a) Using resistor nearest preferred values (NPV), design a network as shown in Figure Q3a if Vcc= 25 V, Vc = 10 V, Icq = 3 mA and IC(SATURATION) = 1.5lco. Determine the values of RB, RC, and RE and state all assumptions made. Ci V₁ HH N Z₁₂ RB ww Vcc Rc RE ww lo ㅏ Co B = 100 Vo Zo

Q: The output f of the 4-to-1 MUX shown in Fig. is 3 CC 210 MUX 0 S₁ So X Y

A: Given 4×1 Multiplexer:

Q: Question No. 22 The output f of the 4-to-1 MUX shown in Fig. is 3 CC 210 MUX 0 S1 S0 X Y

A:

Q: 5. The noise level on a 3 KHz channel limits the capacity to 10 K Bits / sec. What is the signal to…

A: Given Data:   The capacity is c=10 k Bits/sec =10000 Bits/sec The bandwidth is B=3KHz=3000 Hz

Q: The Thevenin impedance of a source is 38+j35 Ohms, and the Thevenin voltage 155 +j64 V. Find the…

A: In this question We need to determine the maximum power transfer to the pure resistive load.  We…

Q: = 1 mA, 2. Find current in in the circuit shown below. Assume Vin = 2 V, R₁ = 4 kN, R₂ = 1 kN, R3 =…

A: The given circuit diagram is shown below,

Q: 9.57 Use the node-voltage method to find V, and I, in the circuit seen in Fig. P9.57. Figure P9.57…

A: Given: Here, use the node-voltage method to find Vo and Io in the circuit. And the given circuit is,

Q: R₁ 5.02 R₂ 78 &-24.0 V 0.10 E₂,-48.0V ű 0.500 Es- 6.0V 5 www 0.05 h P₂ www 40 R $200 >0.200 E 36.0 V

A:

Q: 7. In the OPAMP circuit shown in Fig. 7, V, = 10230° V. Find the average power absorbed by 20kΩ…

A: In this question We need to determine the average power absorb by the 20k ohm.  Power absorb by the…

Q: Solve using kirchhoff's law

A: KVL  Algebraic sum of voltage dros around the closed path is equal to zero. KCL  Algebraic sum of…

Q: What is the value the following sinusoidal voltage signal v(t) = 217 cos (211t+ 47°) V at t = 97 s?

A: Given data: sinusoidal voltage V(t)= 217 cos(211t+47⁰) volts Asked to find Value of sinusoidal…

Q: The following circuit has dependent sources, find the voltage Vo in figure 2. 0.3V 2ΚΩ m I 0.004Vo…

A:

Q: 10. Find the resistance between point A and B for the circuit shown in Fig. 2.247. (Nagpur…

A:

Q: What is the magnitude of the total force acting on the proton due to the electron? Express your…

A: Given  a simple model of a hydrogen atom.  Point charge (q)=1.6×10-19 C Spherical shell of inner…

Q: Combination of 3 Unequal Resistors I In the circuit Delo ne three resistors have different…

A: Given Data: A three-parallel branch circuit with Voltage source = V Resistors R1=40 Ohm, R2=35 Ohm,…

Q: 50V 10 www in ww 20 w 15 15 Mo 30 ww Fig. 2.179 11. State and explain Thevenin's theorem. For the…

A:

Q: What are available techniques to start a synchronous motor?

A: Synchronous motors are AC motors that spin at a consistent speed in time with the power supply's…

Q: Three resistances Rab Rbc and Rca are connected in delta. Obtain expressions for their equivalent…

A: Introduction In a delta connection, the three resistive elements are connected end-to-end in a…

Q: The given circuit is connected to a series RC circuit at terminals (a, b). Find the Thevenin…

A:

Q: The parallel plates of an air filled capacitor are everywhere 1.0 mm apart. What must the plate area…

A: Capacitance C=(€o A)/d  Where €o= Permitivity of air= 8.85*10-12 F/m

Q: The circuit shown in (Figure 1) is a dc model of a residential power distribution circuit. Use the…

A: In this question We need to determine current in the all resistances.  We are solving this problem…

Q: Compute the voltage v(t) at t = 1s, knowing that L = 10H and i(t) = 5e-²t A. i(t) I L & J (t) ✓…

A: In this question We need to determine the value of voltage VL   We know Voltage across the inductor…

Q: Q.4 A three-phase synchronous motor with synchronous impedance of 0.1+j0.3 per unit per phase has a…

A: Given data- A three-phase synchronous motor- Synchronous impedance = (0.1+j0.3) per unit per phase,…

Q: (2) For the circuit of Figure 3, assume R = 80 Ohms and solve for Vout(t).

A:

Q: 11. Connect the circuit of Figure 2-13. Place CM switch 3 in the ON position to change the value of…

A: Given the circuit  using the CM switch 3 in the ON . R1=100 Kohm

Q: 35. Determine la capacitancia equivalente Ceq de la red de la figura 7.56. :7F 12 F 10 F a =4F -Cea7…

A: Given the circuit,

Q: + E=16.8 V R₁ www 90 T R₂ www 60 T B R₁40 B R. 60 R$ 30 C Ic C R. 30

A:

Q: Consider the system y = T[x] = x + b where x is the system input and y is the system output. Find a…

A: To find the value of 'b' that makes the system linear

Q: iii) Find the Product of Sum (POS) using the K-Map, and draw simplified ckt using NOR gate only.

A:

Q: (a) Calculate the transfer function G(s) = 8₂ (s)/T(s) for the system shown below. [Section 2.71 I…

A:

Q: 9. Using nodal voltage method, compute the power dissipated in the 9-22resistor of Fig. 2.91. [81 W]…

A:

Q: 7.10 For a wave characterized by the electric field E(z, t) = ax cos(wt - kz) +ŷay cos(wt - kz + 8)…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Explain the charging system from Supply system to the battery in detail

A: In an Electric Vehicle (EV), the charging system is responsible for transferring electrical energy…

Q: 1. Given x(t) and h(t), find y(t) = x(t) * h(t) x(t) = 2u(t)- 2u(t-1) h(t) = 3u(t)- 3u(t - 2) * u(t)…

A:

Q: Sketch the asymptotic magnitude of the Bode diagram of s+1 5s² + 10s + 500 H(s) = 10²,

A: Given the transfor function HS=102S+15S2+10S+500HS=20S+1S2+2S+100

Q: Q2) Find V1, V2, and V3 for the following circuits: 24 V + www 12 V ww V3 10 V 40 V - 50 V + +30 V-…

A: The given circuit diagram is shown below,

Q: 4. Given VDD-3.3V and VT-0.55V find Vout for the following Vin voltages (a) 0.6V(b)3.8V(c)8V(d)0.22V…

A:

Q: Use nodal analysis to find V, in the following circuit: 20 Ω Here, vx = (40+ 9 υχ Μ 10 Ω Μ 20 Ω ) V…

A:

Q: Find the currents I1, I2 and Ig of the circuit shown in figure 1. 100 V 10 ΚΩ 4ΚΩ I 2 ΚΩ 13 >6 ΚΩ 48…

A: In this question We need to determine the unknown currents as shown the circuit.  We are solving…

Q: 8. Use Thevenin's theorem to find current in the branch AB of the network shown in Fig. 2.176. [1.84…

A:

Q: 1. Draw a sticks diagram of this master-slave D-flipflop Optimize and count the number of: a.…

A: According to the question, for the given diagram as shown below Draw a sticks diagram of this…

Q: Find the Thevenin equivalent from the terminal a and b. Data: R₁ = 492, R₂ = 214, R₂ = 6N, R₁ = 2N,…

A:

Q: 1.10 Show that the average power of the CT signal y(t) = A₁ sin(@₁t + 1) + A2 sin(@2t +$2), with…

A: Introduction Continuous-time signal: In the field of signal processing and communications, a…

Q: A 2500 V, 50 Hz, 1000 hp 0.85 PF leading four poles Y-connected synchronous motor has a synchronous…

A: It is given that: V=2500 Vf=50 Hzcosϕ=0.85 leadingXs=1.5 ΩP=1000 hp EA2=1.15EA1

Q: 13. Name two circuits that can be used to create clock generators in ASICS. a. b.

A: Two circuits which can be used to generate clock in ASIC are frequency synthesizer and PLL and…

Q: c) Three single-phase transformers rated at 150KVA, 3000V/300V, 50Hz, are connected in wye-delta on…

A: Given the 3 single phase transformer at 1500 KVA ,3000 V300 V,50 Hz,wye delta on 6250 V,Load=150 k

Q: 10. State and explain Thevenin's theorem. By applying Thevenin's theorem or otherewise, find the…

A: The given circuit can be reduced to thevein's equivalent and the required parameter can be…

Q: 10. The power absorbed by element 2 in the following figure is -10 W. What is I,? 11V 6V Is 2 5V

A: Given circuit: The power absorbed by element 2 is -10 W.

Q: Acos 2t V R www m v (t) B sin 2t V For the circuit shown above, what is the amplitude of the…

A: Given data Two voltages sources are Acos2t V and Bsin2t V. A=75B=14R=1 ΩL=24 HC=1.0 F We have to…

Q: Consider the circuit shown in Figure 4. Calculate the current through &₁ = 120.0 V battery. Problem…

A:

Q: 1. Find the current supplied by the battery in the circuit of Fig. 1. 24V 892 ww ww 12 92 Fig. 1

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.