Explain the operation of a 2 x 4 line decoder with enable and active low output.
Q: A bit word 1010 is transmitted . construct the even party 7-bit hamming code for this data?If at…
A: hamming code is a error correcting code. it can detect an error and correct it. 1. even parity for…
Q: Implement the below given function using 3-to-8 Binary Decoder with only NAND gates. f(w1,w2,w3) =…
A:
Q: 1. Construct (4x 16) decoder from (3x8) decoder?
A: A decoder is logical combination circuit that convert n coded input into 2n unique outputs.
Q: and 1, we assume that, for a given binary channel, 30% of the time a 1 is transmitted; the obability…
A:
Q: QA: what is Encoders and Decoders
A: The explanation is as follows.
Q: What is the processing gain in a DSSS system with a 1.5-MHz channel and a data rate of 20 kbps?
A: In Direct sequence spread spectrum the pseudorandom code which occurs at fast rate can increases the…
Q: b) What is the purpose (jll ) of the parity bit during data transmission?
A: According to the question we have to discuss the purpose of the parity bit during the data…
Q: 3. What converts binary numbers to decimal numbers? 1. BCD to 7-segment Decoder 2. Encoder 3.…
A: BCD to 7-segment Decoder converts binary numbers into decimal numbers.
Q: If the sequence "101010." is transmitted using Differential Manchester encoding, what is the ratio…
A:
Q: - Design a 3x8 decoder by using 2x4 decoder? - Design a 4x16 decoder by using 3x8 decoder?
A: To construct 3x8 decoder two 2x4 decoder and a not gate is used. And for 4x16 decoder two 3x8…
Q: 2- Draw the logical diagram of a 2 line to 4 line decoder using NOR 1- Draw the circuit for 3 to 8…
A: Demultiplexer is many to one logic circuit. It is also known as distributor or serial to parallel…
Q: If a binary sequence of 100000001 is digitally encoded. Which line encoding format will most likely…
A: If a binary sequence of 100000001 is digitally encoded, the line coding format having…
Q: For 2048-point sequence FFT with signal to noise ratio of 30 dB, how many numbers of bits required…
A: We need to calculate number of bits .
Q: Voice is digitized using an ADC with a sampling period of 0-1 millisecond and 10 bits/sample. What…
A: Given, Voice is digitized using an ADC with Sampling period, Ts=0.1 millisecond Number of…
Q: Design an 8-to-1-line multiplexer using a 3-to-8 line decoder and external gates
A: A multiplexer is combinational circuit that select one of the inputs to the output. The select line…
Q: ght sources, each with a bit rate of 1000 kbps are to be combined using synchronous TDM. Each output…
A:
Q: A- A binary polar signal with ±5 volts is received in the presence of an AWGN with zero mean and two…
A:
Q: Q5: Design a 4x16 decoder using 1x2 decoder?
A:
Q: Question 2: Eight sources, each with a bit rate of 1000 kbps are to be combined using synchronous…
A: Dear student as per our guidelines we are supposed to solve only one question in which it should…
Q: Binary to Octal Decoder using 7-Segment Display. what is the K-map and truth table ?
A: Binary to octal Decoder using 7-segment Display- These four input lines (A, B, C, and D) is used in…
Q: 1. Why are tristate buffers required to interface digital devices to a bus?
A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…
Q: 4. a. What is meant by: i) Bit-masking? ii) 2's complement?
A: Given & to find: What is meant by: i) Bit-masking ii) 2's complement
Q: -Q.1 B) Construct a 5-to-32-line decoder with four 3-to-8-line decoders with enable and a 2- to-…
A: Note: Since you have posted multiple independent questions in the same request, we will solve the…
Q: 3- Design 4x10 decoder whish used to convert from BCD code to decimal?
A: very simple question based on designing of BCD to Desimal (4×10) decoder . In this we first have to…
Q: If the 7 bit hamming code word received by receiver is 1011011 , assuming the even parity, state…
A: Hamming code: R.W. Hamming develop hamming code for error correction. this method, encodes the…
Q: What is the probability of error with a PSK system with a bit rate of 20kpbs, BW of 50 kHz, Noise…
A: The solution is given below
Q: The constellation diagram for a modem that is used for transmission via an analogue channel is shown…
A: The constellation diagram for a MODEM that is used for transmission through an analog channel is…
Q: Construct the truth table from the Below VHDL code for the decoder.
A:
Q: a) Draw the neat labeled diagram of four pair 10BaseT cable? b) Write any four disadvantages of the…
A: 10 baseT was a type of standard for implementing ethernet network using unshielded twisted pair…
Q: Construct a 5X32 decoder with 3X8 decoders with enable and one 2X4 decoder. Use block diagram for…
A: this required one 2x4 decoder and four 3x8 decoders.
Q: Construct a 4-to-16-line decoder with five 2-to-4-line decoders with enable. Use block diagrams.
A:
Q: Why when sending an accurate voltage to a device does the remote sensing terminals become an…
A: Due to the distance between output and the load there is a voltage drop so the important function of…
Q: Q. No 3. In a Public Switch Telephone Network (PSTN), how the analog speech signal is converted to…
A: PSTN represents Public Switched phone phone Network or the standard circuit-exchanged phone…
Q: When the number of bits in a PCM mode, n, is 3, what is the dynamic range in dB?
A:
Q: Design an 8-to-1-line multiplexer using a 3-to-8 line decoder and external gates.
A:
Q: We need to use synchronous TDM and combine 20 digital sources, each of 100 Kbps. Each output slot…
A:
Q: The probability that a packet is received in error is 0.6 in Selective Reject ARQ flow control…
A: The buffer window used by Selective Reject is the same size as the sender window.
Q: Draw a circuit diagram of a 2 bit NOR decoder. Show and explain which line will be activated if he…
A:
Q: Explain with the aid of equations the following: i. How to improve the noiseless channel capacity?…
A:
Q: Modify the Laser Circuit FSM to output x for 25 ns, assuming Tclk = 5 ns. Draw the new State…
A: Note: As per Bartleby guidelines, as both question are different, solution for only first question…
Q: How many 3-line-to-8-line decoders are required for a 1-of-32 decoder? 2 8.
A:
Q: Suppose, you have 6 voice channels, each of 60MBPS. You have to use synchronous TDM to multiplex…
A:
Q: Six message signals each of bandwidth 5 kHz are time division multiplexed and transmitted.…
A: According to the question we have to determine the signaling rate and the minimum channel bandwidth…
Q: explain the aliasing in the PAM Signal?
A: The analog pulse modulation techniques are classified into three types, which are mentioned as…
Q: Design of Binary 0 ,1, 2, 3 to SEVEN SEGMENT Decoder
A:
Q: How Analog to Digital Encoding Scheme works on data during transmission process. Explain.
A:
Q: Explain the concept of channel coding; what is its function on the overall digital communication…
A: Communication System- Communication System is refer to the system which transfer an information from…
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 1 images
- Write VHDL code for an n-bits register (n can be 4, 8, 16, …) with the Synchronous Reset Active High, and Load Input Active High.TRUE OR FALSE: More than one output of a BCD-to-7 segment decoder/driver can be active at one time.Write VHDL code for an n-bits register (n can be 4, 8, 16, …) with the Synchronous Reset Active Low, and Load Input Active Low.
- Example Assuming that a 3-bit ADC channel accepts analog input ranging from 0 to 5volts, determine a- The number of quatization levels b- The step size of the quantizer or resolution. c- The quantization level when the analog voltage is 3.2 volts. d- The binary code produced by the ADC. e- The quatization error when the analog voltage is 3.2 volts.In a digital communication, explain all the methods/mechanism used for the minimization of Bit Error Rate (BER). Also state that which method/mechanism is preferred and why?Explain with the aid of equations the following: i. How to improve the noiseless channel capacity? ii. How to improve the SNqR in the PCM system?
- Modify the Laser Circuit FSM to output x for 25 ns, assuming Tclk = 5 ns. Draw the new State Diagram. How many states have the new State Diagram? Write VHDL code showing separate “blocks” for the next state decoder, memory, and output decoder. Add an Asynchronous Reset active Low.1. Convert the following unsigned binary number to base-10 representation. (10100010)2 = ? 2. Convert the following base-10 number to unsigned base-2 representation. (78)10 = ? 3. Convert the following fixed point unsigned binary fractional number to base-10 representation. Radix point is shown. (10011.010)2= ? 4. Convert the following fractional number to fixed point unsigned base-2 representation. Specify the radix point. (15.75)10 = ? 5. Convert the following 32-bit IEEE single precision floating point number tobase-10 representation. (10111111110100000000000000000000)2 = ?We need to use synchronous TDM and combine 20 digital sources, each of 100 Kbps. Each output slot carries 1 bit from each digital source, but one extra bit is added to each frame for synchronization. Answer the following questions: (a)What is the size of an output frame in bits? (b)What is the output frame rate (frame/s)? (c)What is the duration of an output frame? (d)What is the output data rate? (e)What is the efficiency of the system (ratio of useful bits to the total bits).
- Question 5: a) In the context of WCDMA, answer the following questions: What is the chip rate of WCDMA? i. ii. What is the duration for WCDMA frame? iii. For the figure shown below, what is the spreading factor? Symbol iv. V. vi. vii. Data Spreading code Spread signal Datax code Spreading What is the corresponding processing gain? For the figure shown below, what is the multiplexing mode used? Uplink Downlink Frequency Time WCDMA has a frequency reuse of 1 between different cells. What does that mean? If fast fading occurs when the path difference between two received signals is half wavelength. Calculate the path difference at a frequency equals to 2 GHz.How do you design a 2 to 4 decoder using NAND and NOT gates when the enable but is active low?Q4. Consider the 16-QAM digital modulation scheme (a) What does the abbreviation QAM stand for? (b) Sketch an I-Q constellation diagram for this modulation scheme. (c) State the number of bits per symbol. (d) If the bit rate that is achieved with this modulation scheme is 256 Mbit s, what is the baud (symbol) rate?