A 200 Watt power of 30 MHz frequency is used to heat a resin piece of area 150 cm^2 and thickness 2 cm by dielectric heating. This piece of resin has a permittivity of 5 and a power factor of 0.05. So calculate the voltage and current required for this process. If the voltage is to be controlled at 600 V in this process, how much frequency supply has to be used?

A 200 Watt power of 30 MHz frequency is used to heat a resin piece of area 150 cm^2 and thickness 2 cm by dielectric heating. This piece of resin has a permittivity of 5 and a power factor of 0.05. So calculate the voltage and current required for this process. If the voltage is to be controlled at 600 V in this process, how much frequency supply has to be used?

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter12: Electronic Control Devices

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Similar questions

8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
We want to investigate how the field strength will be with air as dielectric and with steatite. A plate capacitor is placed in a 24 kV network between phase and ground. The relative permittivity of air is &=1 and for steatite &-6. The plate capacitor has area = 1m². The distance between the electrodes is 2 mm. Ep = 8.854-10-12 F/m A=1m² d=2mm a) Calculate the maximum field strength in the plate capacitor. (Answer: 9.8kV/mm) b) What is the capacitance of the capacitor if we use steatite? (Answer: C = 26.6nF)
This is an electrical engineering question. It belongs to microelectronics and material processes.
LVDT produces an rms output voltage of 5.0 V for displacement of 3.5 mm. Calculate the sensitivity of LVDT please explain me
1- What are the various factors which affect Dielectric Strength?
If we increase the load than core loss and copper loss will... Decrease Increase Remain same
Q5. Describe the properties of ferromagnetic materials.
Mathematical Formula How Piezoelectric Energy is Obtained
Damping ratio quettion.
this is the ability of a material to conduct electricity a. impedane b. conductance c. reactance d. capacitance
How much voltage is taken by capacitor #4 (c4)? Select one: a. 7.2 volts b. 6.36 volts c. 5.65 volts d. 4.8 volts
The Subject is Basic Electrical Engineering Chapter 15. Conductance, Susceptance and Admittance of AC Circuit.