In the circuit shown, determine the equivalent resistance, total current and power in each resistor if the supply voltage between terminals A and B is 440 Volts.

Q: A wide sense stationary process X(t) is passed through a linear time-invariant filter with mpulse re...

A: Given function

Q: eektir. Sorulara geri 11 / 20 L-'{Y(s)} = y(t) olsun. t = 0 anında bir sabit katsayılı lineer difera...

A: Note:We are authorized to answer one question at a time, since you have not mentioned which question...

Q: R 300 30Ω 135V I In order for the power consumed in the circuit in the figure to be 405 W, the value...

A: Given circuit: Power consumed in the circuit is 405 W.  

Q: 2- When the BIU is free to read next instruction code?

A: The bus interface unit provide the interface between the external memory unit and the input output d...

Q: determine the local oscillator and image frequencies for an AM broadcast signal with an IF= 455KHz a...

A: We need to find out local oscillator frequency and image frequency .

Q: a MOSFET?

A: NOTE- “Since you have asked multiple questions, we will solve the first question for you. If you wan...

Q: Identify whether the following are linear and time-invariant. Show proofs. 1.) y(t)=x(3t+2)

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: D1 R1 R2 DIODE R3 E

A:

Q: if IL(0)=-5, IL(0)=4,7=2.5, then IL after 4 sec equals to O 2.431 O 3.1829 O 5.361 O 1.095

A: Given data: iL∞=-5iL0=4τ=2.5t=4 sec  

Q: A 4-bit pulse code modulation (PCM) modulator is used with a 0-2V signal. How many quantization leve...

A: Answer: g. 16   The number of quantization levels = 2n , where n is the number of bits. so number of...

Q: 3. a. Implement the following function using NAND gates with a fan in of 2. F= (ab + d')(ac + b) + (...

A: As per guidelines we are supposed to answer only first question when multiple questions are given so...

Q: Given DC voltage and AC sinewave voltage in series, what would be the total power delivered to a 50o...

A:

Q: A star-connected balanced load takes 75 A from a balanced 3-phase, 4-wire supply. If the two supply ...

A:

Q: 2. Find V, and V, when Vm = 20 V and f= 50 Hz. 50 N 10 N V, cos wt 200 N- 0.01 μF| - +

A:

Q: When terminating solid copper conductors to a screw terminal of a toggle switch, the conductor must ...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: polar coordinates are used mostly for drawing

A: 1)ANSWER IS ANGULAR LINES WE USE POLAR COORDINATES FOR ANGULAR LINES IN AUTOCAD FOR ELLIPSE AND CIRC...

Q: 1.2k E-5 10V Si Vo= Current across diode=

A:

Q: The Bode plot of the control system is shown in Fig.2. Find the: i- gain margin, ii-phase margin iii...

A: For a control system -  The bode plot is shown below,

Q: 7-7 In a step-up converter, consider all components to be ideal. Let V be 8-16 V, V, = 24 V (regulat...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: a) Briefly summarise with explanation the difference between discrete & continuous time signal and a...

A: a) The differences between the discrete & continuous-time signal is explained in the table shown...

Q: What will happen if the DC voltage in the clamping circuit is replaced by an AC source?

A: A clamper circuit converts an AC signal to a DC signal. In fact, clamping circuits can be used to se...

Q: Given the nMOS inverter circuit as shown below: 3.3 V M1 2 V V. M2 The W/L ratio for M¡ is twice tha...

A:

Q: 7-8 In a step-up converter, Va = 12 V, V, = 24 V, 1, = 0.5 A, L = 150 µH, C = 470 µF, and f, 20 kHz....

A: Since you have asked multiple questions, we will solve the first question for you. If you want any s...

Q: Find the poles and zeroes of the functions and mark these on the s-plane. K(s + 2)(s + 10) G(s) s(s ...

A:

Q: dy d d'x d²x d² :+y=本 +5+ +&x + &r dt

A:

Q: R2 R3 R4 R1 ni ni

A: Given circuit

Q: 15 V if the switch in the figure is closed the ammeter reading wi indicate

A:

Q: This is a photo of a capacitor that corrects the power factor in an AC setup, in DC it is used in el...

A: Capacitor: It is an element used to store electrical energy in the electrical field. A capacitor is ...

Q: Determine the differential equations of the given system diagram below

A: In this question,   Determine the differential equations of the given system.  We know  Voltage acro...

Q: R R1 R2 C A R R R4 Ra Vo Vi R D B-

A:

Q: 7. The voltage generated across one inductor of a 3Ø alternator is 6 volts. There are 120 slots and ...

A: q=slot per pole per phase=SP×3=1203×10=4 g=slotpole=12010=12 Υ=180°g Υ=18012=15°  

Q: Drive Heat equation in polar form also verify with counter example?

A: Heat equation-   Engineering, fluid mechanics, atmospheric science, climate physics, weather forecas...

Q: . . I won't be late L.. is promising promised promise was promising ООО

A: The answer for the above question is  Option C is correct. I promise I won't be late.    

Q: Show that over the length of one transposition cycle of a power line, the total flux linkages of a n...

A:

Q: Q-6) Find the total steady-state error due to a unit step disturbance in the system D(s) R(s) 5 10 C...

A: Given block diagram of the control system shown       

Q: A 15V battery is in series with a 13 ohms resistor, an open switch, and a 220mH inductor. How much c...

A: Given,A battery is connected in series with a resistor, an open switch, and a inductor.where,V=15VR=...

Q: 5. Calculate the output voltage of a non-inverting amplifier for values of V, = 5v, Rf = 370kn, and ...

A:

Q: 1. Find iot). 10 2 ww 20 sin (10r–) V 1H E 4 cos (10r–4) A 0.02 F elll

A:

Q: Question #1 3. j0.05 pu j0.1 pu Of 92=0.5 pu +P2=1 pu Fig. 1 A) For the radial system shown in Fig. ...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: In what year was 3D printing first developed?

A: The answer for the above question is mid 1980's. And the exact year is around 1983 . And the first p...

Q: 4. The voltage difference between the two terminals of the series equivalent resistance? 5. The powe...

A: We are authorized to answer only three subparts at a time since you have not mentioned which questio...

Q: What is the value of VR2 in the circuit? R1 = 5 0, R2 = 5 Q and R3 = 60 R, R3 R2 VR2 30 V 60 V

A: Given, R1=5 ΩR2=5 ΩR3=6 Ω  

Q: Three types of electric devices A, B, and C are connected in series across a 115-volt a-c source, an...

A: GivenEA=EB=EC=E∠EB=∠EA+90°∠EC=∠EA-90°

Q: find transfer function for this block diagram G4 G5 R(S C(S G2 G3 H1 H2 H3

A: This is a basic problem of finding transfer function The solution is given below

Q: A uniform electric field with strength (E), was applied on a uniform conductor wire with length (L) ...

A:

Q: A two ends of an electromotive force source were connected with a resistance its value is (5 2) and ...

A: In this question,  Resistance R = 5 ohm is connected to electro motive force source with ammeter. Em...

Q: A load of 1500 KW is connected at the receiving end of a 3 phase transmission line 70 km long. The p...

A:

Q: Ge 2k 13V Si 10k Vo=

A:

Q: Calculate the voltage across resistor R=927 ohm with E=12V

A:

Q: An impedance coil, in series with a resistor takes a current of 5 A when binected to a 100-V AC sour...

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.