15-121. The gauge pressure of water at C is 40 lb/in². Ifwater flows out of the pipe at A and B with velocitiesvA = 12 ft/s and vB = 25 ft/s, determine the horizontaland vertical components of force exerted on the elbownecessary to hold the pipe assembly in equilibrium. Neglectthe weight of water within the pipe and the weight of thepipe. The pipe has a diameter of 0.75 in. at C, and at A and Bthe diameter is 0.5 in. y, = 62.4 lb/ftť.VA = 12 ft/sVs = 25 ft/s

Given: The velocity of water at point A is vA=12 ft/s. The velocity of water at point B is vB=25…

Answered: 15-121. The gauge pressure of water at…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

15-129. The water flow enters below the hydrant at C at the rate of 0.75 m³/s. It is then divided equally between the two outlets at A and B. If the gauge pressure at Cis 300 kPa, determine the horizontal and vertical force reactions and the moment reaction on the fixed support at C.The diameter of the two outlets at A and B is 75 mm, and the diameter of the inlet pipe at C is 150 mm. The density of water is Pw = 1000 kg/m³. Neglect the mass of the contained water and the hydrant. |250 mm 30°f 650 mm 600 mm
6-10. Water flows through the elbow with a velocity of 18 ft/s. Determine the horizontal and vertical components of force the support at C exerts on the elbow. The pressure within the pipe at A and B is 28 psi. The flow occurs in the horizontal plane. Assume there is no support at A and B. 18 ft/s 4 in. 4 in. 60 130
*5-12. The jet airplane is flying in still air, A, at an altitude of 4 km. If the air flows past point C near the wing at 90 m/s, measured relative to the plane, determine the difference in pressure between the air near the leading edge B of the wing and point C.
6-27. Air flows through the closed duct with a uniform velocity of 0.3 m/s. Determine the horizontal force F that the strap must exert on the duct to hold it in place. Neglect any force at A due to a slip joint. Take p, = 1.22 kg/m'. A 0.3 m/s 3 m 2 m 1m
*6-16. The steady jet of water flows from the 100-mm- diameter pipe at 4 m/s. If it strikes the fixed vane and is deflected in the vertical plane as shown, determine the volumetric flow towards A and towards B if the tangen- tial component of the force that the water ex- erts on the vane is zero. A 45° 100 mm C 4 m/s В
4-14. The liquid in the rectangular channel has a velocity profile defined by u = (3y1/2) m/s, where y is in meters. Determine the av- erage velocity of the liquid. The channel has a width of 2 m.
*5-8. Water flows through the 30-mm-diame- ter pipe at 0.002 m3/s and is ejected from the 10-mm-diameter nozzle at B. Determine the velocity and pressure of the water at point A. 5-9. Water flows through the 30-mm-diame- ter pipe and is ejected with a velocity of 25 m/s at B from the 10-mm- diameter nozzle. Determine the pressure and the velocity of the water at A. |B 300 mm
Given the velocity through the exhaust of the rocket is: U(r) = Umax (1-1) 1¹/² R Umax is a constant r is the radial coordinate out from the center of the engine R is the outside radius of exhaust flow Determine the reaction force of the exhaust in terms of: p, Umax, and R
Water flows through the 40-mm-diameter pipe assembly such that the velocity at A is 6 m/s and the pressure is 200 kPa The assembly and the water within it have a mass of 54 kg Assume that the flow is steady and the water can be considered as an ideal fluid. 40 mm 6 m/s 2 m Part A Determine the z component of force exerted at the support C, assuming there is no support resistance at A and B. Express your answer to three significant figures and include the appropriate units.
15-117. The nozzle discharges water at a constant rate of 2 ft/s. The cross-sectional area of the nozzle at A is 4 in?, and at B the cross-sectional area is 12 in?. If the static gauge pressure due to the water at B is 2 lb/in², determine the magnitude of force which must be applied by the coupling at B to hold the nozzle in place. Neglect the weight of the nozzle and the water within it. y, = 62.4 lb/ft³. -B
6-7. Water flows through the hose with a velocity of 4 m/s. Determine the force that the water exerts on the wall. Assume the water does not splash back off the wall. 100 mm 4 m/s
The winding drum D is drawing in the cable at an accelerated rate of 4.5 m/s^2. Determine the cable tension if the suspended crate has a mass of 1000 kg.

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS