Q4/ How much heat is required to raise the temperature of 30 Kg air in the room from 5c'to 20c'when a heater is used to heat this room ,under this conditions the specific heat capacity of air=1000 J/Kg.K

Q4/ How much heat is required to raise the temperature of 30 Kg air in the room from 5c'to 20c'when a heater is used to heat this room ,under this conditions the specific heat capacity of air=1000 J/Kg.K

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter1: Heat, Temperature, And Pressure

Section: Chapter Questions

Problem 6RQ: One British thermal unit will raise the temperature of _____ 1b of water _____F.

See similar textbooks

Related questions

Q: Q1: the pressure at point A is 172 pa. All fluids are at 20°C. The air pressure in the closed…

A: Let the air pressure in chamber B be PB and pressure at A is given as PA=172 Pa. Assuming water as…

Q: A- A grown man holds two metal balls with 5kg of mass in his both hands in one level. He started…

Q: Q.6.B. Four g of air is contained in the cylinder. The air is heated until the piston raises 30 mm.…

A: This question is related to the first law of thermodynamics for the closed system. In this question…

Q: Jose is cooking sopas (chicken noodle soup) for Noche Buena. He finished early in the afternoon and…

Q: E.x/ Consider the system shown in figure. The initial volume inside the cylinder is 0.1 m^3. At this…

Q: 300 kJ of heat flow by conduction from the outside to the inside cold storage in one hour. If the…

A: As per question, Heat flow by conduction from outside to the inside in one hour is 300KJ. Heat…

Q: t-lb 7. One pound of air R = 53.3 is compressed isothermally in a closed system from 15 psia and…

Q: takes 675 J of work to compress quasi- culate the temperature

A: we have to determine the temperature of a isothermal system undergoing compression

Q: 5. In - -, all the properties of the system except the temperature vary as moving from one state to…

A: As per our guidelines, we are supposed to answer only first one question in case of multiple…

Q: The pressure of the high altitude chamber is 40 m³. It is put into operation by reducing pressure…

A: Given data: The volume of the chamber, v = 40 m3. The initial pressure, P1 = 1 bar. The final…

Q: There is a balloon in which the pressure due to the restoring force of the rubber is proportional to…

Q: During a process, the temperature of the system rises from 100°C to 200°C. Hent transfer per degree…

A: Given that, T1=100°C=100+273=373 KT2=200°C=200+273=473 KδQδT=1.005 kJ/K…

Q: A 1 hp stirring motor is supplied to a tank containing 22.7 kg of air. The stirring action is…

A: Given data: The power of motor is P=1 hp=746 Watt=0.746 kW. The mass of the air in the tank is…

Q: The warmest temperature ever measured in the United States is 134 °F on July 10, 1913, in Death…

A: Given: The temperature measured in the United States is T1=134 °F

Q: The specific internal energy of water at 10 psia and 220 °F is Btu/lbm. Numeric Response

A: Given: To determine specific internal energy of water.

Q: In the Joule-Gay Lussac's experiment, two vessels connected by a closed valve are submerged in a…

Q: H4: A body at a temperature of 50° F is placed outdoors where the temperature is 100° F. If after 5…

Q: 1. A cylindrical tank, 3 m long and 2 m in diameter is used for oil storage. How many days can the…

Q: A closed rigid tank has a capacity of 2.5 m3. It holds air at 400 kPa and 18 deg C. Heat is added…

A: Given:1. V1=2.5 m3P1=400 KPaT1=18°CT2=350°C2. Pvaccum=165 mm HgPatm=745 mm Hg3. mf=4500 Kg/hx=0.80

Q: It is said that independent temperatures are held at 273 K in a volume of 11.35 dm3, and its…

A: as per guideline i have to solve only three subpart of your question

Q: 2.5 liters of water at 60 degree Celsius is placed in a freezer. What amount of mass in kilograms…

A: Specific heat is a heat by the virtue of temperature difference and its expression is given by:-…

Q: 1- Give an example for a-an open system, b) closed system, c)An isolated system

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: A tank of 10ft3 capacity is half filled with glycerin. The weight density of glycerin is 78.6…

A: Volume of tank fully filled with glycerin,V=10ft3Weight density of glycerin=78.6lbsft3So,weight of…

Q: 1. A gas has an internal energy of 215 KJ/Kg. It had a velocity of 100 m/s and an elevation above…

Q: EXAMPLE 3–3 Volume and Energy Change during Evaporation XAMPLE 3-3 Volume and Energy Change during…

Q: A solid brass sphere is initially surrounded by air, and the air pressure exerted on it is 1.00 x…

A: Bulk modulus of brass = 6.1 × 1010 N / m2 pressure difference = final pressure - initial pressure…

Q: Jose is cooking sopas (chicken noodle soup) for Noche Buena. He finished early in the afternoon and…

Q: A body at an unknown temperature is placed in a room held at a constant temperature of 10 °C. If…

A: This numerical is related to the subject heat transfer And key concept is Newton's law of cooling…

Q: A 10 gallons of water has an inital temperature of 25 degrees Celsius. What is the input power…

A: Given data volume of water (V) = 10 gallons = 10*0.003785 m3…

Q: A piston-cylinder assembly shown below is initially containing 2g of air at STP. Heat is then added…

Q: Please check attach file

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: 1. The discharge flowing down the pipe is 0.03 m³/s and the pressure at 2 is 0.14 kg/cm² greater…

Q: Saturated steam is cooled at constant pressure (40 kPa) to a saturated liquid. Calculate the heat…

A: Given Data State 1:40 kPa, saturated vapor State 2:40 kPa, saturated liquid

Q: The pressure of the high altitude chamber is 40 m³. It is put into operation by reducing pressure…

A: Given data: The volume of the chamber, V = 40 m3. Initial pressure, P1 = 1 bar. Final pressure, P2…

Q: The work done when a gas is expanded to a cylinder is -199 J. A heat transfer of 270 J occurs from…

A: work done by gas, δW=-199 JδQ=270 J

Q: During the process of raising steam in a boiler, when the pressure was 1.9 bar gauge the temperature…

Q: 7. One pound of air R = 53.3- 15 psia and 80°F to 90 psia. Compute the heat transfer. ft-lb is…

A: The heat transfer in this isothermal process is -66.25 BTU.

Q: An evaporative cooling tower (see the figure below) is used to cool water from 107 to 75 °F. Water…

A: Given Data Water flow rate, m1=275000 lbm/hr dry air flow rate, m3=145000 lbm/hr wet air flow rate,…

Q: Determine heat added. Provide your answer in foot-pound-force. Answer in whole numbers; no commas,…

Q: 3.) A 1 hp stirring motor is supplied to a tank containing 22.7 kg of air. The stirring action is…

Q: A 5-kg piston in a cylinder with a diameter of 100 mm is loaded with a linear spring and the outside…

Q: Ex 3-7: A cylinder contains 1 kg of a certain fluid at an initial pressure of 20 bar. The fluid is…

Q: 1. A gas has an internal energy of 215 KJ/Kg. It had a velocity of 100 m/s and an elevation above…

Question

Q4/ How much heat is required to raise the temperature of 30 Kg air in the room
from 5c'to 20c'when a heater is used to heat this room ,under this conditions the
specific heat capacity of air=1000 J/Kg.K

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Half a liter of liquid is being heated in a closed container to prepare food. Initial temp is 25C and desired temperature is 85C. How much energy is needed to raise the temperature of this amount of water as described? Specific heat of water is given as 4.18 kJ/(kg.K)
Q1: If a calorimeter is not assumed to be adiabatic, how would one calculate the heat transfer? Guide Questions: What are the parameters to be considered and the equations to be used? What law of thermodynamics does this transfer of heat to the surroundings touch? Is an adiabatic system automatically considered as a closed system? Please help me understand by also attaching a reference/book/journal article. This would help me in my essay. Thank you.
The two following 2 energy level systems (E; = 0 & E; = 1) are brought into thermal contact: System A: 8 distinguishable particles; UA = 4 System B: 4 distinguishable particles; UB = 1 If a single unit of energy transfers from System A to System B, what is the final Wtot for the combined system?
Heat transfer by conductivity: One side of a 3 cm thick copper plate is held at 400°C and the other at 100°C. How much head transferred through the plate?
Consider that the tropical ocean is exposed to direct sunlight for many hours every day. If the top 1cm of an area of water 10,000,000 cm by 10,000,000 cm warms from 25 to 27 degrees, how much heat energy, in Joules, has the water absorbed? (Every cm' of water has one gram of mass.) Remember the specific heat of water is 4.18 J/g°C
Volume 0.05 m3 while the piston is attached with the pinin a cylinder with 200 kPa pressure and 300 Kthe temperature is. As a result of heat transfer from the environment, the pressure is 0.4 MPa, the pin breaks, and when the system becomes thermodynamically balanced, its volume is 0.1 m3. Area of piston 0.05 m2, piston and masses on 150 kg and atmospheric pressure102 is KPA. a)Find the temperature at the moment the pin breaks. b)Calculate the pressure and temperature after the pin breaks and reaches the equilibrium position.
A particular frost-free refrigerator uses about 745 kWh of electrical energy per year. Express this amount of energy in unit cal.
3. According to Newton's cooling law, the rate of cooling of a hot body is pro- portional to the difference between the temperatures of the hot body and the environment. If the room temperature is 35°C and the temperature of a hot body in the room cools down to 55°C from 105°C Celsius in just 6 minutes, then how many more minutes will it take to cool down to 45°C?
Air treated as an ideal gas and having a specific heat at constant volume Cv=1200 J/kg.K undergoes a process. During this process, heat is observed to exit the system with an amount of 10 kJ while work is provided to the system with an amount of 28 kJ. If the initial temperature of air was 20 C, what is the final temperature of air if the mass of air undergoing the process is 0.7 Kg. Select one: O a. 35.5 C O b. 52.4 C c. 41.4 C O d. 29.5 C
Latent heat of fusion is the heat given up as a substance freezes. The latentheat of fusion for water is 144 British thermal units per pound (Btu/lb). Thismeans that 144 Btu are given up for each pound of water that freezes. Howmany British thermal units of heat are given up when 4,000 pounds of waterfreeze?
H.W1: Warm air is contained in a piston-cylinder assembly oriented horizontally as shown in Figure below. The air cools slowly from an initial volume of 0.003 m to a final volume of 0.002 m'. During the process, the spring exerts a force that varies linearly from an initial value of 900 N to a final value of zero. The atmospheric pressure is 100 kPa, and the area of the piston face is 0.018 m. Friction between the piston and the cylinder wall can be neglected. For the air, determine the initial and final pressures, in kPa, and the work, in kJ. A = 0.018 m2 Patm = 100 kPa Air Spring force varies linearly from 900 N when V = 0.003 m³ to zero when V, = 0.002 m³
1. What is the mass of the air inside the classroom, which is 15m * 8m * 1.5m? The classroom conditions are 25℃. Find the mass of air inside (kg) at a pressure of 1 bar Compare the weight of the air in the classroom with the weight of a person.