50. WH SO 3 k
Q: Building location and soil type
A: This question is from structural dynamics.
Q: 9. A firm loans P500,000 pesos from a bank with interest at 6% compounded annually. He agrees to pay…
A:
Q: PROBLEM 2 Determine the coordinates of the centroid of the lines shown with respect to the indicated…
A: Given data in question The figure has 3 parts. 1) semi circle of radius 80 mm 2) rectangular…
Q: SITUATION 3. Draw the shear and moment diagram. Show your solution. (25pts) 8 kN 4 kN/m 4 kN-m -3 m-…
A:
Q: H.W.15: For a simply supported beam with span 10 m, determine the area of steel required to…
A: Given:- The span length of the beam = 10 m The dimension of the beam = 400×700 mm The magnitude of…
Q: H.W.15: For a simply supported beam with span 10 m, determine the area of steel required to…
A: Answer Based on the given data let us first calculate the Nominal Moment Mn Nominal Moment Mn =…
Q: Example 5.21 Design the absorption field system for the disposal of septic tank effluent for a…
A: Given data- Absorption field system for the disposal of septic tank effluent, Population P=100…
Q: Finds the bending stress and equivalent bending load due to bending of a 6 x 19 (Fiber core) wire…
A: Given data: Fiber core = 6 x 19 Wire rope dia = 1/2 in. = 0.5 in. Sheave diameter = 24 in.
Q: In the figure shown below, calculate the factor of safety against heave (Ysat 19KN/m³).
A: First we summarise the given data : γSat = 19 kN/m3 To Find : Determine the factor of safety…
Q: P 120° 14 in. 60° 3 in. 1.5 in.
A:
Q: Group A D1 = 130 mm S=0.8 D2 = 6 mm h1= 45 mm Weight of mass = 6 kg Weigh Piston D₁ 04 What is the…
A: GIVEN : D1=130 mm D2 = 6 mm h1 = 45 mm W = 6 kg S = 0.8 ρ =1000 kg/m3 To find :…
Q: A beam has a width of 200mm and a height of 250mm and is loaded as shown. 3m 28KN be de d 8m 6kN/m B…
A:
Q: Question 3 Consider a wide rigid-boundary canal with bed slope of 0.004, Manning's n = 0.18 and…
A: Given- Wide-rigid boundary canal- Bed slope S=0.004, n=0.18, Depth of flow y=0.88 m It is needed to…
Q: Identify which of the four types of shown masonry blocks shown below might be used for: A fire rated…
A: Split-face brickwork is a desirable material in commercial construction projects because it is…
Q: hich seismograph has higher amplitude shaking?
A: This question is from earthquake engineering.
Q: Q.4 The perception-reaction time for a vehicle travelling at 90 km/h, given the coefficient of…
A: Given data- Design speed of the vehicle V=90 kmph, Coefficient of longitudinal friction f=0.35,…
Q: H.W.14: For a simply supported beam with span 5.5 m, determine the area of steel required to…
A: Given Service dead load = 15.3 KN/ m Service live load = 36 KN/ m
Q: The figure shows the cross section of a channel carrying water. Determine h, b and that minimize the…
A:
Q: Many factors need to be thought through before a system is moved. Include concrete,…
A:
Q: 2) Why the Elastic Method can be used to increase the carrying load capacity of a mechanical…
A:
Q: Question Types Of Foundation Find out the critical depth at which the vertical cut made in a…
A: Given- Cohesion C=15KN/m2, Φ=0˚ Unit weight γ = 20KN/m3. It is needed to find the critical depth at…
Q: 4. Compute the slope and deflection at 3 m from the left support on the beam loaded and supported as…
A: Given: E = 200 GPa = 2 x 108 = kN/m2 I = 75 x 106 mm4 =75 x 10-6 m4 To find: The slope and…
Q: A parabolic vertical crest curve connects two road segments with grades +1.0% and -2.0%. If a 200 m…
A: Given data : G1 = +1.0 % G2 = - 2.0 % Stopping sight distance = 200 m Height of driver = 1.2 m…
Q: A simply supported beam has a length of 6 meters. If a super imposed concentric load of 50 kN was…
A: Given A Simply supported beam span of the beam = 6m Shear force at A = ?
Q: A footing has a size of 3.0 m by 1.50 m and it causes a pressure increment of 200 kN/m² at its base.…
A:
Q: Q1 A U-tube manometer is used to measure the pressure of oil of specific gravity 0.85 flowing in a…
A:
Q: Locate the centroid of the composite area and coose your own reference axes. Draw the location of…
A:
Q: Task - To determine the reaction at the supports. 2 K/ft 8' 12 k ><4' 16k ******* ******* 4' 16k 4'…
A:
Q: Differentiate the normal stress, shear stress and bearing stress.
A: Reference : Basic Mechanics, Types of stresses. To differentiate between : 1. Normal stress 2. Shear…
Q: Please check Elevation for Last point B.
A: Given- It is needed to check the elevation for Last point B.
Q: Determine the horizontal deflection at joint C of the frame given below by the virtual work method.…
A:
Q: Classify the two soils according to unified soil classification system
A: ###classification of two soilS A and B using Unified Soil Classification System ###
Q: A rectangular gate 1.2 m by 3 m is inclined 60º with the horizontal. The top of the gate is…
A:
Q: A-4.3% grade meets a 8.8% grade at a vertex (El. 141.24m) directly under an overpass bridge having…
A: Answer Let us first draw the curve using the given data Elevation of the invert on center…
Q: The coefficient of permeability of fine sand is 0.012 cm/sec at a voids ratio of 0.57. Estimate the…
A: Given : Coefficient of permeability of fine sand = 0.012 cm/sec Void ratio = 0.57 Increased void…
Q: Find intermidiate elevation
A: ###Finding Elevation of Intermediate Point C ###
Q: a. Locate the centroid of the composite area. Choose your own reference axes. b. Draw the location…
A: ## CENTROID OF COMPOSITE AREA### ##DRAW THE LOCATION OF CENTRIODAL AXES ##COMPUTE THE MOMENT OF…
Q: Explain the role of optimum moisture content in resilient modulus of soil
A: Optimum Moisture Content: The moisture content of soil is determining the amount of water which is…
Q: A soil sample has 36 g of soil solids, 14 cm³ of voids, 11 g of water and specific gravity of soil…
A: Given- 36 g of soil solids, 14 cm3 of voids, 11 g of water and specific gravity of soil grains G =…
Q: H.W.14: For a simply supported beam with span 5.5 m, determine the area of steel required to…
A: Given Span of beam = 5.5 m Width of beam = 250 mm Height of beam= 500 mm
Q: For the figure shown below, if the area of the tank is 0.5 m² and hydraulic conductivity of sand is…
A: Given : Area of tank = 0.5 m2 Hydraulic conductivity of sand is 0.1 cm/sec This is a problem of…
Q: UNSYMMETRICAL VERTICAL PARABOLIC CURVE: 1. V₁ station 12 + 200 and elevation 30m. It is required to…
A:
Q: A vibration test was conducted on the model of a tank. A cable attached to the tank induced a force…
A:
Q: 1. What is the reaction at Support A? a. 4,000 lbs b. 5,000 lbs c. 6,000 lbs 2. What is the…
A: To find : 1. reaction at A 2. force in member…
Q: Problem 3. PRINCIPLE OF VIRTUAL WORK. Determine the rotation/slope of the beam at support B using…
A: Given: A simply supported beam in which the rotation at one of the supports is required. Establish…
Q: The distributed load shown in Fig is supported by a wide-flange section of the given dimensions.…
A: A) Given Data : Allowable flexural stress = 10 MPa Allowable shearing stress = 1.0 MPa To find ;…
Q: The bending moment diagram of a beam is shown in the figure below. Construct the corresponding shear…
A: Given: Let R be the reaction at the right support and w be the udl 500 Nm. From the BMD it is well…
Q: At a point on a streamline, the velocity is 3 m/s and the radius of curvature is 9 m. If the rate of…
A: Given data- A point on a streamline- Velocity =3 m/s, Radius of curvature R=9 m, Rate of increase of…
Q: A 500 lb/ft 10 ft C B 10 ft 3 k
A:
Q: Fluid Mechanics > Turbomachinery urbs. A jet of water of 0.002 m² area moving with a velocity of 15…
A: Given data- Area A=0.002 m2, Jet Velocity V=15 m/s, Blades velocity U=6 m/s, To Find- The force F…
Prblm.
Step by step
Solved in 2 steps with 2 images
- What should be the height (m) of a lighthouse, so that it can be visible from a distance of 3km?A man's eyes 1.85 m above sea level can barely see the top of the lighthouse which is at a certain distance away from a man. a) What is the elevation of the top of the lighthouse above sea level if the lighthouse is 23 km away from the man? b) What is the height of the tower at a distance 23 km away from the man in meters that will just be visible without the line of sight approaching nearer than 1.85 m to the water?QUESTION 2 A man's eyes 1.75 m. above sea level can barely see the top of a lighthouse which is at a certain distance away from the man. How far (in km) is the lighthouse from the man if the top of the lighthouse is 14.86 m above sea level?
- A man's eyes 2.5 m above sea level can barely see the top of a lighthouse which is at a certain distance away from the man 1. What is the elevation of the top of the lighthouse in meters (m) above sea level if the lighthouse is 30 km away from the man? 2. How far is the lighthouse from the man in meters (m) if the top of the lighthouse is 25 m above sea level?What should be the height (m) of a lighthouse, so that it can be visible from a distance of 3 km? de-lk die (a) 0.101 (c) 0.673 (b) 0.605 (d) 0.707 ngA man's eyes 1.75 m. above sea level can barely see the top of a lighthouse which is at a certain distance away from the man. How far (in km) is the lighthouse from the man if the top of the lighthouse is 14.86 m above sea level?
- The top of tower at Point B is viewed at point A using an instrument with height of 150 cm above point A. Point A has an elevation of 20 m above sea level. a) What is the elevation of the top of tower at point B if it is 25 km away from the point A? b) How far is point A in meters if the top of the tower at point B is 15.945 m above sea level? c) What is the elevation of the tower at a distance 25 km away from the point A that will just be visible without the line of sight approaching nearer than 21.50 m to the water?What is the minimum height of the communication tower at point B, so that it can be observed from point A, which is located on the plane of the Earth's surface, if the distance between the two points is 100 kmA man's eyes 1.75 m above sea level can just see the top of a lighthouse. What is the elevation of the top of the lighthouse if the lighthouse is 20 km away from the man?
- A man's eyes 1.75 m above sea level can barely see the top of a lighthouse which is at a certain distance away from a man. What is the elevation of the top of the lighthouse above sea level if the lighthouse is 20km away from the man. How far is the lighthouse from the man in meters if the top of the lighthouse is 14.86 m. above sea levelLevelling 5) A person is looking to the horizon, sees a building of height 25 m. What is the least height of this building can be seen from the same position if the refraction is neglected? 6) A person is looking to a minaret which is touching the horizon when his sighting height is 1.60 m and he can see the mid of the minaret if his sighting height is 5.75 m. What is the distance from this person to the minaret? 7) Via telescope, a surveyor sees top of a tower is touching the horizon and he sees mid of the tower after moving 5000 m toward the tower, what is the height of tower? 8) A person sees a minaret is touching the horizon, what is the distance between the person and the minaret if his sighting height is 1.60 m, and he can see mid of the minaret after moving 4 km toward it. 9) What is the refraction value in case of a person of sighting height 1.65 m sees a top of building is touching the horizon, if you know the distance between him and the building is 19851 m? 10) Where the…If the distance from the instrument to the focus is 0.38m, determine the following:a) Horizontal distance between A and B.b) Difference in elevation between A and B.