• A generator driven by a wind turbine is required to deliver 1.5MW of power at the generator terminals. The turbine is a two-blade propeller rotating about a horizontal axis. The rotor is designed to operate at a rotational speed of 22 rpm. • If the turbine delivers its rated power at a wind average speed of 22 mph, Calculate the corresponding diameter of the propeller and its TSR, assuming a typical value of 0.35 for the overall efficiency. The air density may be assumed to have a value 1.29 kg/m³.

• A generator driven by a wind turbine is required to deliver 1.5MW of power at the generator terminals. The turbine is a two-blade propeller rotating about a horizontal axis. The rotor is designed to operate at a rotational speed of 22 rpm. • If the turbine delivers its rated power at a wind average speed of 22 mph, Calculate the corresponding diameter of the propeller and its TSR, assuming a typical value of 0.35 for the overall efficiency. The air density may be assumed to have a value 1.29 kg/m³.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Comment Shard Q9: Salalah city is planning to install a 3.0 MW wind turbine. The turbine has a 112 m rotor diameter and the power/speed curve shown in Figure Q9. During the daytime hours (7am to 7pm) the wind speed is 12 m/s and the cost of electricity is $100/MWh. During the nighttime hours the cost of electricity is $50/MWh and the wind speed is 6 m/s. Assume that the air density is constant at 1.2 kg/m³. Determine the power output, wind power input, and efficiency of the turbine/generator during the daytime hours. Determine the power output, wind power input, and efficiency of the turbine/generator during the nighttime hours Calculate the daily revenue that the plant earns from selling electricity. 3,000 2,500 2,000 1,500 1.c00 s00 25 Outout kW)
Two identical 2,000 kW alternator operates in parallel. The governor of the first machine is such that the frequency drops uniformly from 50 Hz at no-load to 48 Hz at full-load. The corresponding uniform speed drop of the second machine is 50 Hz to 47.5 Hz. What is the maximum load that can be delivered without overloading either machine?
The terminal voltage of a 150 kW series generator is 600 V at rated load. The armature resistance is 0.06 ohms and the series field resistance is 0.04 ohms. Find generated emf.
• - 1800 pm In a two pole 3-p synchronous generator, the peak flux of rotor magnetic field is o5Tand the rotor rate of rotation is 1800 rpm. The stator windings have a surface area of 0.1 m? and there are 50 turns per Bmax : 0.5T, 0.5T coil. The machine is A-connected. A: 0-1 m? N: 50 a) What is the RMS phase and line voltage of the generator? b) Write the three stator phase voltages as functions of time.
3. What are the various losses in an induction motor? On whatfactors do they depend?
Q-4 100 MVA, 50 Hz alternator is operating at rated speed. The H constant of the machine is 5 MJMVA. The load suddenly increases by 50 MW. Due to delay in governor action, there is a delay of 0.5 sec in opening of steam value. The frequency deviation in percentage is
Steam enters an adiabatic turbine at 6 MPa and 550 °C and leaves at 10 kPa and 50 °C. If the environment temperature and pressure is 0 °C and 103.325, what is the second law efficiency of the turbine? O a. 0.70 O b. 0.75 O c. 0.81 O d. 0.72 O e. 0.78
A three-phase induction motor operates at a slip of 3% and has a rotor copper loss of 300W. The rotational loss is 1500W. Determine (a) the airgap power and (b) the power output.
A 6 pole DC wave wound generator has 28 armature conductors with flux per pole is 23 mWb and the e.m.f generated is 64 V, then the speed of the machine is O 99.38 rps O 0.63 rps O 33.13 rps O 6.34 rps The thermocouples are suitable for temperature measurement applications in the range of 200°C to over 2000°C. Select one: O True O False
The coil span for alternator having fractional pitch winding of 9/14 is .................. 96.00 O 115.71 2.02 4.88 An induction motor at standstill the frequency of voltage generated in the rotor is the same as the frequency of the stator. Select one: O True False
A generator is feeding the load. A second load will then be connected in parallel with the first load. The generator has an idle frequency of 61Hz and an Sp slope of 1MW/Hz. Load2 draws 800kW active power at 0.707 reverse power factor, while load1 draws 1000kW active power at 0.8 reverse power factor. What will be the operating frequency of the system after load 2 is connected? *Please explain the solution step by step
6. Home Works: a) The figure below shows the per-phase equivalent circuit of a two- pole three-phase induction motor operating at 50 Hz. The voltage (E1) across the magnetizing inductance is 210 V, and the slip (s) is 0.05. What is the developed torque produced by the motor ? 0.04 0 jo.22 Q j0.22 0 j6.28 NE E1 0.05 0