A system executes a power cycle while receiving 750 kJ by heat transfer at a temperature of 1500 K and discharging 100 kJ by heat transfer at a temperature of 500 K. Another heat transfer from the system occurs at a temperature of 1000 K. Determine the thermal efficiency if Ocycle = 0.1 kJ/K. T3 = 1000 K Q₁ = 750 kJ 2₂= 100 kJ = 1500 K Weycle T₂ = 500 K

A system executes a power cycle while receiving 750 kJ by heat transfer at a temperature of 1500 K and discharging 100 kJ by heat transfer at a temperature of 500 K. Another heat transfer from the system occurs at a temperature of 1000 K. Determine the thermal efficiency if Ocycle = 0.1 kJ/K. T3 = 1000 K Q₁ = 750 kJ 2₂= 100 kJ = 1500 K Weycle T₂ = 500 K

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter8: Natural Convection

Section: Chapter Questions

Problem 8.46P

See similar textbooks

Similar questions

Shown in the figure below is a system that executes a power cycle while receiving Q1 = 1800 Btu by heat transfer at a temperature of T1 = 1000°R and discharging Q2 = 1200 Btu by heat transfer at a temperature of T2 = 800°R. A third heat transfer occurs at a temperature of T3 = 600°R. These are the only heat transfers experienced by the system. (a) Applying an energy balance together with Eq. 5.13, determine the minimum and maximum values for Q3, in Btu, for the heat transfer at T3 = 600°R.(b) For the power cycle, evaluate the maximum theoretical thermal efficiency.
A heat engine receives an amount of energy Qh = 610 kJ by heat transfer from a high temperature thermal reservoir at Th = 840 K. Energy is rejected by heat transfer to a lower temperature thermal reservoir at Tl = 460 K. If the engine develops an amount of work equal to Wcycle = 160 kJ during each cycle answer the following questions. Solve for the actual efficiency that the engine is operating with.
1. In an analysis, a heat engine based on the Carnot cycle operating between 1000 0C and 300 0C. The heat rejected from this engine to the sink was at a rate of 800 kJ/min. Determine the thermal efficiency (in %) and power output (in kW) of the engin 2.You found out that the power output of your dream car is the same as the sum of each digits of your student number (in kW) with a percentage thermal efficiency the same as the first four digit of your student number divided by 100. The calorific value of the fuel available has a calorific value of 40 000 kJ/kg. Assuming a constant power output from the car, calculate the heat transfer rate (in kW) and the fuel consumption rate (in kg/h)
During transient state operation, a gearbox receives 60 kW through the input shaft and delivers power through the output shaft. For the gearbox as the system, the rate of energy transfer by convection isQ T = −hA (Tb – Tf)where h = 0.171 kW/m 2 ⋅⋅ K is the heat transfer coefficient, A = 1.0 m 2 is the outer surface area of the gearbox, Tb = 300 K (27°C) is the temperature at the outer surface, and Tf = 293 K (20°C) is the temperature of the surrounding air away from the immediate vicinity of the gearbox. The rateof specific internal energy is 5kJ/Kg. For the gearbox, evaluate the heat transfer rate and the power delivered through the output shaft, each in kW.
A heat engine operates between thermal energy stores at 800 ° C and 20 ° C. Half of the power generated by the heat engine drives the Carnot heat pump, which is used to heat a house. While the interior temperature of the house is 22 ° C, the outside temperature is 2 ° C, the heat loss of the house is 62000 kJ / h. In these conditions, calculate the minimum heat that should be given to the heat machine per unit time as kW.
Q1. Solve all parts Depicted in Fig. Q1 is an irreversible refrigerator whose compressor is powered by a reversible heat engine that operates between temperature extremes Thot = 473K and cold = 293 K. The refrigerator depicted uses a dichlorodifluoromethane refrigerant (Refrigerant 12) circulating by means of the compressor at mass flow rate = 0.15 kg/s. The other components of the refrigerator are two heat exchangers in the form of an evaporator and a condenser, and a throttle valve. Information recorded at the state points depicted in Fig. Q1 is as follows: State point 1: dryness fraction x₁ = 1 and temperature t₁ = 15 °C. State point 2: dryness fraction x2 = 0 and temperature t₂ = 15°C. State point 3: wet vapour at temperature t₁ = -20°C. State point 4: wet vapour at temperature t₁ = -20°C. (a) Determine the thermal efficiency NR of the reversible heat engine depicted in Fig. Q1, and consequently determine power -W4-1 supplied to the compressor given that the rate of heat supplied…
Q: The working fluid, in a steady flow process flows at a rate of 220 kg/min. The fluid rejects 100 kJ/s passing through the system. The conditions of the fluid at inlet and outlet are given as : C1 = 320 m/s, p1 = 6.0 bar, u1 = 2000 kJ/kg, v1 = 0.36 m3/kg and C2 = 140 m/s, p2 1.2 bar, u2 = 1400 kJ/kg, v2 = 1.3 m3/kg. The suffix 1 indicates the condition at inlet and 2 indicates at outlet of the system. Determine the power capacity of the system in MW. The change in potential energy may be neglected. Fluid Fluid leaves System enters
A heat pump maintains a dwelling at 68°F. When operating steadily, the power input to the heat pump is 5 hp, and the heat pump receives energy by heat transfer from 55°F well water at a rate of 500 Btu/min. (a) Determine the coefficient of performance. (b) Evaluating electricity at $0.18 per kWh, determine the cost of electricity in a month when the heat pump operates for 300 hours. Part A Determine the coefficient of performance. y = i
A heat pump with a coefficient of performance of 3.5 provides energy at an average rate of 70,000 kJ/h to maintain a building at 20 deg C on a day when the outside temperature is -5 deg C. If electricity costs 8.5 cents per kWh, (a) determine the actual operating cost and the minimum theoretical operating cost, each in $/day. (b) compare the results of part (a) with the cost of electrical-resistance heating.
An engine operates between temperature limits of 900 K and T2 and another between T2 and 400 K. For both to be equally efficient, the value of T2 will be
A Carnot engine operates between temperature levels of 600 K and 300 K. It drives a Carnot refrigerator, which provides cooling at 250 K and discards heat at 300 K. Determine a numerical value for the ratio of heat extracted by the refrigerator (“cooling load”) to the heat delivered to the engine (“heating load”).
A claim states that a power cycle has been invented that produces work of 400KJ and requires energy transfer to the system of 300kJ. Such device is possible. O True O False