stack with an inside radius of 1 m. The plant emits 300 g/s of SO2 from the stack with an exit velocity of 10 m/s at a temperature of 120oC. Ambient temperature is 6oC and the temperature increases at a rate of 2 K/km. At 10 m above ground, surface windspeed is 1.5 m/s on a mostly cloudy night. Find the

stack with an inside radius of 1 m. The plant emits 300 g/s of SO2 from the stack with an exit velocity of 10 m/s at a temperature of 120oC. Ambient temperature is 6oC and the temperature increases at a rate of 2 K/km. At 10 m above ground, surface windspeed is 1.5 m/s on a mostly cloudy night. Find the

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter14: Ocean Thermal Energy Conversion And Ocean Salinity Gradient Energy

Section: Chapter Questions

Problem 5P

See similar textbooks

Similar questions

A 10-kg mass of superheated refrigerant-134a at 1.2 MPa and 70°C is cooled at constant pressure until it exists as a compressed liquid at 20°C. (a) Show the process on a T-v diagram with respect to saturation lines. (b) Determine the change in volume. (c) Find the change in total internal energy.
The contents of a tank are to be mixed with a turbine impeller that has six flat blades. The diameter of the impeller is 3 m, and the impeller is installed 1.25 m above the bottom of a 6-m deep tank. If the temperature is 30°C and the impeller is rotated at 30 rev/min, what will be the power consumption? Find the Reynolds number using Eq. (5-11).
The air shed over a city can be considered by a completely stirred tank reactor (CSTR) model with two sides of 2×10° m in length and a mixing depth of 500 m. Horizontal wind blows at 4 m/s from one side of the box and exits from the opposite side. Assume that within the box, the air is well mixed all the time. Within the air shed, benzene (C6H6) is emitted by automobiles, power plants, and factories at a rate of 0.4 kg/s. No benzene is brought to the city by wind. When equilibrated, what is the benzene concentration in the atmosphere? Please sketch the model first. Pay attention to the units.
At critical depth O The discharge is maximum for a given specific energy. O The specific energy is maximum for a maximum discharge. O The specific energy is minimum for a maximum discharge. O The discharge is minimum for a given specific energy.
..............Wh@t is the equivalent head of kerosene (s=.9) annd mercury( s=14.2). For a 4m head of water.......
A perfect gas has a value of R= 0.317 ks/ka-k and k = 1.27 If 120k] are added to 2.75 KG of this gas e constant pressure when the initial temp. 15 33°C, Find: 9] 1₂ b) Wkn c) pv and TS drag.
Power can be generated in principle by utilizing the naturally occurring decrease with depth of the temperature of ocean water. At one location the ocean surface temperature is 75°F, while at a depth of 1800 ft the temperature is 45°F. Determine the maximum thermal efficiency for any power cycle operating between hot and cold reservoirs at these temperatures. nmax = i %
Convert a pressure head of 10 m water column to kerosene of specific gravity equal to 0.8 and to Carbon tetrachloride of specific gravity 1.6
B. A Carnot engine operates between two temperature reservoirs maintained at 200°C and 20 °C, respectively. If the desired output of the engine is 15 kW, as shown in Fig. below, determine the heat transfer from the high-temperature reservoir and the heat transfer to the low-temperature reservoir. TH-200°C On Engine QL T₁ - 20°C W 15 kW
Water from a large tank enters into a pipe and discharges to the atmosphere through a nozzle connected at the other end of the pipe. The tip of the nozzle is located 240 m below the water surface in the reservoir. The jet formed at the tip of the nozzle has a diameter of 100 mm and velocity of 60 m/s. Neglecting minor losses, a) Compute the power produced by the jet in hpb) compute the power lost due to friction in the pipe
1. Oil that has a density of 880 kg/m3 flows under a head of 30 m. The pipe that the oil flows through is 3000 m long and 0.35 m in diameter. Due to the cooling along the span of the pipe the viscosity changes, this may be taken as 0.57 kg/m-s over the first 1500 m and 1.14 kg/m-s over the second 1500 m. Confirm that laminar flow conditions exist and calculate the flow in dm/s. Neglect entry and exit losses. Answer 37.185 dm'/s
A jet of water issues from a 5 cm diameter nozzle, held vertically upwards, at a velocity of 20 m/s. If air resistance consumes 10% of the initial energy of the jet, then it would reach a height above the nozzle of m.