3- Determine the product term for the Karnaugh map in the following figure and write the minimum Sop expression SD AB 1 1 1

Q: What is the Baud rate for M-ary digitally modulated carrier if M = 8 and channel capacity= 2.7 kHz

A: It is given that: M=8fb=2.7 kHz

Q: 4. Find the branch currents. 2Ω 10V + 2Α Μ 6Ω 5Ω 4A

A: We need to find out the current for given circuit

Q: A 230 shunt motor has a nominal armature current of_60_A. If the armature resistance is 0.15 0.…

A: Given: A Shunt motor has, Terminal voltage, Vt = 230 V Armature current, Ia = 60 A Armature…

Q: plement a full subtractor using

A: The truth table of the full subtractor is

Q: When a 3.00-V battery is connected to the plates of a capacitor, it stores a charge of 15.0 µC. What…

A: Given, Source voltage, Vs=3.00 V Charge on capacitor, Q=15.0 μC

Q: (1) Choose an appropriate set of the state variables, and label them on the circuit. State variable=…

A:

Q: I al =↑ + V₂1 1092 ww V

A: The given circuit is as shown below,

Q: How It is required to find the midband gain, the upper and lower -3dB (0.707 Au) frequencies of the…

A:

Q: Find i(t) for t>0 in the circuit below Α 6Ω 1 = 0 Re 6 iol

A:

Q: onin Determine the d.c. resistance

A:

Q: A 440 V, six poles, 80 hp, 60 Hz, Y connected three phase induction motor develops its full load…

A: Given  Parameters of three phase induction motor are given.we need to determine the value of rotor…

Q: (Voc) ZL For the circuit shown in figure Find Vo.c. 12th Sketch the Circuit. 6L0⁰ (~ JTD R₁2ke R 2…

A:

Q: A continuous random variable X had a pdf shown below. Find (A) K, and (B) P{X>1).

A:

Q: Consider a system with transfer function O = 0.667, wn = 3, underdamped O = 0.222, wn = 9, undamped…

A: Given a system with transfer function, Gs=9s2+4s+9

Q: (2-9) Calculate and draw the output voltage for the circuit shown in Figure (2-74). Vi D₂ Vo f t…

A: We need to find out the output voltage for given circuit

Q: A 3-phase star connected balanced load is supplied from a 3 phase, 410 V supply. The line current is…

A:

Q: 3. List TWO differences between charging an object by contact and charging an object by friction.

A: Given  We need to give differences between charging by conduction and friction. Please find the…

Q: A 15.0-V battery is connected to a 3.00-µF capacitor. How much energy is stored in the capacitor?…

A:

Q: Consider the following circuit. What is the value of current I in the circuit shown? (a) I A (b) 2 A…

A: Given,

Q: 01:- electrical heater (500w) (250V) calculate the current will draw by the heater and its…

A: By using the below formulas we can do the given sum. P = VI and  P = IxIxR  Where I = current…

Q: 6. Find the overall impulse response of the system below, where h(t) = 2u(t – 3), h₂ (t) = 3etu(-t),…

A:

Q: 2- Implement 1 x 8 De-multiplexer using only 2 of 1 x 4 De-multiplexer 3- 1- ement &

A: The demultiplexer takes one input and generates 2^n output lines based on the number of select…

Q: Q1/Fill in the following blanks and explain the solution steps in d 2-Approximately in a pure…

A: There are two types of charge carriers in a semiconductor these are holes and electrons whereas in a…

Q: Q2: find Z equivalent if the frequency is 50: R3 R2 R1 552 792 30Ω 3mF Zeq :4mF 1. Add File 2H

A:

Q: Determine the nodal voltages for the networks of Fig. 6 Ω · 8 Ω 1₂ = 6A/90° 5- 4031₁4A20⁰ ell 50 202…

A: we know thata+ib=a2+b2∠tan-1bar1∠θ1r2∠θ2=r1r2∠θ1-θ2

Q: 2. Find the branch currents. 20V. ই + 122 2025 40V 10V 2525 www 42

A:

Q: 3) Find Vo(t) for t >0 in the circuit below 1 = 0 12 ΜΑ κατά R ΣΟΚΩ 100 με Re σκΩΣυ(t)

A:

Q: Q2 (a) A 440 V, six poles, 80 hp, 60 Hz, Y connected three phase induction motor develops its full…

A: Given  A question on three phase induction motor.we need to solve for rotor resistance. Please find…

Q: generation of impulse high voltage.      1.theory fundamental.   2.Experimental setup- circuit.…

A: Impulse high voltage  1. Fundamental Theory In electronics, surgery is the most important and a…

Q: Subject:Electronics Engineering How JFET has been constructed? Explain the principle of operation…

A:

Q: 2. Using the Norton's Theorem, calculate the following: a) voltage drop across R₂; and b) current…

A: We need to find out the current and voltage for given circuit

Q: The operating frequency for UHF RFID is

A: For Ultra High Frequency (UHF) band ,  frequency range from 300 MHz to 1 GHz. RFID systems that are…

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt R3 R2…

A:

Q: A single-phase half--bridge inverter is connected to a 600V d.c. source. A series connected R-L load…

A: The Given data is, Single-phase half bridge inverter is connected to a 600V dc. R-L load is R=60…

Q: Q14- If f(x,y) = 2xy - x² In y- 2y² + 3x + 4, is : then a²f axy for the function

A: 14) To find d2f/dxy for the function f(x,y)  First, differentiate f w.r.t any one variable assuming…

Q: Find the Laplace transformation of the following functions: 3. f(t) = sin (t)cos (t) + 2cosh (3t)

A:

Q: Q2: find Z equivalent if the frequency is 50:

A: It is given that:

Q: Q3: A 20-KVA transformer has a maximum efficiency of 98 percent when delivering three- fourth…

A:

Q: If a signal bandwidth is 1 MHz and the channel signal-to-noise ratio is 30 dB, what is the Shannon…

A: given questions about signal to noise ratio.

Q: A 15.0-V battery is connected to a 3.00-µF capacitor. How much energy is stored in the capacitor?…

A: Given data, Capacitance, C=3.00 μF Supply, V=15.0 Volt

Q: The terminal voltage of a 3-φ generator is 19053 V, line-to-line. The load draws a current of 2727…

A:

Q: Z Look at the graph in figure 4 and complete the gaps in the text with a preposition from the box.…

A: Given  Fill in the blanks using the preposition table given. Please find the below attachment.

Q: 3. What are the differences between DFT and IDFT? 4. What are the differences between DFT and DTFT?

A:

Q: Q4: find the current in 4mf capacitance if the source value is 4 sin(100t) Amp: R3 R2 5.52 792 4mF…

A:

Q: Q2: find Z equivalent if the frequency is 50 R1 R3 R2 ww 702 3022 552 Zeq 4mF 2H HH 3

A: In this question we will find equivalent impedance of given circuit.....

Q: The operating frequency for UHF RFID is 135 kHz O 2.4 GHz O 13 MHz O 900 MHz O

A:

Q: Find the magnitude of the current density J if o = 50 M S/m, the voltage is 5 volt, the current is 2…

A: Given, The magnitude of the current density, J=? Conductivity, σ=50 MSm Voltage, V = 5 V Current, I…

Q: Q2. Find the exponential Fourier series for f(t) = {1 Fourier series. 0 < t < 1 1 < t < 2 then find…

A:

Q: 3- The silicon ratio in transformer iron cannot be increased greater than 5% because of a) the iron…

A:

Q: dVin 1. Design an opamp circuit to have the following output Vo = 2-4 dt 2. Design a OP-Amp circuit…

A: To Design an op-amp circuit of the output Vo=2-4dVindt To Design a OP-Amp circuit of the output…