1. You use power meter at a receiver with no signal measure a received noise power level of -110 dBm. This is the background noise. You now turn on the signal source and observe that the total power (including the noise power which is independent of the signal power) is -107 dBm. a. What is the actual signal power in dBm? b. What is the signal to noise ratio in dB? c. What is the total received signal plus noise power in W

1. You use power meter at a receiver with no signal measure a received noise power level of -110 dBm. This is the background noise. You now turn on the signal source and observe that the total power (including the noise power which is independent of the signal power) is -107 dBm. a. What is the actual signal power in dBm? b. What is the signal to noise ratio in dB? c. What is the total received signal plus noise power in W

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem ECSQ

See similar textbooks

Similar questions

The carrier frequency is 600 Hz, and the modulating signal is a single-tone sinusoidal signal. The x-axis is in time while the y- axis is the amplitude of the AM signal. If the peak voltage level of modulating and 1v and signal respectively, determine the modulating index. the carrier are 2V 2 1.5 1 0.5 -0.5 -1 -1.5 -2 0.005 0.01 0.015 0.02 0.025 0.03 0.035 0.04 0.045 0.05 Time (s)
in FM , the maximum allowable frequency deviation is 4kHz and the frequency deviation by noise is 156.42HZ? then the signal to noise ratio is .......
what will the approximate voltage on the load be if the output impedance of the signal generator is set to 50ohms, the output amplitude is set to 2Vpp and the impedance of the load is 10 kOhms? b) What will the approximate voltage on the load be if the output impedance of the signal generator is set to high impedance the output amplitude is set to 2 Vpp and the impedance of the load is 10 kOhms?
At two distinct places, a signal is measured. At the first point, the power is P1, and at the second point, it is P2. The decibel level is zero. This denotes
What is the cut off frequency..?
2. What would be the frequency of a signal with a period of 0.1057? 3. A signal of 5 volts is corrupted by 7 mV rms of noise in a circuit. What is the S/N at this point?
A channel having a bandwidth of 1 kHz, the power of signal is 10 W and the power of noise is 5 W. Determine the channel capacity. Or: A channel having a bandwidth of 1 kHz and Signal to Noise Ratio (SNR) is 2. Determine the channel capacity.
Q2. An angle modulated signal with a sinusoidal carrier 100 cos Znfat and a sinusoidal message with frequency fa-20 Hz, knowing that -0.7, a) Draw the single sided spectrum b) Determine the modulated signal bandwidth. c) Determine the 70% and 90% bandwidth and transınitted power.
Assume a signal is represented by the following expression, Calculate: a)The signal bandwidth in KHz. Show all calculation steps. b)The period of the fundamental frequency in micro sec. Show all calculation steps.
6. Why gain is constant in mid frequency region?
QUESTION: Draw small signal equivalent circuit of the amplifier in high frequency band.
Draw the transfer curve of logarithmic amplifier.Explain how does a chopper work with basic circuit diagram.