What is NOT recommended for precipitation of crystal deposits: precipitation in presence of compounds, which can decrease solubility of the precipitate; addition of diluted solution of precipitator to diluted analyte; addition of hot solution of precipitator to hot analyte solution; slow addition of precipitator solution while constant stirring;

What is NOT recommended for precipitation of crystal deposits: precipitation in presence of compounds, which can decrease solubility of the precipitate; addition of diluted solution of precipitator to diluted analyte; addition of hot solution of precipitator to hot analyte solution; slow addition of precipitator solution while constant stirring;

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter15: Complex Ion And Precipitation Equilibria

Section: Chapter Questions

Problem 64QAP

See similar textbooks

Similar questions

From the following data find the percentages of Na2CO3 and NaHCO3 in a mixture of these chemicals and inert constituents: a) A 0.5000 g sample required 45.50 mL 0.1050 N HCl to reach the methyl orange end point. b) 25.00 mL of 0.1000 N KOH is added to 0.2500 g of the sample; BaCl2 is added to precipitate the BaCO3 and 12.00 mL 0.1050 N HCl is required to reach the phenolphthalein end point.
A sample is known to contain about 20% soda ash. What sample size should be taken for analysis, if it is to be dissolved into a 50 mL volumetric flask, with 10 mL aliquots analyzed, if it is desired that the analysis consume a total of 40 mL 0.10 M HCl with 10 mL of 0.10 M NaOH used in the back-titration, after boiling.
A 1.2 g sample of mixture of NaOH and Na COs containing inert impurities s dissolved and titrated cold with 0.5N HCI. With phenolphthalein as indicator the solution turns colorless after the addition of 30.0 ml of the acid. Methyl orange is then added and 12 mL more of the acid is required before this indicator changes color. What is the percentage of NaOH and of Na:CO, in the sample ? 5.
The volume of water needed to dissolve 0.0530 grams of silver hydroxide is 1 Assume no volume change upon addition of the solid. L.
At room temperature, the solubility of bromine in bromoform is approximately 70 times greater than in water pure. Calculate: a) The weight of bromine in mg that exists in each of the two immiscible liquid layers after shaking vigorously with 12.0 mL of bromoform a 15.0 mL aqueous solution containing 0.0060 g of bromine. b) The percentage of bromine not extracted by CHBr3.
3 L contaminated air 50 mL 0.0116 M in an air pollution analysisCarbon dioxide (CO2) BaCO3 is passed through Ba (OH) 2 solution.is precipitated as. Excess of base, next to phenol phthalate (f.f.) indicatorIt is titrated with 23.6 mL of 0.0108 M HCl. CO2 in this air sampleCalculate its concentration in ppm. (Density of CO2Take it as 1.98 g / L. C = 12, O = 16 g / mol).
136 mL of 0.00015 M Pb(NO3)2 and 234 mL of 0.00028 M Na2SO4 (volumes are additive). Will a percipitate form? Hint: each solution dilutes the other upon mixing.
Gravimetric Analysis. Please include complete solution, thank you. 4.) A 0.2025 g sample consisting of only BaCl2 and KCl required 20.25 mL of 0.1200 M AgNO3 solution for the quantitative precipitation of chloride. Calculate the %Ba and %K in the sample.
Why is the solubility of silver chloride lower in pure water than in 0.100 M KOH? Please explain in detail, thank you.
What are the characteristics of an ideal precipitate? Explain using the Von Weirman ratio the different ways that you can do to make the resulting precipitate more ideal?
In general when will sparingly soluble salt precipitate from solution?
The volume of water needed to dissolve 0.0698 grams of lead iodide is L. Assume no volume change upon addition of the solid.