Hhhhjjjkkkkkkkk Problem 2: Learning Outcome #3A river has an average width of 4 meters into the paper and flows steadily with an average velocity of Bm/s at Point A. The depth at A Is 1.2m. Determine the depth h after the flow falls 2 meters. Water canbe considered as inviscid and incompressible. The density of water is taken as p=1000kg/m² andg=9.81m/s². Gravity acts vertically downward.Hint: (i) the free surface, where A, are located, is a streamline and it is exposed to air, with a constantair pressure. (II) Bernoulli eqn. and conservation of mass in control volume form will be helpful.12mB2 m

Name: Hhhhjjjkkkkkkkk Problem 2: Learning Outcome #3A river has an average w
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Hhhhjjjkkkkkkkk Problem 2: Learning Outcome #3A river has an average width of 4 meters into the paper and flows steadily with an average velocity of Bm/s at Point A. The depth at A Is 1.2m. Determine the depth h after the flow falls 2 meters. Water c

To determine the depth 'h' at Bgiven average velocity depth of A, and the depth from the point of A…

Answered: Determine the depth ha sible The

Engineering

Mechanical Engineering

Determine the depth ha sible The

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The three reservoirs system contains water. If L1 = 2000 m, f 1= 0.013, D1 = 1m; L2 = 2300 m, f2 = 0.02, D2 = 0.60m; and L3 = 2500 m, f = 0.023, D3 = 1.20m. Compute Q3 in m3/s.
Water flows over a dam into a rectangular channel of width b (out of page). At the bottom of the dam, the depth of flow is h₁. As you may have seen on watching rapid channel flow, the water may suddenly change elevation to height h₂ as it passes through a highly disturbed region called the hydraulic jump. If velocity is assumed uniform at 1 and 2, compute the height h2 using the control volume analysis. Take the pressures at 1 and 2 as hydrostatic, and assume that the flow is steady. Neglect friction at the channel bed and walls. (Courtesy of the Wright Water Engineers, Inc. and ASDSO) Hydraulic jump h₁ = 3 ft V₁ = 25 ft/s BE 2 h₂ =? V₂ = ? (a) Find the cubic equation, in terms of h₁, V₁, and g, that you must solve for the downstream depth h₂ of the water channel. (b) For h₁ = 3 ft and V₁ = 25 ft/s, find the downstream depth h₂. Use the standard value for g. Note that you are solving a cubic equation, and only one of the solutions is correct.
Water is to be pumped from a lake to a ranger station on the side of a mountain (see figure). The length of pipe immersed in the lake is negligible compared to the length from the lake surface to the discharge point. The flow rate is to be 95.0 gal/min, and the flow channel is a standard 1-inch. Schedule 40 steel pipe (ID = 1.049 inch). A pump capable of delivering 8 hp (= W, ) is available. The friction loss F (ft-lbf/lbm) equals 0.0410 L, where L (ft) is the length of the pipe. %3D
A circular tank of diameter 3 m contains water up to a height of 4 m. The tank is provided with an orifice of diameter of 0.4 m at the bottom. Find the time taken by water to fall from 4 m to 2m. Take Cd= 0.60 (WITH FREE BODY DIAGRAM) CHOICES: a.47.8 seconds b.43.8 seconds c.84.7 seconds d.24.8 seconds
1.Find the diameter of a pipe of length 3000 m when the rate of flow of water through the pipe is 300 litres/s and the head lost due to friction is 5 m. Take the value of C = 50 in Chezy’s formula.
1- Derive an expression for the flow rate q over the spillway shown in figure bellow per foot of spillway perpendicular to the sketch. Assume that the sheet of water is relatively thick, so that surface -tension effects are negligible. Assume also that gravity effects predominate so strongly over viscosity that we can neglect viscosity. H.
engineering fluid mechanics A rectangular open channel has a base of length 2b, and the water is flowing with a depth of b. a. Sketch this channel.
Consider a column of water as it falls from a faucet. The opening in the faucet has radius ro and the water comes out with initial velocity vo. Define y to be the distance below the faucet. As the water falls (y increases), it accelerates due to gravity and the stream narrows. a) Assuming streamline flow, find an expression for the velocity of the water for any distance below the faucet. b) The stream obeys the continuity equation. Use this to determine the radius of the stream as a function of y. c) At what distance ₁/2 will the radius of the stream be half its original radius? At what distance Y1/3 will it be a third? d) Compare 1/2 and Y1/3 for v0 = = 1 m/s and v0 = 0.1 m/s (use g = 10 m/s²).
Q1: Water is flowing from tank A to tank B as shown in the following figure. The flow is steady so that the water level in tank B does not change. Find h, in the figure. The density is constant. The flow is inviscid and irrotational. Hint: apply Bernoulli's equation between the free surface and the discharge for tanks A and B individually. Then, since the flow rate leaving tank A (and entering tank B) must equal the rate leaving tank B, these two Bernoulli's Equations can be substituted and solved for one unknown. 1 10.0 cm = 0.01 m Tank A 士 Tank B d 0.02 m Figure 1. Q1
Please answer asapA pipe transports 1962 N/s of water. The pipe tees into a 2"-diameter pipe and a 3"-diameter pipe. If the average velocity in the smaller-diameter pipe is 82 ft/s, calculate the flowrate (in ft^3/s) in the larger pipe.
The rectangular tank shown here, with its top at ground level, is used to catch runoff water. Assume that the water weighs 62.5 lb/ft³. a. How much work does it take to empty the tank by pumping the water back to ground level once the tank is full? b. If the water is pumped to ground level with a (5/11)-horsepower (hp) motor (work output 250 ft-lb/sec), how long will it take to empty the tank (to the nearest minute)? a. How much work does it take to empty the tank? ft-lb b. How long will it take to empty the tank (to the nearest minute)? minutes (Round to the nearest minute as needed.) Ground 7 ft level o 14 ft
P1 = Patm 1 V 7.3 m/s %3D Flow h = 0.96 ft water 3 Density of water 1000 kg/m Determine the pressure at the point 3?