point where F is applied to the forearm is 8.00 cm to the left of the elbow joint and 25.0 cm to the right of the center of gravity of the milk carton. (For simplicity, ignore the weight of the forearm.) B Milk N -25.0 cm- What is the magnitude of FB (in N)? 75.0⁰ 8.00 cm i
A small block on africtionless, horizontal surface hasa mass of 0.0250 kg. It is attachedto a massless cord passing througha hole in the surface (Fig.).The block is originally revolving ata distance of 0.300 m from the holewith an angular speed of 2.85 rad/s.The cord is then pulled from below,shortening the radius of the circle inwhich the block revolves to 0.150 m.Model the block as a particle. (a) Isthe angular momentum of the block conserved? Why or why not?(b) What is the new angular speed? (c) Find the change in kinetic energyof the block. (d) How much work was done in pulling the cord?
Copy of Consider the system shown below, where m5.6kg and ma18.5kg are attached to the ends of a massless string passing through a pulley of mass M7.Skg. The Inclined plane is frictionless and makes an angle of en420, The pulley is in the shape of a disk with radius R44 cm and the mornent of inertia of a disk is MR-/2. If the system is released from rest when mg is at an height of h-18.2m, determine the angular speed of the pulley right before mg hits the ground. Express your answer using SI units with one decimal place. Take g-9.8 m/s m2 h
Two blocks of mass m1 = 3 kg and m2 =7 kg are connected by a massless string over a pulley with radius r= 0.25 m and masa M= 9 kg . There aren't friction forces in inclined planes . The directions of acceleration a and angular acceleration a are güven in Figure. (a) Draw free-body diagram. (b) Find the linear acceleration . (c) Find the angular acceleration. (d) Find tane tensions in the string. ( 1=1\2 Mr^2 , g=9.8 m/s^2 sin53=0.8 cos53 =0.6 )
Suppose you exert a force of 170 N tangential to the outer edge of a 1.355-m radius 73-kg grindstone (which is a solid disk). What is the angular acceleration of the grindstone αf, in radians per square second, if there is an opposing frictional force of 21 N exerted 0.35 m from the axis?