Answered: 2/85 A projectile is launched with an…

2/85 A projectile is launched with an initial speed of 200 m/s at an angle of 60' with respect to the horizontal. Compute the range R as measured up the incline. Ans. R=2970 m 200 m/s A 60 20 R B

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.47P: A rifle at A is fired at a target at B. If the speed of the bullet is 1400 ft/s, determine the...

See similar textbooks

Related questions

Q: The bicycle and rider shown in (Figure 1) have a mass of 85 kg with center of mass located at G. The…

A: Given:the mass of the bicycle is the coefficient of kinetic friction is

Q: Determine the discharge in gallons per minute of a new 16-in cast-iron pipe if the friction losa is…

Q: Two uniform aluminum spheres are positioned as shown. The distance R = 57 mm. Determine the…

A: R = 57 mm = 0.057 m

Q: An insulated wall has a total thermal resistance of 2.5 K/W for an area of 1 m^2. In winter, the…

Q: What FAv and FAH stand for in the solution

A: After going through the solution and seeing freebody diagram of given blockIt can be concluded that…

Q: Hello! I hope you are well.I don't understanf how we can state that the moment of Fa around B is…

A: The question is about understanding the concept of moment of a force around a point in the context…

Q: Required information An ideal Otto cycle has a compression ratio of 8. At the beginning of the…

A: Where, V1 is the total volume of the cylinder and V2 is the clearance volume.With the help of given…

Q: Find the resultant torque created by the two cables about the base of the post. Express the result…

Q: The cantilever beam consists of a rectangular structural steel tube shape [E = 200 GPa; 1 = 350 ×…

Q: By analyzing the graph shown above, state your statement of why the t₂, t4 and t are effecting the…

A: Given:

Q: A steam pipe has an insidle diameter of 200 in, and consists of 0.22 in of Copper pife Covered by…

A: Given that:inside diameter of the steam pipe is 2.0 in.It is covered by three layers of materials.…

Q: For the beam cross section below, find the location of the centroid relative to point A and…

Q: To produce a vibration, what three (3) properties of a body must a force overcome?

Q: A ladder of length 2L and mass M is positioned on level ground leaning against a wall such that the…

Q: Name the microstructural product(s) of a eutectoid iron-carbon alloy (0.76 wt% C) that is first…

A: A continuous cooling transformation (CCT) diagram for a eutectoid steel shows the transformation…

Q: Design a steam cycle that can achieve a cycle efficiency of at least 40% under the conditions that…

Q: dia Y lo psi Q=10,000 gpm flow oil (sy=086b) I 14"' dia Determine the horizontal force on the…

Q: An ideal Brayton cycle has a net work output of 150 kJ/kg, and a recoil work ratio of 0.4. Determine…

Q: For the load system shown, F₁ = 500 N, F2 = 900 N, 0= 20 deg, and = 25 deg. The magnitude of the…

Q: The pressure in a natural gas pipeline is measured by the manometer shown in the figure with one of…

Q: g) the value of the deflection at point C. Enter your answer in mm to three decimal places. Assume…

Q: Learning Goal: Use the general equations of motion for plane motion to determine the initial…

Q: The 100-mm-diameter pipe is connected by a nozzle to a large reservoir of air that is at a…

A: The schematic diagram is,Here, point 2 is the exit point.

Q: em 158. The 20 kg wheel has an eccentric mass which places the center of mass G a distance r ̅=70 mm…

Q: 11.7 Evaluate the stiffness matrix for the elements shown in Figure P11-6. Let E = 100 GPa and…

Q: 6.14 Determine the nodal displacements and the element stresses, including prin- cipal stresses, due…

A: E=105GPat=5mm

Q: Slide 2: The mass m = 100 g is attached to the spring from slide 1 on a frictionless surface. It is…

Q: A refrigeration system with R134a as the working fluid is used to maintain a space at 25°C by…

A: Here we will take enthalpies at both points and use them to get heat exchange.

Q: cast-iron pipe (ε = 0.0003 m) 3.5m 6 m/s 1.D=43mm -6 2 = 1.00 x10 m/s K₁ = 0.9 L what percentage of…

Q: The simply supported beam supports a uniformly distributed load of w=240 lb/ft between supports A…

A: Given:To find:Principal stresses and maximum shear stress at point K.

Q: A baseball player swings his bat with an angular velocity of 20 rad/s when he hits a baseball…

A: This is problem of collision, where ball is hitting at the middle of the bat.For Ball: Velocity…

Q: ion in a centrifugal pump generate a similar sound to the human ear. Explain how vibration analysis…

A: Vibration analysis is a useful tool used in machinery diagnostics to identify and differentiate…

Q: Water is pumped through a vertical 2-in. new galvanized-iron pipe to an elevated tank on the roof of…

Q: Calculate the ankle torque during initial contact when running from the following data set to 1…

A: To determine the ankle torquethe following data isankle, ankle

Q: Determine and sketch the solution to 2ä(t) + 2x(t) + 32x(t) = 0 x(0) = 1 *(0) = -1. On the same…

Q: An inverted U-tube manometer is connected to two sealed vessels, as shown in Figure .Heptane is in…

A: A manometer with deflection of is given.To determine:The pressure difference between the two…

Q: An insulated tank is fitted with a freely-floating piston made of a non-conducting material as shown…

A: The ideal gas equation can be used to determine the temperature of the gas in the pipeline. The…

Q: A steel beam, of lengths a=5 m and b= 2 m and a hollow box cross section, is supported by a hinge…

A: Here reaction force along x-direction at pin support A is neglected as there are no applied force…

Q: An ideal Otto cycle has a compression ratio of 8. At the begin and 800 kJ/kg of heat is transferred…

Q: Methane (CH4) is stored in a closed, rigid container of 0.5 m3 at a pressure of 9.28 MPa. Initially,…

Q: Pressure = lops. 2F₂=F₁ -FR = (Q (O.-V₁ FR=F₁ - PQ (0-v₁) PA) + P Q Determine the magnitude of the…

A: The diameter of pipe is The inlet pressure is The flow rate are

Q: Consider the basic EOQ model. We want to know the sensitivity of (1) the optimal order quantity, (2)…

A: Concept Used:The Economic Order amount (EOQ) model is a mathematical tool utilized in operations…

Q: determine the magnitude of the applied couple

Q: The drag equation for the Gofaster 172 is: D = 0.0003v2A. D is drag in pounds; v is airspeed in…

A: For the solution refer below images.

Q: Using Mohr's circle, determine for the area indicated, the orientation of the principal centroidal…

Q: Indicated mean effective pressure of an ideal Diesel cycle is 650 kPa and the air is compressed from…

A: Ans The workout of the cycle is

Q: 9.35 Air enters the compressor of an ideal air-standard Brayton cycle at 100 kPa, 300 K, with a…

A: The inlet pressure at the compressor is The inlet temperature at the compressor is The volume flow…

Q: Problem 1. Find the horizontal force magnitude P needed to start the motion of the block with mass…

A: The masses are The coefficient of friction are The angle is

Q: For the diagram below the angular velocity of the wheel is w = 2rad/s. The location of the…

A: The instantaneous centre of zero velocity is the point in a body's motion where, at a given instant,…

Q: The drag equation for the Gofaster 172 is: D = 0.0003v2A. D is drag in pounds; v is airspeed in…

Concept explainers

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.

Question

2/85 A projectile is launched with an initial speed of 200
m/s at an angle of 60° with respect to the horizontal.
Compute the range R as measured up the incline.
Ans. R=2970 m
200 m/s
20

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given values in question

VIEW

Step 2: Speed calculation

VIEW

Step 3: Range calculation

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The driver of a car, which is initially at rest at the top A of the grade, releases the brakes and coasts down the grade with an acceleration in feet per second squared given by a = 3.35 -0.008v², where v is the velocity in feet per second. Determine the velocity VB at the bottom B of the grade. A Answer: VB = i 705' ע ft/sec. B
Q. For figure as shown. A ball is thrown vertically upward. Determine 1- The height (h) 2- The time (t) after release for the ball to land at B. 3- The impact velocity VB. h B 50' V₁-80 ft/sec
A projectile is fired vertically from point A with an initial speed of 280 ft/sec. Relative to an observer located at B, at what times (find two times t₁ < t₂) will the line of sight to the projectile make an angle of 25° with the horizontal? Compute the magnitude of the speed of the projectile at each time, and ignore the effect of aerodynamic drag on the projectile. Answers: t₁ = B t₂ = IM D 25⁰ 360' 280 ft/sec sec, |v|= A IM sec, |v|= i ft/sec ft/sec
A particle moves on a circular path of 20 ft radius so thatits arc distance from a fixed point on the path is given by s= 4t3 -10t where s is in feet and t in seconds. Compute thetotal acceleration at the end of 2 seconds. plss inlude the free body diagram ty..
1. The barrel of the rifle shown is aimed at point A. The distance 8 is the space between points A and B, which the bullet strikes the wall at point B. If the muzzle velocity is 600 m/s. Determine the distance 8, if the constant gravitational acceleration is given as g=8.6 m/s² (4 points) If the bullet is forced to strikes the wall at point O by applied the wind, causing a constant acceleration of a=105.45 m/s². Determine the direction O of the wind, where the effect of gravitational acceleration of g=8.6 m/s² still exists. (6 points) a=105.45 m/s В 20° Horizontal 1000 m
The particle P starts from rest at point A at time t = 0 and changes its speed thereafter at a constant rate of 1.7g as it follows the horizontal path shown. Determine the magnitude and direction of its total acceleration at times t = 0.95 s and t = 1.46 s. State your directions relative to the x-axis shown (CCW positive) and choose the angle with the smallest magnitude. A P B 2.65 m- 4.35 m Answers: Att= 0.95 s, a= i m/s?, e = i Att= 1.46 s, a= i m/s?, e = i
The distance y = 2.8 m. Find the upward velocity of A if the downward velocity of B is 3.8 m/s. Neglect the diameters of the pulleys. A 13 m B
The distance y = 3.0 m. Find the upward velocity of A if the downward velocity of Bis 3.6 m/s. Neglect the diameters of the pulleys. 14 m B Part 1 The motions of A and Bare constrained because they are connected by a rope of constant length. The length of the rope depends on the distances sa and y which change. Write an expression for the length Lof the rope in terms of the variable distances sa and y and the fixed distance 14 m. If the distance sA = 3.0 mand y = 3.0m, how long is the rope that connects moving point A to fixed point C? 14 m B Answer:L= m
2. Boal A moves with a constant velocity of 20 ft per sec, starting from the position shown in the figure. Find e in order for the projectile to hit the boat 5 sec after starting. under given conditions, How high is the hill above the water? Constant 20 A/sec
2/78 A rocket is released at point A from a jet aircraft fly- ing horizontally at 1000 km/h at an altitude of 800 m. If the rocket thrust remains horizontal and gives the rocket a horizontal acceleration of 0.5g, determine the angle from the horizontal to the line of sight to the target. 800 m Target
The driver of a car, which is initially at rest at the top A of the grade, releases the brakes and coasts down the grade with an acceleration in feet per second squared given by a = 3.23 -0.006v², where v is the velocity in feet per second. Determine the velocity VB at the bottom B of the grade. A Answer: VB = i 605' ft/sec. B
2/20 In traveling a distance of 3 km between points A and D, a car is driven at 100 km/h from A to B for t seconds and 60 km/h from C to D also for t seconds. If the brakes are applied for 4 seconds between B and C to give the car a uniform deceleration, calculate t and the distance s between A and B. 100 km/h 60 km/h A B C D 3 km