3) Please don't write on a paper. I can't understand handwritten. 3. HOW MANY NUMBERS OF TURNS PER METER SHOULD BE THERE FOR THE INNER COIL WITH AN AMPERE RATING OF 6A TO CANCEL THE MAGNETIC FIELD STRENGTH OF THE OUTER COIL THAT HAS 35 TURNS PER CENTIMETER AND A CURRENT RATING OF BA?

3) Please don't write on a paper. I can't understand handwritten. 3. HOW MANY NUMBERS OF TURNS PER METER SHOULD BE THERE FOR THE INNER COIL WITH AN AMPERE RATING OF 6A TO CANCEL THE MAGNETIC FIELD STRENGTH OF THE OUTER COIL THAT HAS 35 TURNS PER CENTIMETER AND A CURRENT RATING OF BA?

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter3: Magnetic Starters

Section: Chapter Questions

Problem 17SQ

See similar textbooks

Related questions

Q: connected turbo-driven alternator

A: Three Phase Synchronous machine- This Synchronous machine comprises of rotor and stator as it basic…

Q: Acontrol system is shown in figure belows. Find K and Ke so that the damping ratio 2.0.6 and damped…

A: Given data : Damping ratio ξ=0.6 Damped natural frequency ωd=10rad/s

Q: Question 3b continued (i) Ignoring flux leakage to the surroundings, sketch an equivalent circuit…

A: X=0, Y=6. Given information, Relative permeability of the core (steel) is μr=1100+20X=1100.…

Q: 4. What will be the expected ohmic range of a resistor with a rating of 4000 Ω ± 10%? Group of…

A: Given data : Resistor rating=4000 Ω ± 10%

Q: Refer to the circuit of Figure 19-64. a. Write the nodal equations. b. Solve for the node voltages.…

Q: Applying the transformation x(t)+5 would: Select one: O shift x(t) by 5 seconds to the left O shift…

A: 1) X(t) + 5 is Shift X(t) by up 5 units . Here 5 is dc value so adding this value to existing…

Q: Determine the voltage gain of an amplifier that has an input signal of 4mA at 15mV and a…

A: In this question we need to choose a correct option

Q: Write the mesh equations for the networks in Fig. termine the current through the resistor R₁. R₁…

A: given here a network and asked to determine the current in resistor R1.

Q: 14.29 For the bandpass filter shown in Fig. P14.29, calculate the following: (a) fo; (b) Q; (c) fc1;…

A: Given A band pass filter and we need to find the cutoff frequencies and bandwidth and quality…

Q: + R ww Vg ideal 25V + V

Q: For the circuit shown, find the steady-state for v_o for i_g=2 cos(16x10^5 expression t)A. 60 Ω + Vo…

Q: Consider the digital controller defined by G(z) Realized this digital controller parallel scheme.…

Q: For a second-order system with transfer function 3 G(s) s²+2s-3' determine the DC gain;

A: Given a second order system with transfer function G(s)=(3)/(s²+2s+3) Here we have to find the dc…

Q: 17. What law allows us to solve complex circuit problems by defining a set of basic network laws and…

A: Coulomb’s Law states about electric force for charges. Snell’s Law states relationship between the…

Q: 1. Perform the required integrations to get the result in the notes [/2₁²³ [²²d²-½ * [ ²₂ ] e - fe…

Q: An inductive impedance Z₁ is connected in series with a 5 ohm resistance. When 50 V at 60 Hz is…

Q: A series R-L-C circuit is fed by a 230 V, 60 Hz ac supply. The circuit elements are R = 2 ohms, L =…

A: To find the value of C in a series RLC circuit such that total power power drawn from the supply is…

Q: 4. Design DC voltage regulator for 6V output. Given data are: Vz= 6V at Iz = 20mA, Izk = 2mA, Pzmax…

A: A DC Voltage Regulator is a tool that continues the output voltage of ordinary electricity to…

Q: .8 μm. Calculate: a. Power supply, when the power from the fiber output is 5 μW. b. SNR report that…

A: A PN silicon diode is nothing but a PN junction diode it allows the flow of current in only one…

Q: Calculate the equivalent noise temperature of a receiver with a noise figure of 1.5 dB.

Q: Consider the discrete time closed loop control system with G, (s) = . Obtain the output sequence…

A: Control System: A control system is one that regulates the output in order to get the intended…

Q: P.3. R₂ M 200 V C At t = 0, the switch is closed. The initial energy stored in the inductor and the…

Q: A _______ controller moves its output proportional to the deviation e between the controlled…

A: Here we discuss about Controller used to improve the control system performance.

Q: nd the FoL a. of the given function f(x), which is assumed to have the per f(x) = { 0, 0≤x<2

Q: 4. For the circuit shown in the figure below uses a transformer of 230V/12V-0-12V and all diodes are…

A: centre tapped Full bridge rectifier A transformer is used with centre tapped winding Two diodes…

Q: rated load. If the driving engine(Pin) is developing 30 hp, and the armature resistance is 0.05 ohm…

Q: Q6) Compute impulse response of the following system. Employ time-domain techniqu v[n] + } y[n− 1] −…

Q: The power flowing in a three-phase, three-wire balanced load system is measured by the two-wattmeter…

A: Given Data, The reading on wattmeter A =5kW The reading on wattmeter B = -1kW

Q: An RLC series circuit constructed with R-10 02, L= 2 H, C= 1 mf, for an AC source with angular…

A: Given circuit, Resistance, R=10 Ω Capacitance, C = 1 mF Inductance, L = 2 H Angular frequency,…

Q: Q2. Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. Re LOKO RB Vcc Bpc = 50 www 20…

Q: DATE: power 1 the voltage across given circuit is 75 +jsov. What is the supplied to the circuit if…

A: The power is the product of voltage and current. The maximum amplitude of voltage and current should…

Q: dy +2 +y(1) dt = dx dt + 2x (1)

A: Solution- d2ydt2+2dydt+yt=dxdt+2xtapplying L.T,S2YS+2SYS+YS=SXS+2XSInitial condtion is 0,YSS2+2S+1…

Q: Two magnetically-connected circuits have the following characteristics: • A series-opposing…

A: Transformer coils with series opposing. primary winding reactance =jXL1 = j 8 ohm secondary winding…

Q: In this function how can I convert cos to sin and put it in sin wave tool in matlab simulink

A: Simulink is used to model various systems. It is a part of MATLAB software.

Q: A capacitor of capacitance 120 µF is connected across a 220 V, 60 Hz A.C. mains. Calculate the value…

A: 22)

Q: The capacitor is initially uncharged The switch is moved to position 1 for a time of 5t The switch…

Q: What would be the resistance if a 4-band carbon resistor had the following color on it: red, green,…

A: These resistors have two bands for the resistance value, one multiplier and one tolerance band.…

Q: 18. Refer to the circuit of Figure 19-64. a. Write the nodal equations. b. Solve for the node…

A: According to nodal analysis the current at a node the sum of all incoming and outgoing currents is…

Q: A very long wire generates a magnetic field of 0.0070 x 104 T at a distance of 3.0 mm. What is the…

Q: Design Wien-bridge and ose to get sin wave F = 3000 HZ 1 signal

A: The wein bridge oscillator is a low frequency oscillator which generates sinusoidal waveform based…

Q: 110 E 101 CBA 000 100 (c) 001 011 Up/Down 010

A: State diagram is diagram used for studying the system behavior. In a state diagram the system…

Q: The net magnetic flux density of the stator of 2 pole synchronous generator is Bnet = 0.3x +0.193 y…

A: Solution is as shown below

Q: One branch A of a parallel circuit consists of a 50-uF capacitor. The other branch B consists of a…

Q: Q1/c: the passive inverter elements helps to gate O sine-wave O compensating voltage rate

A: Given A multiple choice question based on power inverter. Please find the below attachment for…

Q: Calculate the capacitance and stored energy for one dimensional change in potential using direct…

A: Vr To show all the calculation with diagram of the capacitor structure.

Q: Find the resistance and reactance of an inductive load if it draws 4 A and 600 W from a 240 v ac…

A: To find the value of resistance and reactance of an inductive load

Q: H.NO: A BJT is specified to have Tjmax = 150 c and to be Capable of dissipating maximum power as…

A: Given data, The value of Tjmax =150°C The value of Pmax = 40W when Tc = 25°C The value of Pmax = 2W…

Q: Q2.Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. Re 1.0 KM) RB www 20 KQ VBB 50

Q: Design Wien-bridge and ose to get f = 3000 HZ? Sin wave Signal

Q: SUPPLEMENTARY PROBLEMS 6.62. Find the discrete Fourier series for each of the following periodic…

A: As per the guidelines of bartleyby I need to answer first question only so kindly repost other…

Question

(3) Please don't write on a paper. I can't understand handwritten. 3. HOW MANY NUMBERS OF TURNS PER METER SHOULD BE THERE FOR THE INNER COIL WITH AN AMPERE RATING OF 6A TO CANCEL THE MAGNETIC FIELD STRENGTH OF THE OUTER COIL THAT HAS 35 TURNS PER CENTIMETER AND A CURRENT RATING OF BA?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Reluctance in a magnetic circuits corresponds to in an electric circuits. Resistance Current O Voltage Charge
Using figures (a) and (b), a magnetic flux density of 0.1 Wb in the air gap Determine the current I in the coil with 200 turns required to produce
magnetic circuits
Magnetic field Need to make an illustration (identifying the variables)
For the figure shown below if the current is moving clockwise around the coil. Which direction does the coil rotate? S O The whole coil moves down. The whole coil moves up. The right side goes down, and the left side goes up. The right side goes up, and the left side goes down.
Magnets and Magnetic Circuits
What are the two necessary conditions for a thyristor to begin conduction?and Once a thyristor begins to conduct, what condition(s) is necessary to cease conduction? Also, why is the conduction angle greater with an inductive load than with a purely resistive load?
Consider a coil as Figure 10 turns, placed in a magnetic field B= (100 x2 cos 103t) az T and R=10000 Determine the current in the circuit. The units of length are in m R -0.1 + Vemf 0.1 -0.1 B 0.1
Electromagnetism 1. A coil has 480 turns and flux in it changes from 0.24 m Wb to 1.2 m Wb in 0.24 second. Calculate the voltage induced in the coil. instructions: Solve in step by step manner as possible for future referencesPlease illustrate properly and draw the solving Make sure to write it in a clean sheet of paper to review
Look carefully at the figure and answer the following questions. For your answers choose between on the right, on the left and it is zero; there are no more options. (a) When the switch is “open” i. Where does the current flow in the battery? ii. Where is the magnetic flux going in the bar on the left? iii. Where does the magnetic flux go in the bar on the right? iv. Where does the current flow in the resistor?
4. Two current-carrying loops are arranged so that one of the loops just sits above the other just like in the figure below. The current in each loop is directed counterclockwise. Draw the resulting magnetic field for each loop to determine how the loops will "interact" with each other. 00
show thatvthis is a magnetic flux density: then prove and interpret it with reasons on each step