2) A Cu wire carries a current I = 1.0 MAmp. Calculate the number of electrons per second that pass by any given point in the wire, per unit time. Show your work, and choose from the best answer below. A) dn/dt = 1.6 x 10 30 electrons/sec B) dn/dt = 0.625 x 10' 10'3 electrons/sec C) dn/dt = 3.75 x 106 electrons/sec D) dn/dt = 6.25 x 10 electrons/sec %3D

2) A Cu wire carries a current I = 1.0 MAmp. Calculate the number of electrons per second that pass by any given point in the wire, per unit time. Show your work, and choose from the best answer below. A) dn/dt = 1.6 x 10 30 electrons/sec B) dn/dt = 0.625 x 10' 10'3 electrons/sec C) dn/dt = 3.75 x 106 electrons/sec D) dn/dt = 6.25 x 10 electrons/sec %3D

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 15P: Use the orders of magnitude you found in the previous problem to answer the following questions to...

See similar textbooks

Similar questions

Directions: Solve the given problems. Show your complete solutions.Round off your answers into the proper number of significant figures.1. A silver wire 2.5 mm in diameter transfers a charge of 370 C in 70 minutes.Silver is made up of 5.8 x 1028 free electrons per cubic meter.a. Find the current in the wire.b. What is the magnitude of the drift velocity of the electrons in the wire?
Please fill out the template below with the work for this problem. Note that you need to have a picture, a list of knowns and unknowns, the general equation/s you will use, and the math steps to solve for the unknown, only plug in the numbers after you have solved for the unknown, and the answer with units included. Question 1: A current of 2.72 A flows through a wire. How many electrons flow past a particular point in the wire every 15 seconds?
Directions: Solve for the given problems. Show your complete solutions.Round off your answers into the proper number of significant figures.1. Copper has 8.5 x 1028 free electrons per cubic meter. A 75.0-cm length ofcopper wire with a diameter of 2.05 mm, carries 4.97 A of current.a. How much time does it take for an electron to travel the length of thewire?b. Repeat (a) for a wire with a diameter of 4.12 mm of the same length thatcarries the same current.c. How does changing the diameter of the wire affect the drift velocity ofthe electrons in the wire?
Direction: Answer the following questions below and box or highlight your final answer. Always write down the givens and convert into its SI unit if necessary. 4. A parallel plate capacitor has a capacitance of 349 nF, and a potential difference of 56 V between the plates. The charging battery is disconnected and a paraffin slab (k = 2.2) is inserted between the plates. (a) What is the potential energy of the device before and after the insertion of the slab? (b) What is the potential energy of the device before and after, if the inserted slab is a porcelain slab (k = 6)?
Activity 2 Directions: Solve for the given problems. Show your complete solutions. Express your final answers into 3 significant figures. 1. Silver is composed of 5.8 x 1028 free electrons per cubic meter. If a silver wire with a diameter of 1.8 mm can allow charges of 360 C to flow in 1 hour, a. What is the current in the conducting wire? b. What is the magnitude of the drift velocity of the electrons in the conducting wire? 2. A wire has a radius of 1.90 mm. If the current in the wire is 6.14 A, the drift velocity is 4.86 x 10-5 m/s. What is the concentration of free electrons in the metal?
Check your understanding A. Solve the problems below. You are required to show the proper solution with the final answer written inside a box. Make sure to put the final unit of measurement. 1. If in the process of rubbing the lenses of the eyeglasses, 6.28 x 10 10 electrons were transferred, a. what is the charge of the lenses and the nylon cloth? b. what is the change in their masses? CS Scanned with CamScanner
A proton beam that carries a total current of 3.09m.A has 3.78mm diameter. The current density in the proton beam increases linearly with distance from the center. This is expressed mathematically as J）=1元， where R is the radius of the beam and Jo is the current density at the edge of the beam. Determine the value of Jo (in A/m?). Show all work and look at correct answer
Answer the following. Write your solution and box your final answer on each question. 1. What charge flows past a point in a wire in 6.0 s if the wire carries a current of 2.0 A? 2. If a circuit element can withstand a maximum current of 15 A, how many electrons can pass through it each second?3. How many electrons are transferred in a 10.0 A current that runs for 3.0 s?4. If 2.00 × 102mA of current flows through the filament of a light bulb, how many electrons would pass through the filament in 30.0 s?5. What feature of a river is most similar to current in an electric circuit? (A) The depth of the river measured in meters (B) The temperature of the water measured in degrees Celsius (C) The vertical drop between two points along the river measured in meters (D) The volume of water moving past a point measured in liters per second
Directions: Solve for the given problems. Show your complete solutions.Round off your answers into the proper number of significant figures.2. The current in the wire varies with time according to the relation I = 55 A –(0.65 A/s^2)t^2.a. How many coulombs of charge pass a cross-section of the wire in thetime interval between t = 0 and t = 8.0 s?b. What constant current would transport the same charge in the same time interval?Note: In problem 2, A means ampere, s means second.
Directions: Solve for the given problems. Show your complete solutions.Round off your answers into the proper number of significant figures.2. A metallic wire has a diameter of 3.80 mm. When the current in the wire is7.20 A, the drift velocity is 4.86 x 10-5 m/s. What is the density of the freeelectrons in the metal?
decide if the given statement is true or false,and give a brief justiﬁcation for your answer.If true, you can quote a relevant deﬁnition or theorem . If false,provide an example,illustration,or brief explanation of why the statement is false.Q. If R = 4 OHM, L = 4 H, and C = 1 \17 F, then the RLC is underdamped.
Use the orders of magnitude you found in the previous problem to answer the following questions to within an order of magnitude. (a) How many electrons would it take to equal the mass of a proton? (b) How many Earths would it take to equal the mass of the Sun? (c) How many Earth-Moon distances would it take to cover the distance from Earth to the Sun? (d) How many Moon atmospheres would it take to equal the mass of Earth’s atmosphere? (e) How many moons would it take to equal the mass of Earth? (f) How many protons would it take to equal the mass of the Sun? For the remaining questions, you need to use Figure 1.4 to obtain the necessary orders of magnitude of lengths, masses, and times.