A signal of 0.1 kW is transmitted in a cable. The attenuation of cable is -5 dB per km and cable length is 20 km. The power received at receiver is 10-x W. The value of x is O a. 5 O b. 6 O c. 7 O d. 8

Q: H.W4 The diode in the single-phase half wave rectifier has a reverse recovery time of t₁ = 150µsec…

A: Given data:

Q: Evaluate the factors that influence the choice of an appropriate cable for a specific connection.

A: When choosing an appropriate cable for a specific connection, several factors should be considered.…

Q: Vin R₁ + R₂ N Vout What is the voltage gain in V/V for the operational amplifier circuit shown?…

A: Op-amp circuit,Where,The op-amp is idealInput resistance, .Feedback resistance, .

Q: A uniform quantizer, with average quantization power of 67.5 mW, is used in a PCM system. 1) What is…

A:

Q: The unmodulated carrier power in an AM transmitter is 5 kW. This carrier is modulated by a…

A: In this question, we need to choose the correct option. What is unmodulated carrier power for…

Q: 3. (a) Show that if F(s) = L{f(t)}, and then (Hint: Use the defining integral to write ∞ ∞ S F(u)du…

A:

Q: K= K₁= K₂= volts volts volts

A:

Q: Consider the position control system given below. Determine the value of K such that the steady…

A:

Q: find the output of the given circuits. 3. x 2 y 2 y 2

A: In this question, we need to determine the output of the circuits. Both the circuits have AND, NOT…

Q: H.W3 The single-phase full wave rectifier has a purely resistive load of R, and I₁=10A and average…

A: Given Data:A single-phase, full-wave, center-tapped rectifier with a resistive load of,Average power…

Q: If the field current of a shunt wound d.c. motor is halved, what effect will this have on the speed?…

A: Dc shunt motor is a constant flux motor.Asked to find the speed when the field current is reduced by…

Q: Let D = 2xy ax - x² ay C/m² and find (a) The charge density. (AS) Pv D PL A (b) The flux through…

A:

Q: The AC voltage appearing across a load is 2sin(10^5t) and the AC current through the load is…

A: The voltage across the load, The current flowing through the load,

Q: In the figure below, part of a long insulated wire carrying current i = 5.78 mA is bent into a…

A: We are given,What is a magnetic field at the center of curvature C if the circular sectiona) Lies in…

Q: For the data stream 011100101, sketch the transmitted sequence of pulses for each of the following…

A: The data stream is given byD = 011100101.We need to sketch the transmitted sequence of pulses for…

Q: ▸ A 25-KVA, 4000/400-V, 60-Hz transformer has the following parameters: Χι RH 18 S2, XH = 25, R₂ =…

A: Given dataTransformer rating f=60HzRH=18Ω,XH=25ΩRL=180mΩ,XL=250mΩRCH=15kΩ,XMH=25kΩasked to find the…

Q: Consider the linear de machine shown below. Frinctionless rails Sliding bar R₁=0.12 10 N 0.75 m t=0…

A: For the given linear DC machine arrangement, we need to determine:1) direction of electromagnetic…

Q: In the circuit given below, R = 80 2. Find the value of io using mesh analysis. 400 V (+1 4 A ↑ The…

A: Mesh analysis uses ohms law and Kirchhoffs voltage law.The detailed solution is provided below.

Q: Find the open circuit voltage between terminals a & b. -/39 j60 100/0° V Select one: 402 ww j8Q2…

A: Given circuit diagram :

Q: Consider the following to the modification with a voltage controlled voltage source to the eariler…

A:

Q: (a) Compute the Fourier transform of the signal x1(t) = e| tl .

A: Given that,               signal x1(t)=               Fourier transform of signal x1(t) is X1(w)=?

Q: The phase angle of the current with respect to the voltage in the circuit shown in Figure 38 is A…

A: Given circuit diagram is,

Q: The circuit has a switch that closes at t=0. Resistor R = 2.6ohms. L=0.1H, C= 4F while Vs= 24 volts…

A:

Q: 2/0° A CS Scanned with CamScanner 1 -j1 Ω Η 41: 1Ω + σχον 1Ω + Vo

A: The question is about finding output voltage Vo using superposition principle.

Q: Choose the right output of the following code Input Ladder logic program L1 -Input A Select one: O…

A: From PLC ladder diagramInput is switch AOutputs are lamps, Green, Red and Yellow

Q: 2.2 k For the series diode configuration of Fig. 2.16, determine VD. VR. and Ip

A: The given circuit is,To calculate the diode voltage, diode current and load voltage.

Q: A FM wave is represented by the following equation, V-9sin (5 x 10't +3sin1300t) Find; a) Carrier…

A: In this question, we need to determine the carrier frequency, modulating frequency and modulation…

Q: Determine the power consumed by resistor R₂, given: Ę₁ = 19 V, R₁ = 1102, R₂ = 1702, R₂ = 4102, and…

A: Given circuit:Component values are,Asked to find the power consumed by the resistor R3

Q: Determine the power consumed by R₁, given: Ę₁ = 145 V, R₁ F 24, R₂ = 37, R₂ = 232, and R₁ = 210…

A:

Q: C. Draw a representative circuit diagram in the box below. d. On the diagram, annotate component…

A: The given circuit isWe need to find the voltages Vs, Vb and the current I3 using Kirchoff's laws.

Q: Design a Half Subtractor Circuit and provide its Gate-Level Modeling, Data Flow Modeling, and…

A: Need to design a Half Subtractor Circuit and provide its Gate-Level Modeling, Data Flow Modeling,…

Q: Determine the power consumed by resistor R₂, given: E₁ = 224 V, R₁ = 180, R₂ = 37, and R3 = 420…

A:

Q: Evaluate the impact of microchip technology on the development of electronic devices.

A: It is asked to evaluate the impact of microchip technology on the development of electronic devices.

Q: A. Define Commutation commutation method in details.

A: define commutation

Q: Determine the current flowing through resistor R₁, given: 4' E₁= 15 V, R₁ = 232, R₂ = 142, R₂ = 142,…

A: The battery voltage, The resistors,

Q: Q₁. Find the thevenin's equinolent circuit. R₁ 52052 33052 m 27052 M A 201 + зака {1K52 Calculato:…

A:

Q: If the capacitive reactance of a parallel R-C circuit is 10 times the resistance value, would the…

A:

Q: Q1 Given circuit below. BJT is specified to have ß-100 when in active mode and |VBE 0.7V. Find…

A: The given circuit isβ=100.|VBE|=0.7 V.We need to find all the currents, node voltages and mode of…

Q: Liquid tight flexible nonmetallic conduit is subject to which of the following limitations? cannot…

A: The question is asking about the limitations of liquid tight flexible nonmetallic conduit (LFNC).…

Q: an rlc circuit has a sinusoidal vtage supplied to it at 632 Hz with a peak voltage of 748 V; a 25…

A:

Q: 5. The value of an unknown load at the end of a transmission line can be determined by measuring the…

A: The characteristic impedence , The incident or forward voltage, The reflected voltage,

Q: 3. Solve the following Vin R1 100kQ P12 P12 IT N12 R2 ww 1kQ V1 12V U1A LM324AD N12 Hit V2 12V Vout

A:

Q: Question 2 Diode The diodes in the circuit are ideal. Find Vo as a piece-wise linear function of VIN…

A:

Q: sketch the s-plane poles of a 2nd order butterworth filter with cutoff frequency of 2 radian/sec

A: To sketch the poles of a second order (n=2) butterworth filter with cut-off frequency ωc=2 rad/s.

Q: E = 120 V 20⁰ f = 2 kHz Find the total impedance 12+1= Find the total current |ls| = Z R₁ Find the…

A:

Q: The two parallel inductors in the figure below are connected across the terminals of a black box at…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Assignment: obtain the root locus of the following system q(S) = 1 +K_S+2 S3+1

A: The characteristic equation is given below..The loop transfer function is.

Q: Match the transfer function with step response

A: The transfer functions of the systems are given bya. T(s)=289s2+3.4s+289.b. T(s)=5s+5.c.…

Q: a. A THREAD is defined as b. Name of the 3 commonly used ARM buses are APB and c. Multiprocessors.…

A: Since multiple subparts have been answered as per Bartleby guidelines only the first 3 are answered.…

Q: For the circuit below, find the transfer function H(w) = Vo/Vi. Vi 10 с L R +

A: The given circuit isWe need to find the transfer function H(ω)=VoVi.

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.