Mutual inductance between an infinite current filament placed along y -axis and rectangular coil of 1500 turns placed in x -y plane as shown in figure will be 1- (6, 1, 0) I 2 0.33mH None of choices 0.264MH 0.396mH

Mutual inductance between an infinite current filament placed along y -axis and rectangular coil of 1500 turns placed in x -y plane as shown in figure will be 1- (6, 1, 0) I 2 0.33mH None of choices 0.264MH 0.396mH

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 11RQ

See similar textbooks

Related questions

Q: 13. A coil with 60 turns wound over a ferromagnetic core having relative permeability 400 has an…

A: Given values are - L1=50mHN1=60μr1=400 Given new values are - N2=2N1=2×60=120μr2=600

Q: In a circuit with an inductor of inductance L, a resistor with resistance R and a variable voltage…

A: Given: The voltage is Et=Ldidt+Ri The measurement table is And the parameters L=0.98 HR=0.142…

Q: A multilayer coil of 2000 turns of fine wire is 20 mm long and has a thickness 5 mm of winding. If…

A: The EM wave is formed when electric field is in contact with magnetic field. Magnetic field exert…

Q: An inductance of 1 H and a resistance of 2 0 are connected in series with a constant emf of E volts.…

Q: This is a toroidal inductance. Calculate the inductance of this material. r1 = 96mm, r2 = 120mm, a =…

Q: From a coil with an inductance of 2 mH, i = 5(1-e -5000t) Ampere current is passing. At the ends of…

Q: The field winding of a DC electromagnet is wound with 960 turns and has resistance of 100Ω. When…

Q: 1. The capacitance of a parallel-plate capacitor does not depend on the a. area of the plates. b.…

A: In this question we will write about capacitance , electric supply etc...

Q: An uncharge capacitor in series with a 120 volt voltmeter of 10,000 ohms resistance is suddenly…

Q: 1. The inductance of a single layer solenoid is 5 mH. Find the value of inductance when the number…

A: We need to find out inductance for given number of turn and length

Q: a purely capacitive circuit, the voltage will lead the current by an angle 90 degrees. elect one: O…

Q: The 0.5-nF capacitor of figure (1) has the waveform of current shown across it. Calculate and plot…

A: Current waveform is applied to the capacitance. Find the voltages waveform and power waveform.

Q: QUESTION 1 Find GMD, GMR for each circuit, inductance for each circuit, and total inductance per…

Q: A coil of 500 turns has a flux of 0.4 mWb linking with it when carrying a current of 2 A. Determine…

Q: 4. A coil having an inductance of 0.2 H and negligible resistance is connected across a 100 V a.c.…

A: Given data, The value of inductance is L = 0.2 H. The value of voltage is V = 100 V. (a) When…

Q: A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0,…

A: for RC circuit, Initially capacitor voltage is 0

Q: What is the inductive reactance of the following voltage source 200 sin(500t +30) V in series with a…

A: Given: Voltage source with voltage, vt=200 sin500t+30 V Series connected inductance value, L=10 mH

Q: ix 13 V mat drives Capacitor

A: Thevenin's theorem states that if a circuit containing an RLC components, independent voltage…

Q: Three inductors of 10mH, 40mH and 45mH are connected together in a series combination with no mutual…

A: If inductors of inductance L1 , L2, L3 are connected in series than equivalent inductance = L1 +…

Q: 5. An iron core 0.4m long and 5 cm?. In cross section, is wound with 300 turns. Wh current of 0.5 A…

Q: Calculate a capacitor's Q (express the answer in k notation) Blank 1 at 100MHZ given 0.001 uF and a…

Q: 18 - chapter26-question12 Find the equivalent capacitance of the system given in figure. C Option1…

A: Equivalent capacitance across the a and b terminal.

Q: The maximum efficiency for pure inductance load and iron-losses = cupper losses is zero. O True O…

A: Given data, For Pure inductive load , Resistance = 0. Given, iron losses = copper losses. For pure…

Q: QUESTION 4 (a) Figure 2 shows a parallel plates capacitor with a dielectric material being placed at…

Q: In a given parallel plate capacitor with a stored energy of " W" Joules, if the capacitance value is…

A: We know that parallel plate capacitor C=ε0εAdC= capcitanceε0= permitivity of spaceε=relative…

Q: For the given circuit below calculate i) the total capacitance of circuit ii) the total charge in…

A: The given circuit is,

Q: Calculate a capacitor's Q (express the answer in k notation) Blank 1 at 100MHZ given 0.001 uF and…

A: In this question we will find capacitor Q factor and dissipation factor.....

Q: How much resistance must be inserted in series with a 0.96-H inductance to limit the current to 0.25…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: f the number of turns is doubled, what will happen to the inductance?

A: Inductance = Flux linkage / current = Number of turns* Flux /current. But flux =…

Q: 9. An inductance of 15mH has a current drawing 1= 15sin(650t-30%) A. Determine the equation of…

A: Given: I=15sin(650t-30∘) AL= 15 mH It is asked to calculate voltage across the inductor.

Q: An iron core 0.4 m long and 5 cm2 is wound with 300 turns. When a current of 0.5A flows in the coil,…

Q: An iron core 0.4 m long and 5 cm^2 is wound with 300 turns. When a current of 0.5A flows in the…

Q: In a purely inductive circuit, the voltage will lead the current by an angle 90 degrees. Select one:…

Q: In the circuit below, assume that the inductor is replaced by a short (still with the current i…

A: Inductor and Capacitor in DC circuit Transient Problem: To solve above question, one should…

Q: Calculate the equivalent capacitance that would connect to points "A" and "B". Answer in…

Q: Two identical air core solenoid has 200 turns, length of 25 cm and cross-sectional area of 3 sq.cm.…

Q: A coil is wound with 500 turns. When a current of 4 A flows the total flux threading the coil is…

Q: 33. How much energy is stored by a 100 mH inductance with a current of 1 A? O 0.01 J 0.05 J O 1 J O…

Q: A capacitor is rated 100 kVAr, 380V 50Hz. What will be its rating at 60Hz, 220V

Q: Determine the equivalent inductance of the inductive network with coupled coils shown in Figure. 2H…

A: The solution is given below

Q: Calculate the value of the inductor(mH) that must be connected in series with a fiftyΩ resistor to…

A: we need to find out value of inductor (mH).

Q: 9. Three inductors are connected in series to a 480 volt, 60 Hz power source. The current flow in…

A: According to the question we have to find the value of 3rd inductor inductance.

Q: our inductors are connected as per the arrangement shown in Figure 4. Calculate the value f L1 to…

Q: A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t 0, there…

Q: D2 C1 D1 A C2 Vo Vs(t) what will be the absolute value of the voltage across D1 during the Negative…

A: Referring to the given circuit, for the positive half cycle the diode D1 will get forward biased and…

Q: olenoid has an inductance of 1.58 mH. How many turns of wire does it have if the solenoid is zm long…

Q: Capacitance is the property of an Electric Circuit that is due to changing magnetic fields. Select…

A: We need to tell about the given statement is true or false.

Q: 2) A length of an air cored solenoid is 1.7m and area of cross-section is he number of turns of coil…

Question

Mutual inductance between an infinite current filament placed
along y -axis and
rectangular coil of 1500 turns placed in x -y plane as shown in
figure will be
1
(6, 1, 0)
6
0.33mH
None of choices
0.264mH
0.396mH

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Choose the correct answers The coil winding in PMMC meter is -1 small heavy large fine
r cut 1oum 20gm 1ocm 个 //// wax poper/ A capacitur is mad by sandwiching a sheet of wax psper between two sheebs of aluminum fail, as shoumm What is the figue. capacitance! I the capacitoris aut into twopieces, alme the hme, what oil be the expacitenel of each Diece ? wiggly What lo be the capactnce
Paramagnetic materials have relative permeability Equal to that ferromagnetic materials Slightly less than unity Slightly more than unity Equal to unity
b1- The given ferromagnetic core relative permeability is 800. Determine the total reluctance of the core. 35 cm 10 cm 20 cm 50 cm 15 cm 45 cm 15 cm 15 cm 10 cm
circut for the core. (₁ For the ferromagnetic core shown in the gure below draw the magnetic The magnitudes of the reluctances are not important but clearly indicate on your circuit every reluctance which should be calculated for the given core. 10 15 = 0.5A d DNI 15 0.03 N2 1₂ = 0.1A 9
6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
Two parallel wires made of copper are placed in air. The inductance of each wire is 0.9 µH/m with diameter of 2mm. The external inductance is? 0.85 µH/m 0.85 H/m - 0.85 µH/m 0.85 mH/m 0.85n µH/m None O uH/m - 0.85 µH/m -0.85n µH/m
arcing c
Determine the symmetrical components of the three currents Ia = 10cis0, Ib = 10cis230, Ic = 10cis130 A.
Draw roughly the arc characteristics in alternating currents with a frequency of 50 Hz and 500 Hz, explain briefly
QUESTION 19 E-06, PC-02. Three inductors 15 mH, 15 mH and 15 mH are connected in series. What is the total inductance? O 5 mH. Without knowing the coupling factor the total inductance cannot be found. 45mH. QUESTION 20 E-06, PC-05. Why are the iron cores of most induction coils laminated? To increase the core permeability. O To reduce the core reluctance. O To reduce the effects of eddy currents. Click Save and Submit to save and submit. Click Save All Answers to save all answers. MacBook Air 888 F7 FB F6 F4 F3 F2 & 23 $ 4 5 0 8 3 Y W E と S D S F G >> J しのくつつ >
Stator core of alternator is built up of steel sheet lamination of thickness between a) 0.35 mm to 0.5 mm c) 0.25mm to 0.35mm b) 0.5mm to 0.85mm d) Imm to 1.25 mm