A cylinder that has a 41.0-cm radius and is 50.0 cm deep is filled with air at 29.5°C and 1.00 atm shown in figure (a). A 21.0-kg piston is now lowered into the cylinder, compressing the air trapped inside as it takes equilibrium height hi as shown in figure (b). Finally, a 21.5-kg dog stands on the piston, further compressing the air, which remains at 29.5°C as shown in figure (c). What is the value Ah?

A cylinder that has a 41.0-cm radius and is 50.0 cm deep is filled with air at 29.5°C and 1.00 atm shown in figure (a). A 21.0-kg piston is now lowered into the cylinder, compressing the air trapped inside as it takes equilibrium height hi as shown in figure (b). Finally, a 21.5-kg dog stands on the piston, further compressing the air, which remains at 29.5°C as shown in figure (c). What is the value Ah?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Solve the following problems. Provide correct units with answers. 1. If atmospheric pressure is 14.7 psi and the gauge pressure is 64 psi, what is the total or absolute pressure? 2. If atmospheric pressure is 14.7 psi and the absolute pressure inside a container is 69 psia, what would a gauge read? 3. 24 cubic feet of a gas at a gauge pressure of 246 psig is compressed to 6 cubic feet. After the temperature has cooled to the original value, what will be the new gauge pressure? The atmospheric pressure is 14.7 psi. 34 cubic feet of a gas at a gauge pressure of 146 psig is compressed to 6 cubic feet. After the temperature has cooled to the original value, what will be the new gauge pressure? The atmospheric pressure is 14.7 psi. 24 cubic feet of a gas at a gauge pressure of 460 psig is allowed to expand to 36 cubic feet. After the temperature has warmed to the original value, what will be the new gauge pressure? The atmospheric pressure is 14.7 psi. 14 cubic feet of a gas at a gauge…
Topic: Thermodynamic Measurements and Quantities 5.) A 15cm diameter piston was uniformly applied by a force of 1200 N. Find the pressure on the piston.Express answer in kilopascals.
The porous catalyst pellet shown in Figure 1 has an overall radius R and a thermal conductivity k (which may be assumed constant). Because of the chemical reaction occurring within the porous pellet, heat is generated at a constant rate of Se cal/em s. Heat is lost at the outer surface of the pellet to a gas stream at a constant temperature T, by convective heat transfer coefficient h. Gas bemperature T, Figure I. Sphere with internal heat generation Answer the following questions (a) Make a list of assumptions that apply to the above situation. (b) Set up the differential equation by making a shell energy balance. Show the units for all variables that are used. (c) Specify the proper boundary conditions. (d) Integrate the differential equation with the above boundary conditions to obtain an expression for the temperature profile, and make a sketch of the function profile T(r) (e) What is the limiting form of T(r) when h co? (f) What is the maximum temperature in the system? (g)…
Consider an ideal gas at 27.0 degrees Celsius and 1.00 atmosphere pressure. Imagine the molecules to be uniformly spaced, with each molecule at the center of a small cube. Part A What is the length L of an edge of each small cube if adjacent cubes touch but don't overlap? Express your answer numerically in meters. ► View Available Hint(s) L = for Parval for PartAddo for Part Submit redo for Part A reset for Part A keyboard shortcuts for Part A help for Part A m
Const Express your answers using two significant figures separated by comma. Vz avg, Vy avg = 0,0 m/s The molecules in a six-particle gas have velocities v1 = (20i – 30j) m/s v2 = (50i + 907) m/s Submit Previous Answers v3 = (-90i + 20j) m/s v4 = 30i m/s vs = (40i – 40j) m/s v1 = (-50; – 403) m/s v Correct Part B Calculate vavg Express your answer to two significant figures and include the appropriate units. HA m Vavg = 0 S Submit Previous Answers Request Answer X Incorrect; Try Again; 5 attempts remaining Part C Calculate vrms Express your answer to two significant figures and include the appropriate units. Vrms = 69 " Submit Previous Answers
A 20-ton vapor compression refrigeration system is to evaporate R-12 at -20°C and to condense it at 40°C. The vertical compressor is to run at 10000 rpm; it is single acting, has the bore equal to the stroke, and has 5% clearance. Vapor enters the compressor at -10°C and liquid enters the expansion valve at 30°C. Draw the schematic and ts diagram 1.1 What refrigeration flow rate is required?1.2 What would be the bore and stroke of the compressor?1.3 What power is required by the compressor?1.4 What is the quantity of the cooling water required in the condenser for a 8-degree increase in temperature?
PROBLEMS 1.1. In the table below, a number in the top row represents the pressure of a gas in the bulb of a constant-volume gas thermometer (corrected for dead space, thermal expansion of bulb, etc.) when the bulb is immersed in a water triple-point cell. The bottom row represents the corresponding readings of pressure when the bulb is surrounded by a material at a constant unknown temperature. Calculate the ideal- gas temperature T of this material. (Use five significant figures.) PTP, kPa P, kPa 133.32 99.992 33.331 66.661 102.37 204.69 153.54 51.190
I. Solve the following problems by introducing variable/s and formulating appropriate equation/s. 1. Three painters, Mike, Dan and Katy, working together can paint the exterior of a house in 10 hours. Dan and Katy together have painted a similar house in 15hours. One day, all three worked on this same kind of house for 4 hours, after which Katy left. Mike and Dan required 8 more hours to finish. Assuming no gain or loss in efficiency, how long should it take each person to complete such job alone? 2. The sum of three numbers is 108. The sum of 1/3 the first, 1/4 the second, and 1/6 the third is 25. Three times the first added to four times the second and six times the third is 504. Find the numbers. 3. 1. Mr. Cruz invested P100,000.00 part at 6% and the rest at 8%. How much should be invested at each rate so that the income from the 8% is twice the income from the 6% investment? 4. 2.Nine men agreed to rent a van for their trip to Sagada. Three of them backed out at the last minute. As…
Topic: Thermodynamic Measurements and Quantities 4.) The equivalent pressure gauge of a compound gauge measuring a pressure of 25.3 inches mercury is ____. The density of mercury is 13.53 g/cm3: Express your answer in kilopascal.
PROBLEM SOLVING. Choose 4 numbers only. Write the given data, the unknown, the formula and the complete solution. 1. A quantity of gas exerts a pressure of 2.4 atm when its volume is 4.0L at 40⁰C. Calculate the pressure exerted by the same gas if the temperature is raised to 50⁰C while the volume is reduced to 1.5L. 2. A steel bridge is built in several segments, each 20m long. One end of each segment is fixed and cannot expand while the other end is free. The gap between the segments is 4.0 cm at 18⁰C. What is the maximum temperature that the bridge can manage before buckling? The coefficient of linear expansion of steel (α) = 12 x 10-6 /⁰C. 3. Find the rate of heat transfer through a 2.0-m long steel rod if one end of which is placed in an 800K fire. The cross-sectional area of the rod is 1.5 cm2 and the cool end is at 315K. The thermal conductivity of the steel rod is 16.5 J/s-m-K. 4. A 2-kg copper bar is cooled to 60⁰C. If the copper gave off 50 kJ of energy, what was the initial…
Please answer these 2 subunits.8. A block occupied 0.2587ft3. What is its volume in mm3?9. If you are going 55mph. What is your speed in nm per second?
Problem 1.14. Calculate the mass of a mole of dry air, which is a mixture of N2 (78% by volume), 02 (21%), and argon (1%). 2. Construct a mental "model" of a container full gas to describe how, exactly, is temperature related to energy? Use the Macroscopic Model of an Ideal Gas. Precisely, you want to know how the temperature of a gas is related to the kinetic energy of the molecules it contains.