A coil that consists of 450 windings is wound around a Bakelite ring. The mean diameter of the ring is 100 mm and the diameter of the Bakelite core is 20 mm.The current through the coil is 3A. Determine the field strength

A coil that consists of 450 windings is wound around a Bakelite ring. The mean diameter of the ring is 100 mm and the diameter of the Bakelite core is 20 mm.The current through the coil is 3A. Determine the field strength

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.9MCQ: Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated...

See similar textbooks

Related questions

Q: 4. Considering an edge triggered T flip-flop, answer the following THREE questions (a) Write out its…

Q: (a) A system consists of two components that can be presented by the respective h₁ (t) =…

A: GIVEN: h1(t)=3000e-20th2(t)=t e-10tu(t) input voltage of the system…

Q: (c) Design a Butterworth equal component high-pass active filter with f-3dB at 1kHz and at 10Hz,…

Q: Q4/ Find the input impedance (Zin) for the circuit shown below j252 Voltage source 5002 L₁ j1022 L₂…

A: Given data,

Q: Determine the current supplied by each voltage source (8 V,12 V). using superposition theorem in…

Q: alternative name for volt/ohm

Q: 47. In NPN BJT, .......current is lowest current. O a. Base. O b. Collector. O O d. Drain. O e.…

A: A BJT is a current controlled Device in which base current control the mode of operation of BJT.…

Q: B- Compare between circuit switching, message switching, data gram packet switching and virtual…

A: Switching : Switching techniques involves a specific message which is to be transferred from initial…

Q: 2.82 A 10 KVA, 2200/220 V transformer gave the following test results: Open circuit test, High…

A: Given, A 10 kVA, 2200/220 V transformer gave the following test: Sfl=10 kVA Open circuit test: High…

Q: Determine the current supplied by each voltage source (8 V,12 V). using superposition theorem in…

A: Given circuit, To determine current supplied by each voltage source using superposition.

Q: Simplify the following block diagram. qo G₁ H₁ G₁ H₂ G₂ G₂

A: Given:

Q: Q3/ For the circuit shown find (a) Equations for 1₁ and 1₂ with respect to V₂ (b) The value of V₂/Vs…

A: It is given that:

Q: 03: For system shown in Fig.(2) below: R(s) 11 s+10 h →C(s) Fig. (2) What is the value of h that…

A: Steady State Error : When the output response is not similar to the input given to the system in…

Q: B 36v R₁ MM I C 32 1 arrat 5) Energy passing used 4.22 1+T₂ ww JOV A using Kirchhoff's current and…

A: We need to find out the current through each resistor

Q: A constant speed drive has following duty cycle: 2 A constant speed drive has following duty cycle:…

A: The instantaneous power is given byPi=14∫044005x2dx=400514×x3304=400514×643=3203 kW

Q: Q2/ For the circuit shown, find Vo(t) and lo(t)

Q: If vi(t) is a step voltage in the network shown find the value of the resistor such that a 25%…

Q: 2) In an n-channel enhancement type MOSFET if VGS = Ov and VDs > Ov then ID> 0 A. a) True. b) False.…

Q: Determine Vout for Vin=169 V, R1=234 Ohm, R2=28 Ohm Vin 썰 R1 R₂23 ㅎ bur

A: In this question, We need to determine output voltage Vout as shown the circuit. We are solving…

Q: How do the grade 12 TVL-EIM students utilize electrical wires as accessories in terms of 2.1…

A: Organization - the report is factual and showing evidence of some work, 2 Elements of research…

Q: difference between sensors and detectors.

A: Sensor are detector are devices which responds the input energy. The output is the generated signal…

Q: It's a Physics question about mechanical engineering. A shunt motor has a speed of 900 rpm when it…

A: DC Motor:- When motor is operated by direct current than it is called DC motor, which converts DC…

Q: 1) The trigger waveform of the monostable multivibrator has an amplitude that Vcc must be less than…

A: The Types of Multivibrator used in the digital electronics systems are enlisted as follows :…

Q: (B): Obtain the transfer function V₂(s)/V₁(s) of the electronic cct. shown in Fig. (3) C₁ ਮੁਰੰਮਤ '…

Q: 230 V, 50 Hz, 4 – pole single-phase induction motor has the following equivalent circuit…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Find the current I if: V₁=2V, V₂=1.5 V, R₁-20 KQ2, R₂-10 KQ and R3=5 KQ. V₂ V₁ R₁ ww R₂ ww R3 R₂ m…

Q: 1.1.3 Sketch the signal y(n)= x(n+1)[8(n+3)+8(n)+8(n-3)].

Q: (a) A capacitor of capacitance 30 µF and resistance 40 Q is connected to a 100 V, 50 Hz supply.…

Q: (b)- For a feedback system G-k, G,-1/(s'+6s+12) and H=s+2, k20. (bl)- sketch the Root Locus (RL)…

A: The Given Feedback system Gc=k Gp=1s2+6s+12 & H=s+2,k≥0. To sketch the root locus RL To find…

Q: Q2/ For the Two Port Network shown below find the impedance (Y) parameters 100Ω Μ 30Ω 40Ω www 60Ω…

A: Given circuit:-

Q: Consider the circuit in Fig. 16.12(a). Find the value of the voltage across the capacitor assuming…

A: Given that Vst=10 utinitial current through inductor i0=-1Ainitial voltage across capacitor…

Q: according to the circuit determine the voltage, current and power of each resistance applying…

A: Given: Consider the following circuit: To find: Determine the voltage, current, and power of each…

Q: For the circuit shown in the figure, determine the value of RL. What will make the Zener diode reach…

A: The given circuit is

Q: A solenoid coil has a resistance of 30 Ohms and an inductance of 0.5H. If the current flowing…

A: This question belongs to circuit theory . It is based on the concept of impedance of coil . Problem…

Q: An AM radio station using double side band transmitted carrier system employs a carrier of frequency…

Q: In a series RLC circuit driven by an ac generator, the angular frequency is tunable in the sense…

A: Q- factor is the dimensionless parameter that it show the underdamped condition of a oscillator and…

Q: A high-voltage generator is connected to a 3-phase wye connected load through a transmission line.…

Q: A. WHICH OF THE FOLLOWING TYPE OF TRANSFORMER IS REQUIRED TO CREATE A 180 DEGREE PHASE DIFFERENCE…

A: A transformer is an electrical energy transfer device that either steps up or down the voltage from…

Q: convert the transfer functions into linear differential equations: a) 1/(1.896s+1) b)…

A: Given data : Transfer functions are (a). 1(1.896s+1) (b)130.19(s2+8.22s+130.19)

Q: A three phase, 50 Hz, 8 pole alternator has a star connected winding with 120 slots and 6 conductor…

A: It is given that: f=50Hzp=8slots=120conductor per slot=6ϕpp=0.05for full pitched coil:kp=1

Q: A slide-wire potentiometer has a battery of 4 Volt and negligible internal resistance. The…

A: An sliding wire potentiometer is used to provide current to the sliding wire , the current through…

Q: A 3- ph, 4- pole, 1440 rpm, 50 Hz IM has a star connected rotor winding, having a resistance of 0.2…

A: The Principle of operation of a synchronous motor is based on the change of alternating flux which…

Q: An information signal to be transmitted digitally is a rectangular wave with a period of 70.4 μse…

A: An sampling frequency is the average number of samples obtained per second. Frequency is the inverse…

Q: Q4/ In the circuit shown R=200 2, L=10mH, C=1μF and Vs=10V A. Calculate the characteristic roots of…

Q: Find the Current Io. In figure (2). 4mA 2mA II, Ika wm 12₂ Ika Iy 2km m 4 Io lkn Is Fig.2 6V Ikr (1)…

Q: 11) I. II. III. Design the circuit with a decoder and external Gates for the following: F1 =…

Q: In the figure shown below, +1 + RLoad what is the voltage across the diode when the switch is open?

A: It is given that:

Q: 3. What is the output voltage in the circuit of Fig. 14.44? 2012 V₁= 1.5 VW 250 k V₂

A: Given data : The given circuit of inverting amplifier is,

Q: 1. The relationship between antenna efficiency and radiated power A. no relation B. Direct…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: 47. current. O a. Base. O b. Collector. c. Source. O d. Drain. O e. Emitter. nt is lowest

A: We need to select correct option for bjt current

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Magnetic field force lines created by the primary coil in transformers pass through the secondary coil and an induction current occurs in the secondary coil. What is the reason for induction current in the secondary coil?
Q1- The given ferromagnetic core relative permeability is 800. Determine the total reluctance of the core. 35 cm 10 cm 20 cm 5 cm 15 cm 45 cm 15 cm 15 cm 10 cm
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
in lab winding schemes, The-2 induced emf in a coil is emf in .coil for wave winding a) greater than b) smaller than O c) equal to O
The self inductance of a coil is a. Inversely proportional to current b. Inversely proportional to flux c. Inversely proportional to number of turns d. Directly proportional to current
circut for the core. (₁ For the ferromagnetic core shown in the gure below draw the magnetic The magnitudes of the reluctances are not important but clearly indicate on your circuit every reluctance which should be calculated for the given core. 10 15 = 0.5A d DNI 15 0.03 N2 1₂ = 0.1A 9
A magnetic ring has reluctance of 1.675 × 10⁰ AT weber. The flux to be produced by the coil is 800 x 10 webers, then the AT required for the m.m.f. will be
10. A potential difference of 250 V is applied to a field winding at 15-C and the current is 5 A. What will be the temperature of the winding when current has fallen to 3.91 A applied voltage being constant. Assume temperature coefficient at 15'C is equal to 1/254.5 per °C
For the following magnetic circuit, the flux density is 1 T and magnetic field intensity is 700 At/m. The material of the core is d C cast iron cast steel sheet steel None of the above
Determine the emf inducted in a coil that rotates its 1250 r/min. The coil has 60 windings and a length and width of 0.7 and 0.6 respectively. The pole shoe has an area and area of 0.4 meters squared and it moves through a magnetic flux of 36 mWb
Question: 01 A three-legged circular core is shown in figure below. The winding on the left leg of the core (N) has 800 turns. The depth of the core is 10 cm. If the dimensions are as shown, then determine the total reluctance of the given core when u, = 500 and constant. 15ст N=800 50ст Scm 15ст 60cm 20cm
2. Tabulate the winding table of a 4 pole 11 slots simplex wave winding double layer