Nutrient Agar (NA) is a general purpose medium used for the cultivation of a wide variety of non- fastidious microorganisms (Merck, 2000). Its ingredients are listed in Table 2. You are tasked to prepare 300ml of NA, determine the amount of ingredients and write in column 3 in Table 2. Show your calculations. *A sample calculation was made for you. Peptone = 300 mL x 0.5% = 1.5 g Table 2. Medium Composition of Nutrient Agar (NA) with the recommended proportions (Merck, 2019) In % Ingredients In Grams/300mL Peptone 0.5 *1.5 Meat extract 0.3 Agar 1.5 Distilled Water As needed

Nutrient Agar (NA) is a general purpose medium used for the cultivation of a wide variety of non- fastidious microorganisms (Merck, 2000). Its ingredients are listed in Table 2. You are tasked to prepare 300ml of NA, determine the amount of ingredients and write in column 3 in Table 2. Show your calculations. A sample calculation was made for you. Peptone = 300 mL x 0.5% = 1.5 g Table 2. Medium Composition of Nutrient Agar (NA) with the recommended proportions (Merck, 2019) In % Ingredients In Grams/300mL Peptone 0.5 1.5 Meat extract 0.3 Agar 1.5 Distilled Water As needed

Aquaculture Science

3rd Edition

ISBN:9781133558347

Author:Parker

Publisher:Parker

Chapter2: Aquatic Plants And Animals

Section: Chapter Questions

Problem 2KA

See similar textbooks

Similar questions

The nutrient broth is a basic media used for growing a broad variety of microorganisms in the laboratory. The nutrient broth consists mainly of 1.5g * L ^ - 1 extract, 3g * L ^ - 1 yeast extract and 5g * L ^ - 1 sodium chloride dissolved in distilled water. The nutrient agar is prepared by adding the agar at the desired amount into nutrient broth. Answer the following questions. marks) a) How would you prepare a 500 ml nutrient broth? b) How would you prepare 2% (w / v) nutrient agar for 1L? c) How would you prepare a 100 ml nutrient broth supplemented with 100mu * g / m * l ampicillin antibiotic? The stock concentration for ampicillin solution is 100mg / m * l .
How would you make two-fold serial dilutions such that the last tube is a 1:32 dilution of the original, concentrated material? Assume that you need to have at least 500 µl of each dilution, and you should be able to perform the dilutions in microfuge tubes with a maximum capacity of 1.5 ml.
You want to prepare 500 mL of the macronutrient and micronutrient stock solutions which have 100X and 1000X higher concentration, respectively, than the required concentration in the culture mediuma)Approximately 4 % (w/v) sucrose and 0.8 % (w/v) agar are added into the medium.Determine the amount of sucrose and agar (in gram) required in order to prepare 200 mL MS medium. Show your work
Given the following media recipe, pick the terms that apply (pick as many as are applicable). 10.0 g Meat extract 10.0 g Peptone 5.0 g Sodium chloride 15.0 g 1.0 L Agar Water Once media is cool, add 6% sterile sheep's blood Defined Complex Minimal Selective Differential
If you have a 15 mg/100 ml stock solution of GA3 and you need a 1 mg GA3 in 25 ml, how much stock solution would you add to 125 ml of medium? how to calculate these kind of question in tissue culture media preperation
The chart below represents the results (absorbance readings) of your Bradford Assay. Use the data and graph to determine the dilution of each well and concentration (in mg/ml) of the sample in each well of the microtiter plate.
Look at the table below and answer the following questions: Culture 1/10 1/50 1/100 1/200 dilution OD Reading 1 2.0 0.36 0.18 0.11 OD Reading 2 1.9 0.35 0.18 0.08 OD Reading 3 1.8 0.33 0.16 0.09 1. Which 2 dilution levels of the culture are the best to use to compute for its optical density? 2. What is the average optical density of the culture? (use values from 2 dilution levels)
What nutrients do the following media components contain? Peptone Yeast extract Beef extract Potato infusion Agar Why should agar media be completely dissolved before they are dispensed in tubes and plates? What are the bases for pegging the temperature at 1210C for 15-30 minutes during moist heat sterilization and 1800C for two (2) hours using dry heat sterilization? 1.Can you sterilize culture media using dry heat sterilization? Why is that so? You will notice in the videos shown, the cotton plug is not used. What is role of cotton plug in media prep, sterilization and culture of microorganisms? Instead of using cotton plug, plastic screw-cap is used, can you substitute this for the former? Is it technically acceptable in microbiology?Please include source
Suppose your professor handed you a bottle of kombucha with 2.0 ml in it and told you to make a 10^-2 dilution of the entire culture. Explain how you would do this. Show your calculations.
A sample of Earth Alive Soil Activator was diluted by transferring 1 gram into a 9 ml dilution blank (tube A) and then serially diluted five (5) more times by transferring 1 ml of a previous dilution into a tube of 9 ml of sterile water. After making these serial dilutions, 2 ml samples were taken from tubes D, E, and F, added into empty petri dishes, and molten PCA was poured into each petri dish. Tubes A, B, and C were heated in a 80˚C water bath for 30 minutes, 2 ml samples of these tubes were added into empty petri dishes, and molten PCA was poured into each petri dish. These plates were allowed to solidify, and they were incubated at 35˚C for 48 hours. After the incubation period, you counted CFUs on all 6 plates. The results of your CFU counts are contained in table 1. Table 1. CFU counts for 3 plates from the heated dilutions (A-C) and the 3 plates from the non-heated dilutions (D-F) # CFUs Not heated Heated A -- 400 B -- 45 C -- 6 D 350 -- E 31 -- F 2 --…
For an exponentially growing culture that increases from 5 *106cells/ml to 5 * 108cells/ml in 8 h, calculate g, n, and k forthis culture.
Following electrophoresis of the two pGlo mini-preparation samples (both digested and undigested), the following agarose gel image was obtained. provide an accurate and detailed figure, describing the image and what it depicts.